Question about 2012 Ford Fusion

1 Answer

My rear lights on my 2012 Ford Fusion stay on even when my car is off

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,203 Answers

Sounds like a stuck/bad brake light switch on your brake pedal

Posted on Apr 23, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Ford Fusion 04 Engine Management Light

I had a 2002 model 1.4 Fiesta, same problem Engine management light or ECA, electronic accelaration Control (EAC), it needs a ford dealer to do a computer diagnostic, most likely that it will need replaced.

Mt friend who is a mechanic for ford said that it was a common factory fault and is very common in 1.4 zetec /duratec petrol models.

I now have a 2007 Fusion and was quick to see if this problem had been sorted on this model, and it has!!

Hope this helps!!

Posted on Dec 16, 2008

polarcycle
  • 1392 Answers

SOURCE: Rear bumper on Ford fusion

Are there holes for them? Then yes, if not then no.

Posted on Mar 11, 2009

  • 65 Answers

SOURCE: I have a 2008 ford fusion where the dome light

your problem is probably caused by a sticking door switch try spraying wd40 in the door latches and opening and closing the doors several time do all the doors or you can take it to the dealer and they can scan the body control module and tell you which one it is

Posted on Dec 30, 2009

Testimonial: "You solved our problem. Thankyou so very much! "

  • 12650 Answers

SOURCE: Check engine light stays on.

first check gas cap make sure on properly and not damaged if good have car scanned just because not running bad doesnt mean to much for trouble code there are 100s of codes ---most auto stores offer free scanning the code will help pinpoint ur problem

Posted on Jan 20, 2011

tunde007
  • 2382 Answers

SOURCE: drivers side turn signal does

Hi, usually if the signal is blinking fast, it means there is a problem with the circuit. Usually this is caused by a lightbulb going out. They've engineered the cars to blink fast to let you know that the bulb might be out, since you usually can't see your own turn signals. I'd try replacing the rear taillight bulb first to see if that fixes the problem.
As for the signal that does not shut off, i would start at the bulbs and access them and check there connectors for melting. This unit is known for this,unplug the bulb and check its connectors, check all four Also the ground for the r/f turn signal and headlamp is right by the headlamp, its a wire that is bolted to the body Thats about all I can think of right now, there is no known problems like this through Ford

Posted on Mar 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a rear tail light bulb in a 2012 Ford Fusion


guess I would look inside the trunk and behind the liners .it is not rocket science .

Dec 21, 2016 | Ford Cars & Trucks

1 Answer

Left rear turn signal had blown bulb. No power going to socket or new bulb. What do I ck next? Thanks!


Use the test light and probe back a couple inches from the plug. Check for power there. Also put the test light on the B+ side of the battery and check the ground wire.

Apr 03, 2016 | 2012 Ford Fusion S Sedan 2.5L 4-cyl....

1 Answer

How to remove and replace passenger side mirror on a 2014 ford fusion


Replace Your Car Passenger Side Mirror - How To - DIY ...

? 3:46
https://www.youtube.com/watch?v=77lBQ_CRqdo
Apr 10, 2012 - Uploaded by GregHint
See how even a novice can repair a passenger mirror on a FordEscape. ... Replace Your Car Passenger Side Mirror - How To - DIY .... Replace 2003-2008 Toyota Corolla Side Mirror, How to Change Install 2004 2005 2006
About 22,000 results (0.61 seconds) Search ResultsHow-To: Replace Ford Fusion side mirror (HD) - YouTube? 7:27https://www.youtube.com/watch?v=iGHeXUbvvJsMay 7, 2014 - Uploaded by Derrick HardingFord Fusion SEL 3.0 Liter V6 How to fix broken side mirrorIncludes: ... Published on May 7, 2014 ..... Great instructions - just replaced the driver's side mirror on my 2007 Fusion following your instructions. ... Front brake pad replacement 2006 - 2012 Ford Fusion Lincoln Mazda Pads Rotor Install Remove ...

Jan 08, 2016 | Ford Cars & Trucks

1 Answer

My trunk light on dash says the trunk is ajar even though it is closed


There should be a switch at the trunk hinges or lid either wires are faulty or switch

Hope this helps :-)

Oct 26, 2015 | 2012 Ford Fusion S Sedan 2.5L 4-cyl....

1 Answer

I have a 2012 Ford Fusion SE and the shifter is stuck in park and I have no brake lights. I already have had the brake switch replaced twice within 3 months.


if the shifter is on the floor there should be slot that a key will go in and manuly release it,neutral before starting check fuses electical release

Mar 18, 2015 | 2012 Ford Fusion SE

1 Answer

2012 Ford Fusion Vanity light, dome, light, trunk light, and reading light not working. But when I open my car door the dome and reading mid rear light comes on but not by the switches. Do you think if I...


I would consult a repair shop or buy the service manual and look through the wiring diagrams. If you can't read wiring diagrams and have no testing equipment then it is best left to a repair facility.

Jan 17, 2014 | 2012 Ford Fusion S Sedan 2.5L 4-cyl....

1 Answer

Trunk light switch


Im having problems with my 2012 ford fusion trunk light, dome light, vanity lights and reading light will not come on but my reading light and the middle rear dome light will only come on when the door is open and when I use the dimmer switch. Do you think if i unhook the battery for a few minutes will it somehow reset them to work again.

Jan 04, 2014 | Dodge Neon Cars & Trucks

1 Answer

2012 ford fusion 2.5 misfiring but no dtc's


You have a mechanical problem,There is no sensor that can do this, Running out of fuel can do this,A cam and crank that is not synchronized can do this,Try this remove the variable timing actuator,clean out the port with brake cleaner,install and restart,

Feb 26, 2013 | 2012 Ford Fusion S Sedan 2.5L 4-cyl....

1 Answer

Power steering assist fault light stays illuminated on a 2012 ford fusion


This had been an intermittent problem on my 2012 Fusion, but the other day it became permanent. I have since discovered that the Fusion has electronic power steering, that this problem is caused by a bad module, and that the fix involves replacing the entire rack and pinion system.

Mar 20, 2012 | 2012 Ford Fusion S Sedan 2.5L 4-cyl....

Not finding what you are looking for?
2012 Ford Fusion Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...