Question about 1996 Mercury Sable

1 Answer

My car goes in reverse and forward. But after a little while it wont move at all goes in gears just revs up. Fluids are all filled. Someone please help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mercury Master
  • 42,984 Answers

Your torque converter has failed you call a transmission repair shop

Posted on Apr 22, 2015

Testimonial: "It couldnt be anything else censor or anything"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ford telstar tx5 V6 idles correctly and revs clean when not in gear. When driving there are deadspots in the throttle


there is an idea that when it runs good in reverse but not in forward gears , there is a problem in bad engine mounts that is allowing the wiring to make a bad circuit for the electronics
could be a loose /bad connection for the cam/ crank sensors, injector operation or ignition control module
in forward gear , the engine reacts to the torque application and that would pull on the harness
when in reverse the reaction is opposite and not affect the wires

Jul 01, 2016 | Ford Cars & Trucks

2 Answers

Why wont my toyota camry 3.0L v6 move in reverse


you need to check your reverse gear switch for cleaness,then clean it ,see how it goes

Jul 21, 2014 | 1996 Toyota Camry

1 Answer

Freelander starts,revs well but doesnt move off sharply,what may be the cause?


Check transmission fill and differential fills for proper levels. Also, if temperature is cold, allow vehicle to warm up with transmission in forward gear for about ten seconds before moving to allow fluids to move freely along channels in transmission. In extremely cold climates, some change may be needed in viscosity of fluids. See your dealer for information on this. You didn't indicate how cold it is where you are driving, but low fluid levels, lack of adequate lubrication or severe cold can be a cause of this problem.

Dec 02, 2013 | Land Rover Cars & Trucks

1 Answer

My 2001 chrysler neon wont reverse and sometimes wont go forward


I had this problem and it was the transmission was going bad. I am afraid you will need a transmission rebuild

Jun 12, 2017 | Chrysler Cars & Trucks

1 Answer

Gearbox only goes forward in all gears on automatic gearbox


Sounds like transmission is failing and may need to be replaced or atleast have it looked at by mechanic,,,this would be my suggestion and good luck and if need help in future fill free to contact me...

Aug 16, 2012 | Cars & Trucks

1 Answer

1990 VW cabrio wont reverse. Seems in gear but only goes forward


left and push the shifter into the floor like stabbing down ten it will go left a little more and push forward and you will be on your way in good ol R

Jul 25, 2009 | 1990 Volkswagen Cabriolet

1 Answer

Car does not drive forward but works in reverse


Sad to say but your automatic transmission has bit the dust.

Jul 24, 2009 | 2004 Chevrolet Cavalier

1 Answer

94 tauras AT once warmed up trans will drop out gear at a stop


This is a common problem. You have a cracked forward clutch piston. Ford made this part out of aluminum. The replacements are steel. But you have to disassemble the transmission to install it. ( I know you said Rev too, In the AXODE trans, the forward clutch is on in 1st and reverse)

Apr 08, 2009 | 2000 Ford Taurus

1 Answer

Transmission mystery


It moves forward in neutral? Can you get it in to park?

Mar 20, 2009 | 1989 Ford Econoline

2 Answers

REVERSING PROBLEM


check the transmission fluid and make sure it isnt low.

Jul 16, 2008 | 1987 Toyota Cressida

Not finding what you are looking for?
1996 Mercury Sable Logo

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...