SOURCE: unable to bleed front brakes
loosen the front brake line that goes to the master cylinder fill master cylinder up with fluid and bleed it first by attaching a flexible line from master cylinder front brake side submerge that line into jar of brakefluid keeping air from entering line get someone to pump brake pedal while ur holding line in a jar keep refilling the brake resivoir so no air gets in, once the master is bled front brake side then reattach the origional brake line then remove bleed screw from caliper and let fluid gravity flow down to calliper then bleed the normal way. more than likely your master cylinder has air trapped in the front portion good luck
SOURCE: Trail Blazer LT 2002 Manual
http://www.books4cars.com/result3.asp?finddesc=trailblazer&imageField2.x=0&imageField2.y=0
Here is one but its $40 or so.
SOURCE: 2005 CHEVY +TRAIL BLAZER ABS AND BRAKE LIGHTS ON
if chains caused problem and you have driven with them off light would have gone out once it saw everything working properly. look at sensors might have pulled a wire loose with chains. the abs system runs a self test everytime you start vehicle if it sees a history code from last time it will leave light on and look to see if that problem still exists and 99% of the time it will cut light off . but need to have scanned and checked out
SOURCE: 2005 CHEVY +TRAIL BLAZER ABS AND BRAKE LIGHTS ON
When the ABS light is on when driving there is a problem in the anti lock brake system and you will need to have it tested to find out what the problem is. As long as the light is on the ABS has been shut off by the computer until it is repaired. There could be problems with one of the wheel speed sensors, wiring or the ABS pump. On some vehicles the red brake light will come on too.
SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
202 views
Usually answered in minutes!
×