Question about 2006 Suzuki Forenza
Left/right or up and down
most new cars do not allow left/right.
so not knowing whats UP> we cant help
you might read the FSM for 4 bucks like we must....
usa answer. on a USA forum
but if not here, other countries (europe) have auto aiming lamps.
so..... gee, where are you.
posted over 100 times.
you can read the manual here, if car is USA car.
if not, you need to ask SUZUKI. where you live.
Posted on May 23, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: head light replacement
Hi, I have done this many times before for my 2006 Suzuki Forenza. You will need a 10 milimeter socket wrench for the top two nuts and a 8 milimeter socket wrench for the nut located directly behind the highbeam light. After removing the nuts carfully tilt the head light upward and wiggle out. After moving it halfway, disconnect the two wires connected to the housing. Be careful not to scratch the trim located around the grille. The bulb has a rubber gasket over it. Remove turning counter clockwise. Then, with your index finder slightly push the metal bracket holding the bulb in place down and then release. Install a new bulb making sure not to touch the glass part of the bulb. Reinstall the rubber gasket and carfully put the light housing back into the car. Line up all holes before attempting to replace the nuts. Do not tighten them too much. Only until they are slightly snug. This housing is plastic. So be carful. Then you are finally done. One thing to remember. It's usually better to replace both headlights at the same time for optimum performance. If cost is a factor, one can be done, but you will notice a difference in brightness.
Posted on Aug 22, 2008
Right on the transmission, to the right side of the engine bay as you are looking down on it. It is a black plastic part that is bolted on the transmission with two 10mm bolts, and connected to the transmission with rod and clip. It is partially obstructed by the radiator hose, but otherwise really easy to get to.
Posted on Jan 28, 2010
The diagram should be located under the hood by latch that holds your hood down on either the hood or the support for the radiator.
But hope these help. Also check out Suzuki Forums for more info
Posted on Feb 07, 2010
You will have to do it from under the hood. You will have either a plastic cap that you can turn a 1/4 turn counterclockwise and remove or a rubber type cover that you will have to pull out of place. Just follow the wires that go to the lights to find it. Once you get the cap/cover out of the way you will be able to either pull the lamp socket to you (good) or you will have a fastener that looks like a bent paperclip (bad) that you will have to get to release the bulb holder. For the good situation just unplug the old lamp and plug the new one in-DO NOT TOUCH THE GLASS BULB with your hands-then reassemble. IF you have the "bad" situation, squeeze the clip to see if it releases. you may have to take one of the screws loose that holds it. Once you get it loose unplug the old bulb and plug the new one in DO NOT TOUCH THE GLASS part-skin oils will make the bulb go out FAST, and you do not want to have to do this more than you have to. Put it all back together.
Posted on Mar 23, 2010
Tips for a great answer:
Oct 06, 2014 | 2005 Suzuki Forenza
Dec 31, 2013 | 2006 Suzuki Forenza
Jan 02, 2011 | 2006 Suzuki Forenza
Dec 30, 2010 | 2006 Suzuki Forenza
Sep 22, 2009 | 2006 Suzuki Forenza
Apr 12, 2009 | 2006 Suzuki Forenza
129 people viewed this question
Usually answered in minutes!