Question about 2002 Honda Accord

1 Answer

Po1362 and po1359 on 2002 honda accord se 2.3 engine

No spark damaging igniter and coil bad cps

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 195 Answers

Hi brian.
I think you mean P1362 and P1359
both fault codes are pointing to the crankshaft sensor.
check the wires/ connector. replace the crankshaft sensor.
Good luck

Posted on Apr 26, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have fuel but no spark. what can it be?

it could be a crank sensor, ignition module, coil, if this has a distributor could be pickup coil or a bad distributor, bad cap/rotor. could also be a PCM problem on the ignition circuit.

Aug 24, 2014 | 2001 Jeep Cherokee

1 Answer

91 civic dx no spark. Checked fuses, all good. Checked ECU (Replaced). Checked coil, ohmed good. Checked ignitor, via parts store 8x, all passed. Checked continuity ECU->Distributor, good. Checked main...

How About the CPS Crank Shaft positioning sensor? otherwise Sounds Like( Im Not Sure what you are saying you replaced the ECM) Electronic Control Module) ? Or Electronic Control Unit? Otherwise Checking to make sure you have a good ground from the battery to the motor to firewall as well,also im pretty sure there is a switch in your fuse box for the ignition and fuel pump last but not least coil could be bad even though you have ohms and how many ohms?(ps you said you forced spark thru hooking strait up to positive you got little Spark when you did that? if you did sounds like ground or low voltage or Bad Coil !! have you hooked up and tried to pull a code ? I hope this helps!!

Jul 26, 2017 | Cars & Trucks

1 Answer

My 1995 fxstsb keeps misfiring on the rear cylinder. I have replaced the coil, plugs, and wires and after about 5 minutes of running good it started misfiring and sputtering again. What else can it be

Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals especially the negative cable at "BOTH" ends, ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For a prime suspect please visit website below.
Good luck and have nice day.
Harley Davidson Wiring Diagrams and Schematics

Mar 31, 2013 | Cars & Trucks

2 Answers

My 2003 saturn ion will turn over but willnot start

You may have two issues, one with starting and running while the other may be ignition lock cylinder related. You may be able to try using the spare key if you have one otherwise its recommended to have one made by Saturn and try it before determining that its a worn out lock cylinder. Then Saturn may be the best choice to at least configure a new lock cylinder with the original keys to match. The lack of engine firing up may be a simple cps failure.

The engine turning over but never firing up may be related to the crank position sensor (CPS) as long as you don't see the security light flashing in the speedometer or tach. The security light flashing would mean the factory anti-theft deterrent system is preventing engine running by disablng the fuel pump. No fuel pump = no engine run. Determining a faulty cps is by way of observation - the spark from the ignition system is observed. Remove the spark plug wires, noting the firing order carefully, from the coils and have someone crank the engine over so you can watch for expected sparks across the coil towers. A lack of sparks usually means a failed cps as the only other failure would be the ignition module that the two ignition coils mount onto. The cps is mounted behind and above the starter with one 10mm bolt. You can buy it from any auto store stocking it.

Nov 04, 2011 | 2003 Saturn ION

1 Answer

2001 Hyundai Accent1.5L It has no spark. I replaced the ignition coil and still no spark. It is getting power to the coil. I was told to check the crank sensor. Any other suggestions?

I would check the CPS too, if the the sensor is bad, it has no idea where or what position the crank is in so it's not going to start.

Mar 12, 2011 | 2001 Hyundai Accent

1 Answer

Locartion of primary/secondairy ign. coil d on a ls lincoln

You have COP Coil-On-Plug ignition system. A coil on top of each spark plug,no wires.

On the V6, the coils are in the middle of the valve covers

On the V8,you remove the coil covers on top and in the middle of the valve covers.

Do not be putting a meter on them,as you won't see the primary ,unless the Ignition Pulse Wheel is turning and the CPS has an output.
If you touch the ground side,you will take out the PCM drivers.

A PO-301 to PO-308 Code,could mean a bad coil. The last # is the Cylinder

May 24, 2010 | 2004 Lincoln LS

1 Answer

I have a 1997 Gmc Sierra 5.7 4x4. It has no spark. I replaced the coil and ign module today but still no spark. Tech suggested Crank shaft sensor? Truck was running then died going down road. (30kms after...

It could be the CPS, but as you now know throwing parts at a repair is costly and sometimes it does not fix anything. A code scanner should be able to tell you if the sensor is bad. If the CPS goes bad you will have no spark.

Oct 17, 2009 | 1997 GMC Sierra

3 Answers

'93 Mitsubishi Mirage Still Not Starting

Hi there are few things that you have not check that can cause this problem,cap and rotor , pick up coil regular coil ,fuse (start with the less expensives) good luck

Aug 18, 2008 | 1993 Mitsubishi Mirage

Not finding what you are looking for?
2002 Honda Accord Logo

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides