Question about 2012 Toyota Camry

1 Answer

Security Lock Flashing. Even when I lock with key it stops flashing but stays on. What is solution?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 509 Answers

You are going to have to use the Key fob or remote alarm fob to go threw a set of lock and unlock procedure. Crank the car shut it off remove the key outside the vehicle at a distance of at least 30ft then lock the car, wait till it arms and the dash light blinks once this is active you want to unlock the car with the remote. If this one does not work do the same thing except when you unlock it do so with the key to re open after arming security.Also make sure you have both fobs or all remote fobs with you when you do this lock with one unlock with the other then vise, versa ok if you need any further help just ask also make sure your battery is fully charged and the terminals are clean this will affect a security system bad a low battery or low battery in the FOB's.

Posted on Apr 23, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 Trailblazer security light on, will not crank, replaced steering column


Did you use the original key and lock cylinder? They are coded for the security system.

Dec 31, 2016 | 2002 Chevrolet TrailBlazer

1 Answer

Resetting security system


Check door and hood latches to make sure they are actually closing properly. It could be a faulty security module, but more likely it is a broken plastic piece that clips onto the back of a door lock.

Also, if you want to test each security sensor before ripping everything apart, you can put the key in each lock and turn it to about 2:00. The light should go out completely but then begin flashing again when you remove the key. If you can get the light to go out while doing this on each door and hatch lock, then you probably have a bad hood sensor.
Otherwise, the lock that does not turn the light off is the one with the bad sensor. Also found that the alarm will not work if the security light is flashing.

Mar 25, 2014 | Nissan Cars & Trucks

1 Answer

Lights flash when battery cables are connected


Disconnecting and reconnecting the battery cables sets up the security alarm system which is part of the flashing lights. To stop the flashing, insert your key into the drivers side door lock and and turn to the unlock position. This will also stop any unwanted security alarms.

Nov 30, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Installed ignition on 2003 sunfire, how do i reset security system


did you reuse the same pass lock sensor and key lock tumbler? if so the security system shouldn't have to be reset. if you replaced either lock cylinder or pass lock sensor then you have to turn the key to the start position and then to the run position and leave the key on for about ten minutes and wait for the security light to stop flashing. once the light stops flashing do the same process again. it may take up to three times to get the key code encrypted into the BCM. on the third time after the light stops flashing the car should start, if not then you may have another problem.

May 23, 2012 | 2003 Pontiac Sunfire

1 Answer

2003 alero steering won't lock and nothing happens when you turn the key in the ignition


If the security light keeps flashing,you might as well do a reset.
Be sure to turn off all the accesories including the radio before you start the process.
Insert the key to the ignition switch and turn the key to ON position without starting the car.
leave it ON until the flashing light (security) stops.It will take approximately 15 to 20 minutes.
As soon the flashing stop,turn the key to OFF
position and start the cart.
Hope this help.

Jul 23, 2011 | 2003 Oldsmobile Alero

2 Answers

I drove the car to my mothers yesterday, went to my dads got there just finr. We went to leave and the car won't start turn over nothing. The security light is flashing. My dad could get it to start from...


you need to get a new ign. lock cylinder and chip key. Or you can get a lock cylinder and copy your old key with a regular key no chip. Take new cylinder, put old chip key in it. Plug into harness at the bottom of steering column just behind the dash, fine orange wire from existing one in the column. Hide lock cylinder under dash and start car with copy of old key.

Dec 26, 2010 | 1991 Buick Park Avenue

1 Answer

Security alarm stays on and vehicle wont start


Sure the door lock is bad maybe. with the fuses in and the doors clsed try the other locks some jeeps only reset with the hatch lock as all the others are worn out or don't detect tha t the door is closed

Dec 05, 2009 | 1993 Jeep Grand Cherokee

6 Answers

Jeep alarm will not turn off


The ignition security on/off is located at the trunk lock. unlock and lock rear gate and the alarm will turn off. My jeep sat in my drive for a month before a jeep tech told me this. It still triggers the security sometimes when I unlock the passenger door with the key and I go straight to the rear gate lock and it shuts off instantly.

Jun 27, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
2012 Toyota Camry Logo

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...