Question about 2000 Pontiac Grand Prix

1 Answer

Need picture of 2000 Gran Prix radio panel removal

Need to remove face plate of radio & fix channel light

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 371 Answers

Https://youtu.be/k4IxZevcAb8

Posted on May 06, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ndguy2481
  • 251 Answers

SOURCE: Replace multifunction switch on Pontiac Gran Prix 2000

no just the top and bottom of the steering wheel cover

Posted on Dec 07, 2008

  • 21 Answers

SOURCE: i want to install a

Under the steering wheel by your feet, remove the 2 screws that hold the panel up. Carefully remove that, then just take your hands and start popping the dash off, but be CAREFUL! 

Posted on Apr 20, 2009

  • 1986 Answers

SOURCE: how do i take the door panel off a 2007 pontiac

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring.

Posted on Nov 16, 2009

ZJLimited
  • 17970 Answers

SOURCE: how to remove the door panel on a 2005 grand prix

Just an philips screw, you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.

If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door.

Hope helped with this (remember rated this).

Posted on Mar 09, 2010

jsmes1027
  • 749 Answers

SOURCE: 2001 Grand Prix: Is the blower motor resistor on a Pontiac 2001 Gra...

It is behind and underneath the glove box back by the firewall. No need to pull out the glovebox.You may need to pull the carpet back to get to one of the bolts.

Posted on May 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the signal light relay that makes signal lights flash located on 2000 ols intrigue 3.5 liter


Important: The hazard warning switch includes the turn signal and hazard warning flashers.
Removal Procedure
Remove the center air deflector. Refer to Instrument Panel Center Air Outlet Deflector Replacement .
Squeeze the retainer on the backside of hazard warning and cruise control switch.
Pull the hazard warning and cruise control switch from the retainer in the instrument panel.
Disconnect the electrical connectors from the hazard warning and cruise control switch.
Remove the hazard warning and cruise control switch from instrument panel.
Remove the hazard warning and cruise control switch bezel from the instrument panel trim pad by using a small flat-bladed tool to the release retainers.
Remove the radio. Refer to Radio Replacement in Entertainment.
Reach through the radio opening and push the retainers up towards the roof of the vehicle. When the retainers release, slide the instrument panel (I/P) center air outlet deflector out of the I/P opening
Remove the air outlet deflector
Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges, and Console.
Remove the bolts from the radio.
Pull the radio toward you.
Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement .
Pull the instrument panel (IP) accessory trim plate away from the IP trim pad.
Disconnect the IP harness seat heater leads, if equipped.
Remove the seat heater switches from the IP accessory trim plate, if equipped.
Remove the IP accessory trim plate.

Nov 09, 2016 | Cars & Trucks

1 Answer

How do i remove the stock radio from my 1993 geo metro 4 door hatchback


here is the online fsm quote

  1. Disconnect the negative battery cable.
  2. Open the glove box. Remove the glove box open panel.
  3. Remove the air conditioning switch connector and heater control unit lever knobs. Pull heater control unit cover plate from instrument panel.
  4. Remove the gearshift control lever upper boot and center console.
  5. Remove the ashtray.
  6. Remove the instrument panel center trim bezel and radio face plate.
  7. Remove the screw from the back of the radio receiver and the screws from the front face of the radio.
  8. Remove the radio.

Sep 30, 2014 | 1993 Geo Metro

1 Answer

2005 Pontiac Gran Prix 140000 miles. The engine icon on the face plate of the speedometer at the lower right came on, (Not the Check Engine light),. What would cause this icon to come on? I had it reset...


this one? That is the check engine light.

airjer995_22.jpg

Sounds like you may have a code for insufficient engine operating tempurature. This is usually caused by a bad thermostat. Its pretty common to see this problem on newer GM vehicles. A new thermostat will take care of it 99% of the time.

To find the thermostat follow the upper hose to the engine. The thermostat will be behind the metal housing that the hose attaches to on the engine.

Dec 06, 2010 | 2005 Pontiac Grand Prix

1 Answer

How do i replace a starter on a 2000 Pontiac gran prix, what do I need to do !


The starter is located at the front of the engine at the engine to transmission mounting surface.

Disconnect negative battery cable.

Raise and support the vehicle to give access to underside of engine.

Remove main battery cable from starter solenoid (large cable 13mm nut) and solenoid "S" terminal wire (8mm nut) Both at back of solenoid.

Remove inspection plate, usually 10mm screws, one in front and one up from bottom.

Remove the two 15mm starter mount bolts.

Reverse proceedure to install.

Oct 30, 2009 | 2000 Pontiac Grand Prix

2 Answers

How do i remove ignition switch on steering cloumn of 2000 pontiac gran prix


unless u are familiar with air bag assemblies I suggest u take it to a qualified mechanic..if u accidently touch something wrong u can deploy the bag and cause serious harm to yourself..u have to remove the air bag in the steering column

Sep 16, 2009 | 2000 Pontiac Grand Prix

1 Answer

I need to remove the radio in my 1998 mountaineer


you need specail radio removal tools. they spread 4 spring clips.

  1. Remove the radio chassis.
  2. Insert Radio Removing Tool into the radio face plate and release the radio retaining clips.
  3. Pull outward on Radio Removing Tool to remove the radio chassis from the instrument panel.
Special Tool(s)

Radio Removing Tool
415-001 (T87P-19061-A)

19701bc.gif

May 12, 2009 | 1998 Mercury Mountaineer

1 Answer

Radio and dash lights


Remove radio from vehicle. remove T15 torx screws on top and sides of radio. Remove knobs and outer bezels around knobs. Face has retainer clips top and bottom. Unsnap the face of radio and remove old bulbs there are five or six in a gm radio.

Jan 12, 2009 | 2001 Chevrolet Blazer

1 Answer

Light out on toyota Sienna radio


FIXED MINE! My 2000 Sienna XLE had the same problem with the lights not working. They would flicker on once in a while. I took off the face plate, cleaned the radio with a "can of air" to remove any dust, put electrical grease on the face plate contacts and the plugs on the back of the radio. Reassembled and the lights worked better, but dim and flickered off a bit. Knocked on it a few times on the side to get those contacts to work better and it is now working. My guess is the contacts on the faceplate were not making good contact. If I had to do it again, I would pull on and off the face plate a few times after installing the electrical grease to help loosen up any corrosion for a better connection. That would probably eliminate the need to beat on the side of the radio after reassembling. This fixed mine. Hope it works for you.

Dec 08, 2008 | 2000 Toyota 4Runner

1 Answer

Replace multifunction switch on Pontiac Gran Prix 2000


no just the top and bottom of the steering wheel cover

Dec 07, 2008 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
2000 Pontiac Grand Prix Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...