Question about Cars & Trucks

1 Answer

What's your question?can i have the diagram of the mpv ignition coil pack

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 296 Answers

Felix. I could help if I had year, make, model.

Posted on Apr 22, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76673 Answers

SOURCE: how to replace ignition coil mazda mpv 2004

I show $47 for each coil at rockauto.com here is the part #
STANDARD MOTOR PRODUCTS Part # UF406
here is a picture, is this the coil?
0d72734.jpg

Posted on Feb 14, 2009

  • 1 Answer

SOURCE: would like information on a

REMOVAL AND REFIT CRANK SHAFT SENSOR PROBLEM. NEED THE SOLUTION TO SORT THIS OUT FOR HYUNDAI SONATA 1998 MODEL.

CAN SOME ONE HELP ASAP.
THANKS

Posted on Feb 26, 2009

roniecon
  • 6826 Answers

SOURCE: diagrams for coil pack

I hope it is a v6 engine27a321d.jpg

Posted on Feb 21, 2010

dttech
  • 4803 Answers

SOURCE: I have 1991 mpv v6

Several things, actually. There could be no battery power at the distributor due to a blown fuse or a bad main relay. You could have a bad distributor cap, bad rotor, bad ignition cable between the coil and the distributor cap, a bad Engine Control Unit, a bad distributor pick-up coil, or any of the wiring in-between. (see schematic)


dttech_164.gif

Posted on Aug 16, 2011

  • 10 Answers

SOURCE: coil pack diagrams 2000 ford taurus

Yes there is, or at least their should be. I just got my Taurus so I don't know the tips and tricks and pitfalls of Ford cars, but this is how I'd test my ignition coil on both my 86 Fiero GT, 87 Fiero GT, 96 Saturn SC2, and my 93 Geo Storm.

When my previous cars wouldn't start, one thing I'd do was to pull the wire that comes from the DistCap (DC) to the IgnCoil (IC). You'll want to leave the the DC side of the wire plugged to the DC and the other end just needs to be temporarily out of your way.

Ok, in a perfect world, when you try starting the car the (now exposed) IC post should energize and send an electrical charge down the wire you just unhooked to the DC's center post which charges each individual plug in order. With the wire off of the IC, when the car is being cranked, your IC is good if you see the IC Post start sparking (kind of a tesla or plasma ball effect). In summary, if you see sparks, the Ignition coil is good. In the previous example, if the coil showed that it could get and send spark, the next culprit was usually the Ignition Control Module, but that might not apply to your case. I did have 2 plug wires backwards once and it stuttered really bad until I went back and double-checked the firing order diagram for the DistCap-->SparkPlugWires-->SparkPlugs.

Hope it helps.

I think Advanced or Autozone will test ignition coils and Ignition Control Modules for free ().




Mercedes Parts.

Posted on May 25, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 mazda mpv will not start in cold and/or wet weather


Did you change the ignition cables as well? Ignition cables are made of carbon fiber conductors. They may look ok from the outside, but as they get older the carbon fibers get brittle and minute cracks form in the silicone jackets that lets moisture in. How many miles to you have on it? You may be due for new spark plugs also.

Dec 02, 2014 | 2001 Mazda MPV

Tip

Misfiring Ford Escort ignition fault finding


1999 Ford Escort firing order and ignition troubleshooting.<br /><span>Refer to the diagram. Cylinders are connected as shown on the diagram in blue. 1 goes to cylinder 1(sparkplug furthest from coil pack), 2 to 2, 3 to 3 and 4 to 4(closets to coil pack).<br />To test the coil pack use a digital volt meter. Measure resistance between coil towers for coil 1(marked 1 in red on diagram) Value should be between 12000 and 14500 ohm. Do the same for coil towers 2. <br />Measure resistance between I and C1. If the measurement is more than 5 ohm the coil is defective. Do the same for I to C2.<br />Measuring voltage at I(Ignition start/run) to ground should be 10V.</span><br /><span>I is connected to the 15A engine fuse. The radio interference capacitor is connected between this line and earth at the coil. Disconnect it to see if it cures the misfire.<br />C1 and C2 connect to the powertrain control module. The module earths each line to make its respective coil fire.<br />Bear in mind that aftermarket coil wires may cause problems with misfiring</span> so use OEM parts where possible.<br /><img src="suzman_6.JPG" /><br />

on Nov 17, 2010 | Ford Escort Cars & Trucks

2 Answers

Need a cylinder wiring diagram for 92 buick park avenue


Buick Park Avenue has Type I coil packs, three twin tower ignition coils are combined into a single coil pack unit, and Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack.

zjlimited_349.gif

What is yours?

May 05, 2011 | Buick Park Avenue Cars & Trucks

2 Answers

Diagram for 3.8 firing order


1987 Pontiac Bonneville 3.8 liter V-6 VIN "3"

Identifying Ignition Types I and II

On Type I coil packs, three twin tower ignition coils are combined into a single coil pack unit.

zjlimited_324.gif

On Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack.

With Type I Ignition

zjlimited_325.gif

With Type II Ignition

zjlimited_326.gif


Hope this helps.

Mar 24, 2011 | 1987 Pontiac Bonneville

1 Answer

FIRING ORDER DIAGRAM FOR 1988 OLDSMOBILE 98


1988 Oldsmobile Ninety-Eight 3.8 liter V-6 VIN "3"
Identifying Ignition Types I and II

On Type I coil packs, three twin tower ignition coils are combined into a single coil pack unit.

05f233b.gif

On Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack.

With Type I Ignition

45fe561.gif


With Type II Ignition

25a6a1a.gif

Hope helps.

Aug 30, 2010 | 1985 Oldsmobile 98

1 Answer

Looking for car ignition coil mazda mpv 2004


this car doesn't have just one coil, it has a separate coil for each spark plug so u have six coils, the coil is plugged right onto the top of the plug in a deep well this is called a "coil over" ignition system, see picture of coil below

c065c1d.jpg

Aug 03, 2010 | 2004 Mazda MPV

2 Answers

Can somebody show or tell me the firing order for 1988 buick park ave.and a wiring diagram for the ignition mod.


1988 Buick Electra Park Avenue 3.8 liter V-6 VIN "3"
Identifying Ignition Types I and II


On Type I coil packs, three twin tower ignition coils are combined into a single coil pack unit

5537d00.gif.

On Type II coil packs, the coils can be replaced separatelyand the ignition wires are all on the same side of the coil pack.
With Type I Ignition


af1eddd.gif


With Type II Ignition

d636ed4.gif

or...

7e32bcd.gif



Good luck.

Oct 05, 2009 | 1989 Buick Park Avenue

1 Answer

Is the coil pack what the spark plug wires go into on 2000 mpv


Yes....one end of the plug goes to the spark plug in the head and the other end plugs into the coil pack.

Jun 28, 2009 | 2000 Mazda MPV

2 Answers

Can't Find the spark plugs


pull of the engine covers if so equipped, the plugs each have there own ignition coil, they are held in position by a single retainer, remove the coils to access the plugs. see photo of coil

ad6fa2d.jpg

May 19, 2009 | 2003 Mazda MPV

1 Answer

Will not start


check the coil pack and the crank sensor and the timing cause you could have a bad timing belt also go to your local library and there you can get pictures and diagrams showing you detailed instructions

Mar 08, 2009 | 2000 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...