Question about 1999 Oldsmobile Cutlass

1 Answer

Fan will not run - 1999 Oldsmobile Cutlass

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Oldsmobile Master
  • 428 Answers

Howdie sounds Like the fuse Or the relay is Blown Look at Replacing those and it will work again or if it has Lots Of KM,s it just might be the Fan replace it Done

Posted on Apr 25, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My coolin fan wont come on wat should I do

Cooling fan is controlled by a relay and a temp sensor. You need to check that each piece is working.
Run power to the fan. fan run? fan ok.
Bridge the relay. Fan run? run power to the relay coil. Fan run? relay good.
find temp sensor. replace.

May 29, 2015 | Cars & Trucks

1 Answer

1996 ford tbird fan runs at high speed once engine is started.

Have you tried changing the fan relays? Sounds like they may be stuck on.

Mar 11, 2014 | Ford Cars & Trucks

1 Answer

Cooling fan not running as temp. heats up.

most time coolant temperature sensor faulty.but check cooling fan fuse and relay.then hot wire the cooling fan if fan runs.problem in the fan wiring or pcm.if every thing else okay.if cooling fan dont run when hot wired the cooling fan need replacing fan motor has internal open winding circuit.

Apr 15, 2011 | 1995 Buick Skylark

1 Answer

Engine radiator cooling fan won't come on

The first thing is to test fan motor, unplug it and test it by powering it up to see if it runs, if fan runs then the next thing is to check the fan switch sensor, this is the sensor that controls the fan, jump connector to see if fan runs, if the fan runs then fan and relay are good and mostlikely its the switch sensor,

Aug 29, 2010 | 1994 Pontiac Grand Am

2 Answers

My camry 1993 engine is heating up while idling or in traffic also when ac is on. drives well on high speed without overheating

You have a radiator fan motor that is not running either due to a thermostatically controlled temp switch,(Located on the back of the radiator) a failed fan relay (in the engine compartment fuse /relay box) or a bad fan motor.
You can troubleshoot by checking for 12V DC to chassis ground at the fan motor temp switch. If you have power in you can jumper with a wire the switch wires and see if the fan runs. If it does not run then you need to check the fan relay and motor.

To test the fan you can run a wire from the battery to the fan and another wire to chassis ground to see if the fan runs. If after directly connecting 12V DC to the fan motor and it does not run the fan has failed.

As far as the you either replace it with another one or... have to figure out which 2 wires control the fan motor and jumper them out to see if the fan runs.


Jun 01, 2010 | 1993 Toyota Camry V6

1 Answer

Cooling fan stopped running

check fuse and relay.if all is wire cooling fan using jumper wires to battery.if fan dont run replace the fan.if fan does run you have a open wire or bad connection at cooling fan electrical connector.

Nov 22, 2009 | 1999 Jeep Grand Cherokee

1 Answer

I have a 2005 Jetta 2.5 and it seems like one fan runs to fast

One fan should run when engine is running. Other fan should run when AC is on.

Jun 28, 2009 | 2005 Volkswagen Jetta

1 Answer

03 Mini Cooper Power Steering Fan will not run

2006 mini cooper s power steering fan seezed. replaced with new fan won't run?

Mar 30, 2009 | 2006 Mini Cooper

1 Answer

Cooliant fan not running

The tempature switch for the fan will be located on the radiator tank, most likly near the bottom or mid way up. It will have two wires in most cases.

With the key on but the car not running, connect these two wires together. If the fan runs, replace this radiator switch.

If the fan does not run, pull the connectors apart going to the fan itself. Jump power and ground to each of these two wires. If the fan does not run, the problem is the fan. If it does run, the problem is most likely the relay for this fan

Good Luck!

Feb 09, 2009 | 2001 Kia Rio

3 Answers

2001 Jeep Grand Cherokee Radiator Fan Doesn't run

Have you confirmed the fan has a good ground, sounds like you have eliminated the issue of 12 volts, when you turn on the fan then the AC does the compressor run? if the compressor runs pull the plug to the fan motor and check to see if has 12 volts with a test light, wait for moment because the fan may not run until the AC system pressure reaches a certain pressure point, this means that even though the compressor is running the fan may not always run, There is a quick test for the fan circuit, disconnect the fan sensor at the thermostat housing, the fan should come on, this is failure mode, so if the switch goes open the fan will run to keep the engine from overheating , let me know after the tests are run.

Dec 01, 2008 | 2003 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Oldsmobile Cutlass Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides