Question about 2001 Nissan Micra

Open Question

My Nissan micra 2001 not starting.use keys to unlock doors but strange sounds comes from front n back door locks when try to lock/ unlock.

When I Turn the ignition from 0-1 all lamps lit normally but it doesn't start and lights starts flickering

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hiseyj
  • 99 Answers

SOURCE: Lost door lock remote for 2001 Nissan Xterra.

You don't want to turn the security system completely off, besides there really is no need to. To arm and disarm the vehicle simply use the key in the drivers door. When you turn the key and lock the car the system will arm after about 30 seconds. When you come back to the car and unlock the car with the drivers door lock cylinder the system will unarm, just the same as if you were using the remote. If the system is unarmed and it still wont start you probably have a NATS issue with the key. This is different than simply disarming. You can't shut off or disarm the NATS system.

Posted on Nov 29, 2008

Gypsybaron
  • 80 Answers

SOURCE: driver door won't lock with key fob

Check the locking solenoid / actuator in the door behind the panel, could be burned out or loose wire. It should take about 20-30 minutes to open, fix it and close the door panel if there's no major problem. Autozone might be able to help out with a solenoid.

Posted on May 17, 2009

  • 6 Answers

SOURCE: Noisy central locking Nissan MIcra

Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.

Posted on Jun 07, 2009

  • 6 Answers

SOURCE: Nissan Micra 04. The central locking is making a noise

Hi there, this is a very common fault, what ever side door the noise is coming from you need to replace the door actuator to cure the noise, Ive done loads of these, not sure how much it is though, hope this helps.

Posted on Jun 07, 2009

FixurNissan
  • 61 Answers

SOURCE: 2003 Nissan Murano Driver door won't lock or unlock with keyfob

The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.

Thanks Jay!

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver door wont open from the inside in my 2007 Nissan Micra. All other doors fine and opens with central locking from outside


open or unlock?
if open then the little bar has come off inside on the door handle.
If unlock then the servo has failed.
Might be possible to rekit

Apr 16, 2017 | Nissan Cars & Trucks

1 Answer

Nissan micra central locking locks but makes a grinding sound on on side of the car.


Put your ear to the door and listen to where the grinding/buzzing noise is coming from when you lock the door, sometimes it maybe more than one door! The door it's coming from need a door actuator, common fault with the k12 micra's, which i'm guessing this is a k12 model!

Feb 04, 2015 | Nissan Cars & Trucks

1 Answer

My 2001 Micra locks itself all the time, and to unlock it I have to turn the key exactly 4 and a half times and it unlocks. All I want to do now is to disable the central locking...but I can't fin


check your manual, im sure there is a menu that pops up on the dashboard with the key in the ON posistion useing your turn signal or wiper control arm.. sometimes its buttons on the stearing wheel that controls the dash menu too.. good luck..

Oct 17, 2012 | 2001 Nissan Micra

1 Answer

Central locking playing up on nissan micra k11


You probably have a defective door lock switch. (the one on the inside door panel)

May 14, 2012 | Cars & Trucks

1 Answer

How do i reset central locking on a micra 04 reg


Try the following:

"KEY FOB PROGRAMMING
NISSAN
SYSTEM DESCRIPTION
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and hazard reminder. When the doors are locked and
unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed.
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Then turn ignition switch to OFF position. Leave key in ignition switch.
3. After 2 seconds, the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key?s.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key?s for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds."

Mar 12, 2012 | Nissan Cars & Trucks

1 Answer

Nissan Micra 04. The central locking is making a noise


Hi there, this is a very common fault, what ever side door the noise is coming from you need to replace the door actuator to cure the noise, Ive done loads of these, not sure how much it is though, hope this helps.

Jun 06, 2009 | 2004 Nissan Maxima

1 Answer

Noisy central locking Nissan MIcra


Hi there, this is a very common fault, you need to replace the drivers door actuator to stop the noise, ive done loads of these. hope this helps.

Feb 24, 2009 | 2007 Nissan Armada LE

2 Answers

Cannot get my car to lock without the keyless entry


check the room 10a fuse that is the problem

Feb 22, 2009 | 1997 Nissan Pathfinder

1 Answer

Lost door lock remote for 2001 Nissan Xterra.


You don't want to turn the security system completely off, besides there really is no need to. To arm and disarm the vehicle simply use the key in the drivers door. When you turn the key and lock the car the system will arm after about 30 seconds. When you come back to the car and unlock the car with the drivers door lock cylinder the system will unarm, just the same as if you were using the remote. If the system is unarmed and it still wont start you probably have a NATS issue with the key. This is different than simply disarming. You can't shut off or disarm the NATS system.

Nov 29, 2008 | 2001 Nissan Xterra

3 Answers

Key fob not working


hello mate.. if it has stopped working you might want to check the battery first.. if you are sure that the battery is fine then consider reprogramming the fob to your car.. here are the steps to follow.. NISSAN

Remote Control Fob Procedures:

The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and emergency hazard reminders.

When the doors are locked and unlocked the unit flashes the hazard lights once for lock and twice for unlock.

A maximum of four remote controls are allowed to be programmed:

ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II

Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.

Procedure:
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Next, turn ignition switch to OFF position. Leave key in ignition switch.
3. Wait 2 seconds then the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key's.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key's for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds.


http://www.autokeysquad.com/nissan-fob-programming



i hope this can help you.. :)

Jul 28, 2008 | 2005 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Micra Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...