Question about 1999 Chevrolet Silverado 1500

Open Question

1999 chev Silverado missing when ya drive it for 2 until you restart it

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 196 Answers

SOURCE: Change Fuel Pump on 1999 Chev Silverado v8 2 wd automatic 2 door

well the pump is in the fuel tank and it depends if the tank is full or not if it is its very heavy and you will need a jack and 1 other person to help you there are two fuel lines to unhook and the electrical connector. When replacing it replace the entire fuel pump/sending unit and the electrical harness or you will end up having more problems also spend the extra 15$ and replace the fuel filter

Posted on Jan 08, 2009

Ad
  • 23 Answers

SOURCE: where is the cam shaft sensor in my 1999 chev. silverado 1500

it should be on the drivers side under the exhaust manifold close to the rear firewall.

Posted on Mar 03, 2009

jryan11kc343
  • 19 Answers

SOURCE: on my 1999 chev silverado the power mirrors and my

check fuses & switches

Posted on Mar 07, 2009

luke_bradfor
  • 662 Answers

SOURCE: vibration in low gear

could be a number of things unfortunately.........firstly, it could be a misfire, now even though these are more common over the whole rev range (not just on start off), it cannot be ruled out.........secondly, it could be engine/transmission mounts, if these are worn/cracked or broken, you will feel a vibration/knock on take off, but you would also tend to feel it at each gear change........and thirdly as you suspect it could be the transmission

now for the diagnosis, the questions i am going to ask is :-
1. does the car get serviced regularly (has it had a tune-up), remember it is over 10 years old, and things will be wearing out....
2. is the transmission oil red in color and smells sweet...if yes, then i do not suspect the transmission, but if it is brownish and smells burnt then it would be a high chance that the clutches are wearing in the transmission causing the bands to shudder

im sorry i cant give you more of a definite answer at this stage, but if you would like to provide more info, i could narrow it down for you,


PLease vote if you liked this response

Posted on Jun 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No tail lights and no inside cab lights NEED FUSE BOX DIEAGRAM 1999 CHEV SILVERADO 2500 4X4


the fuses have little metal tabs on each one . use a ohm meter to check continuity on each fuse by probing the metal tabs on each fuse with the two leads from the ohm meter. repeat until you find the culprit. many times this happens when trailer is pulled or trailer wiring harness has been chaffed

Oct 30, 2013 | 1999 Chevrolet Silverado 2500

1 Answer

1999 chev security light on wile driving


Go to this link to learn a little bit about the system and also a couple ways to get around the problem.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Oct 02, 2012 | 1999 Chevrolet Silverado 1500

2 Answers

2001 chev silverado. Filled up with gas started


My Dad had a 1999 Silverado that did the same thing, it's a bad design. You wont run out but keep track of your miles, Then you know how far you can go.

Apr 17, 2010 | 2001 Chevrolet Silverado 1500

1 Answer

HOW DO I CHANGE A CARRIER CASE FOR A 1999 CHEV SILVERADO


remove both wheels
Remove the center axle cover
remove the inner axle C clips
they just slide right out easily
Disconnect the drive shave
Remove the pinion nut behind the drive shaft on the axle
Remove the screw inside the pin for the pinion gears
remove 2 pinion gears and the shaft
Now you can gain access the the bolts for the carrier

Mar 24, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

I have a 1999 chev silverado 5.3L. Engine will


What is the fuel presure? on a vortech engine the presure needs to maintain 60-66 pounds. It is possible that the fuel filter is restricting the flow of gas or could also be a weak pump... just a another thing to check... hope it helps.

Jan 20, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

I replaced my left running light on my 99 chev truck and now neither one will burn what should I do


Is your truck in the garage or outside? If it is inside pull it out and start the truck , for some reason these Chevs will trick you into thinking they are not working until you pull it outside and then they come on?

Sep 24, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

I can here the fuel pump running but it wont start 1998 chev k1500 4.3v6


It may be the cam position sensor or the crank position sensor

May 27, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Where is the cam shaft sensor in my 1999 chev. silverado 1500


it should be on the drivers side under the exhaust manifold close to the rear firewall.

Mar 03, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

My 2002 chevrolet silverado missing


if its missing ya better go find it

Jan 12, 2009 | 2002 Chevrolet Silverado

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...