Question about 2004 Lincoln LS V8

Open Question

How do I install power steering pressure hose on a 04 lincoln ls v8? Is there any diagram or pictures?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75066 Answers

SOURCE: Trying to figure out the cylinder numering of my 04 Lincoln ls

this is a photo of your engine's firing order.
df2a723.gif

Posted on Mar 13, 2009

Mr BrokRench
  • 1623 Answers

SOURCE: I need the location of the low pressure ac port

The lincoln better idea engineers put the low side freon port in a peculiar place.. You will find the low pressure port near the compressor under the car on the driver's side. You will need to put your car on a lift to get to it. Once you raise your vehicle, take the plastic shields off and you will find the compressor...yup...it's a tight spot.
Hope i was able to answer your question...be safe.

Posted on May 13, 2009

  • 2 Answers

SOURCE: How to replace high pressure hose on steering,

Found a diagram online myself..

Posted on Nov 09, 2009

SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...

First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)

Posted on May 06, 2010

SOURCE: diagram for a 2000 lincoln ls V8

Your best ,to cut the old belt,to remove.

You can use a long handle 1/2" drive ratchet, on the belt tensioner.

The only pic is in the shop manual.

Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.

Draw a picture before you start, and you won't need a diagram

Posted on May 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need firing order for lincoln94 mark vllland diagram plz ,Jose


images for firing order lincoln ls v8

Question LS V8 Firing order - Lincoln vs Cadillac Forums

www.lincolnvscadillac.com/forum/showthread.php?...LS-V8-Firing-orde...

Sep 14, 2012 - 17 posts - ‎3 authors
Firing order on 2001 LS V8 Bank 1 & 2 1-5-4-2-6-3-7-8 ??? 1) Can someone draw/show me a picture on how that looks when facing the front of ... firing order from 95 dual coils to plugs
6 posts
Aug 2, 2012
'05 LS V8 firing order and coil installation?
9 posts
Nov 19, 2009
Firing order?
5 posts
Mar 20, 2008
What is the firing order for a 2000 LS V8?
3 posts
Nov 23, 2007
More results from www.lincolnvscadillac.com

Jan 08, 2016 | Cars & Trucks

1 Answer

2001 Lincoln ls v6 throttle body hose diagram after throttle body


V6 or V8

I have a 2004 V8 & all the manuals for 04

No one will provide you what you need
& very few people but me, even answer
LS questions

Only made for 7 years & too high tech

What issues do you have?

Jun 12, 2011 | 2001 Lincoln LS

1 Answer

Where is the thermostat on a 2000 lincoln ls


On a V6 driver side front of engine in hose assy,
in front of power steering pump

On a V8 behind the Throttle Body, hard to miss that one,
the radiator hose goes to it.

Jun 10, 2011 | 2000 Lincoln LS

1 Answer

How to replace power steering pump on 2001 lincoln ls v8


please rate if this helps. Might find one cheap on ebay.

Power Steering Pump - 3.9L
Special Tool(s) st1444a.gif Teflon® Seal Replacer Set
211-D027 (D90P-3517-A) or equivalent
Removal
  1. Remove four pushpins and the engine cover.
    a0004091.gif
  1. Remove the air cleaner and the air cleaner outlet tube. For additional information, refer to Section 303-12.
  1. Remove the bolts.
    a0001108.gif
  1. Remove the accessory drive belt. For additional information, refer to Section 303-05.
  1. Unclamp and disconnect the power steering reservoir-to-pump hose (3691) and drain the reservoir (3E764) into a suitable container.
    a0001104.gif
  1. Position the power steering reservoir out of the way.
    1. Loosen the bolts.
    1. Rotate the reservoir from the insulator.
    1. Pull the reservoir down from the insulator and position the reservoir out of the way.
    a0001105.gif
  1. Raise the vehicle on a hoist. For additional information, refer to Section 100-02.
  1. Remove the wheel and tire assembly. For additional information, refer to Section 204-04.
  1. Remove two bolts, one pushpin and the shield.
    a0000396.gif
  1. Remove two pushpins and the shield.
    a0001110.gif
  1. Remove the bolt.
    a0001111.gif
  1. Disconnect the electrical connector and the wire retainer.
    a0001112.gif
  1. Remove four bolts and position the A/C compressor out of the way.
    a0001113.gif
  1. Disconnect the power steering pressure hose.
    a0001114.gif
  1. Remove the bolts.
    a0001115.gif
  1. Lower the vehicle.
  1. Remove the bolts and the pump.
    a0001116.gif
Installation
  1. Using the appropriate special tool, install a new O-ring on the power steering pressure hose fitting.
    a0001117.gif
  1. NOTE: Do not tighten the upper bolts until the lower bolts are installed.

Jun 10, 2011 | 2000 Lincoln LS

1 Answer

Cant find a engine coolant bleeder on 04 lincoln ls


On a 3.9 V8 it is on the end of the hose under the
power brake booster,next to the degas bottle (coolant container)
below master cyl

On the 3.0 V6 it is on top off a coolant hose near
the throttle body

Nov 27, 2010 | 2000 Lincoln LS

1 Answer

Where is the thermostat on the 2005 Lincoln LS


V8---top hose to throttlebody-behind plastic rad cap

V6--hose on driver side,in front of power steering pump

Aug 24, 2010 | 2005 Lincoln LS

1 Answer

Diagram for a 2000 lincoln ls V8


Your best ,to cut the old belt,to remove.

You can use a long handle 1/2" drive ratchet, on the belt tensioner.

The only pic is in the shop manual.

Wear long sleeves and arm protector sleeves on top. the fan housing is sharp and a tight fit. You will be there a couple hours.

Draw a picture before you start, and you won't need a diagram

May 14, 2010 | 2000 Lincoln LS

1 Answer

GMC 350 V8 POWER STEERING DIAGRAM


The high pressure and low pressure hoses are different sizes at the gear box. And the low pressure /return hose is usually rubber with a clamp at the back off the pump.

Mar 03, 2009 | 1993 GMC Sierra K1500

Not finding what you are looking for?
2004 Lincoln LS V8 Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

fordexpert

Level 3 Expert

5470 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...