Question about 2001 Chrysler Sebring

2 Answers

2001 Chrysler Sebring is there anyway manually to put up a power window

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 27 Answers

Remove window, remove track and motor, remove motor from track. reinstall track, reinstall window, push window up into place, cut stick to fit from bottom of door housing to window track, to hold window up with stick. HOWEVER, taking wires from the battery to motor terminals first may start the motor and roll it up .till u get a new door switch

Posted on Apr 26, 2015

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 1,326 Answers

Have someone push button at the same time pull top of window up. Or rake door panel off and reach inside door and push bottom of window up while pushing button

Posted on Apr 26, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

shaggyrat
  • 1224 Answers

SOURCE: removing the 2.7 engine from 2001 sebring sedan?

ok heres the simple version its alot of work
remove hood put someplace safe
disconnect all wireing and mark off with masking tape and marker
****** you need car lift ******
remove all plastic part molding from engine
find the engine hoist holes for chain to hook to
this is a unibodi design so the whole front chassis drops down
unbolt the chassis make sure to have the chasis blocked and stable
lift car while chasis stays on floor engine tranny and every thing inside hood comes down on the unibody this is how you remove an engine from a sebring

or you take to the dealer spend the doe cause you got a nice car and have it done right

Posted on Jun 13, 2008

dealt_soul
  • 296 Answers

SOURCE: 2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

Posted on Jan 18, 2009

  • 1 Answer

SOURCE: no power to cigarette lighter, and no fuses

Did you check the fuses under the hood? The cigarette lighter fuse is not located in the fuse box by the passenger door.

Posted on Apr 07, 2009

goofduck
  • 490 Answers

SOURCE: 2001 Chrysler Sebring- difficulty steering,

the belt will be on the front pulley on the power steering pump

Posted on Apr 22, 2009

housejess
  • 317 Answers

SOURCE: How do I replace the window motor in my car?

take the door panel off...should be 3 bolts holding motor inplace and wiring to unplug...make sure the window is up when attempting ...its not as difficult as it seems thanks and have a good day

Posted on Nov 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace head unit on 2001 sebring a/c


Sounds like you just need a single bottle of Freon to recharge your system. Do that before you think about pulling the unit apart. It's easier and cheaper to replace the compressor than the head anyway. But I don't think the compressor is the problem. Just put a bottle of Freon in.

Aug 11, 2014 | 2001 Chrysler Sebring

1 Answer

How can i manually get the window down on my 2001 sebring


You would have to take the door panel off and disassemble the window regulator. Your window motor may have died since it is used the most.

Jun 22, 2012 | 2001 Chrysler Sebring

1 Answer

Where is the window fuse in a 2001 chrysler sebring


On the end of the dash drivers side, with the door open, you will see a cover. Pull on that cover and it will come off. The Power Window fuse is #4 which is a 15 amp blue fuse.
6_18_2011_2_46_23_pm.png

Jun 17, 2011 | 2001 Chrysler Sebring

1 Answer

My chrysler sebring has power but will not start.no clicking sounds


put battery on charge first then try again if still no joy then call the dealer as the immobilisor could have cut in ,try the spare key as well

Jul 16, 2010 | 2001 Chrysler Sebring

2 Answers

Tire specs for 2001 chrysler sebring


HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.


2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16

Jul 06, 2010 | 2001 Chrysler Sebring

1 Answer

2001 sebring ewont even turn over. but have lights


check connection at starter, check solenoid

Oct 03, 2009 | 2002 Chrysler Sebring

1 Answer

Needing timing belt diagram for 2001 chrysler sebring 2.4 sohc


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2001/make/chrysler/model/sebring/2001_chrysler_sebring_drive_belt_routing_diagram.htm

Sep 25, 2009 | 2001 Chrysler Sebring

1 Answer

2001 Chrysler Sebring- difficulty steering,


the belt will be on the front pulley on the power steering pump

Apr 22, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
2001 Chrysler Sebring Logo

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...