Question about 2000 Chevrolet S-10

1 Answer

I have brake lights, but no tail lights, it is not the sensor, have checked the fuses, still the same what else could it be?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,326 Answers

Switch bad

Posted on Apr 26, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights work but tail lights out - Help! (Thanks)


Tail lights are on a different fuse than the headlights. If you already checked the bulbs then check the fuses. They're under the dash, on the left side of the driver.
Hope this helps.

Mar 26, 2015 | 2011 Honda Pilot EX-L

2 Answers

I have 89 bronco 2 my brake lights turn signals both work my tail lights don't work have check fuse n blubs what might be the problem


The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

Feb 25, 2013 | 1987 Ford Bronco II

1 Answer

How do i remove the sensor for the rear tailgate?


1) Locate and remove sensor.
The sensor is located under the drivers tail light. Unclip it from the body and then unplug it.

2) Bypass the tail light circuit.
Connect the tail light signal wire (Green) to the tail light wire (Green w/ Red Stripe). I recommend using wire tap in squeeze connectors that way you dont have to cut any wires.

3) Bypass the brake light circuit.
Connect the brakelight signal wire (Green w/ White Stripe) to the brake light wire (Red w/ Blue stripe) and the the 3rd brake light wire (Red w/ White Stripe). Again all three of these wires are to be connected together.

4) Throw away your broken Tail Lamp Failure Sensor
Do not plug your sensor back in. Doing so will cause the annoying orange lamp failure warning light on your dash to stay on. Leave it unplugged ant the light will stay off.

5) Test your work
Turn on your lights and make sure your tail lights work properly. Have a friend step on the brake pedal, and make sure your brake lights work properly as well. Dont forget to check the Third brake light.

Sep 20, 2012 | 2002 Chrysler Voyager

1 Answer

My tail light not working


Which light?
One light not working? Check the bulb.
Both tail lights not working? Check the fuses and the bulbs.
Brake light (or lights) not working? Check the bulb, fuses and brake light switch.
Totally no lights in one or both tail light assemblies? Check the plugs on the light assemblies from inside the car. Check the fuses. Check the grounds (might be some under the dash for those lights).

Aug 23, 2011 | 1988 Mazda RX-7

2 Answers

Interior dash and running lights dont work but my signal and brake lights work else works


Look at fuse #18, a 15 amp fuse, in the fuse block. This fuse powers both the tail lights and instrument cluster lights. Usually both of these light systems are powered by the same fuse so when your cluster isn't lit up you'll know right away that your tail lights aren't working as it's not safe to drive without tail lights. Your brake, turn, and head lamps are powered by different circuits. Hope this helps and good luck!

Aug 11, 2010 | 1997 Dodge Ram 1500 Club Cab

2 Answers

No tail lights


Before you just replace the fuse, if it's blown there is a reason. Also if it's blown you probably don't have dashboard lights or running lights on the side of the car. Note this is for tail lights (parking lights) not brake lights. The fuse is 15 A on driver's side wall next to brake pedal. Should be top left as you look at it, of course looking at it is a challenge unless you are very limber. If your dash board lights work but you have no tail lights then the fuse is ok and you Lamp Failure Sensor is burned up. Probably the little nichrome wire in it in the tail light circuit. This is probably caused by a dead short in the harness to the trunk lid. It can get pinched at the hinge it you load something in the trunk and push it out of place. Check that harness for damage before you waste money on a new sensor. They are hard to come by and if you have a short you'll just burn up a new one. I just did this this weekend and had two frayed wires inside the protective sheath. I clipped them, crimped them back together and covered with shrink tubing, repackaged and made sure it didn't get near the hinge. All better now.

Mar 07, 2010 | 1991 Toyota Camry

1 Answer

87 celica. tail lights do not work, but brake and others do


Check the tail light failure sensor. Located in the driver's side kick panel fuse box. ~Rick89GTS

Jan 06, 2010 | 1987 Toyota Celica

1 Answer

I've checked all the components, relay, pedal switch, fuse, bulbs and I still don't have brake lights. The third brake light works but no brake lights, every thing else works, tail lights, flashers and...


The mechanic needs to check again the connection of the brake light to the fuse and the wires . then try checking terminal sockets of the brake light that can also be the problem.if still not working try to look at the sensor .

Aug 11, 2009 | 2003 Ford E150

1 Answer

Tail and brake lights quit working


Auto light shut off is a relay that is basically a timer.
Replace it .

Jun 23, 2009 | 1989 Toyota Camry

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...