Question about 1993 Ford F350

1 Answer

93 f350 diesel replaced fuel pump now lost power to the starter

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 229 Answers

Look back around the pump and see if any disconnections took place.

Posted on Apr 22, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: where is the fuel pump located on the 1988 ford econoline F350

on the frame or the tank

Posted on Feb 03, 2009

  • 35 Answers

SOURCE: 1994 F350 WILL NOT START

you simply have to bleed the fuel lines...

to do that just loose up the line and have someone rotate the engine until you have some fuel going there...

make sure that your fuel filter is full because you will do this for nothing...

it should only take like 5 minutes of bleeding...

Posted on Apr 29, 2009

DIESELMUDDER
  • 2760 Answers

SOURCE: replace fuel pump on 03 Ford F350 diesel

simple : obtain replacement pump from parts provider (no used stuff)

Now help me out here: thats the year they were bolted to the pass side front of engine
and not inside the tank right? (better go look to see for sure)

using a tube wrench unscrew the fuel lines (i use large wire nuts to temp block off fuel leakage)

with a 12 mm wrench undo the two side bolts holding the pump to block

wiggle pump it should come straight off

clean mounting place on block with solvent let dry

silicone back (or use gasket that comes with pump ) of pump

apply pump to block (depending on where crank stopped you may have some tension on arm you will have to overcome to get flange to meet block )

use locktite (blue)or simmiliar thread lock on bolts retighten firmly but not hang up the dog tight

use light grease or vasolene on tube connections don't try to tighten dry

Now the fun part your diesel now has air in the fuel system

there are two ways to remove this ( hard and harder)
your choice here are both methods

loosten the fuel supply line for #8 injector ( I did not say remove) 1 full turn ought to be enough

crank engine 30 seconds only
wait 5 minutes for starter to cool down
crank engine 30 sec again
did it start but runs rough while it's still running tighten #8 injector (caution fuel under high pressure)
engine smooth out good your lucky
engine did not start yet
wait 5 minutes
crank engine 30 sec again
start yet
if so tighten #8 injector up

Now here's something I've done to my diesel to make this much less a hasstle

trace fuel line as it comes up from pump
obtain a small low pressure electric fuel pump and a two short pieces of fuel line
and a few clamps

use tube cutter and cut fuel line just before it bends to go in filter
deburr edges
slide tube and clamps over pipe (both sides)
insert pump observe flow arrrow towards filter

the wires of pump can be stretched over to #1 battery terminals

now any time you change a filter or open your fuel system for any reason
all you need do is connect pump to battery
open sharader valve on top of filter for a few min
and start truck as normal
then disconnect wires and stow away for another day

Posted on Jul 08, 2009

  • 2418 Answers

SOURCE: 2004 Ford F350 diesel, changed fuel filters hard starting

Pull the filters and ck for plastic or o-ring in wrong place. Something is up in the filter. 

Posted on Jul 28, 2009

  • 496 Answers

SOURCE: How do I change a fuel pump on my 1995 Ford F350

Hi, I hope this helps...

1994-96 Engines
See Figures 3 and 4



0900c15280262dd1.jpg Fig. Fig. 3: Details of the fuel pump assembly-1994-96 diesel engine



0900c15280262dd2.jpg Fig. Fig. 4: View of the fuel pump-1994-96 diesel engine

  1. Remove the turbocharger assembly.
  2. Remove the fuel line banjo bolt at the pump.
  3. Remove the fuel line fittings at the rear of the cylinder heads.
  4. Remove the fuel lines assembly.
  5. Loosen the two hose clamps at the fuel pump fittings.
  6. Disconnect the water drain hose at the fuel filter.
  7. Disconnect the filter and position it forward.
  8. Remove the fuel pump retaining bolts, then lift the pump out of the crankcase bore.
  9. Remove the fuel pump tappet from the crankcase bore.

To install:
  1. Rotate the engine so the fuel pump eccentric is on the base circle.
  2. Install the fuel pump tappet in the base of the fuel pump.
  3. Replace the O-ring on the fuel pump base.
  4. Install the fuel pump and bolt it in place.
  5. Install the fuel filter and connect the water drain hose.
  6. Connect the two fuel hoses at the front of the fuel pump.
  7. Tighten the fuel line clamps and install the fuel filter retaining bolts.
  8. Install the fuel line assembly and new seal rings at the rear of the pump.
  9. Loosely install the fuel line fittings at the rear of the cylinder heads.
  10. Install the fuel line banjo fitting at the pump. Tighten the fitting to 40 ft. lbs. (54 Nm).
  11. Tighten the fuel line fittings.
  12. Install the turbocharger assembly.

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Won't start but cranks has 300k miles. Check fuel pump working, replace glow plugs, checked fuses and relays, fuel pump won't come on but works hooked it direct to battery, wait to start light does not...


If you can't pull the codes from the pcm it has either died or lost it's ground assuming it has power. I would try to get a wiring diagram and check both the power and the ground for the computer itself, because it is what turns on the pump and the wait to start light.

Feb 25, 2011 | 1999 Ford F350 Regular Cab

1 Answer

Ford F350 Diesel was running for past 3 hours and now stalled


check your filters and fuel filter.. if they need to be replaced then do so.. then check your fuel pump.. a mechanic can tell you if you need to replace that or not... and check your starter, alternator, and battery cables

Feb 26, 2010 | 2005 Ford F 350 Super Duty

3 Answers

Ford f350 diesel truck 30 amp fuse keeps blowing.


It is the fuel heater, All you have to do is unplug it.a4c0d50.gif

Dec 27, 2009 | 2000 Ford F350 Super Duty Super Cab

1 Answer

2001 f350 diesel craks but wont start


SOUND LIKE THE ELECTRIC LOW PRESSURE FUEL PUMP CHECK FUSE TO SEE IF PUMP GETTING POWER. IF NOT REPLACE FUSE AND CHECK THE WIRE TO PUMP.IF PUMP IS GETTING POWER..REPLACE FUEL FILTER FIRST.IF IT DONT HELP.COULD BE THE ELECTRIC LOW PRESSURE PUMP. FAULTY. IT PUMPS DIESEL FUEL IT INTO INJECTION PUMP TO BE PRESSURIZED TIMED AND INJECT.SEE IF LOW PRESSURE PUMP DONT WORK THE WHOLE ENGINE WONT RUN.THE INJECTION PUMP NEED FUEL FROM LOW PRESSURE ELECTRIC PUMP TO RUN ENGINE.

Aug 11, 2009 | 2001 Ford F350 Super Duty SuperCab

1 Answer

1996 f350 dw 7.3 diesel no power will idea but have a silght miss


check the fuel pump and injectors, pump maybe retarded and injector maybe plugged . Take it to a diesel mechanic shouldn't cost much for a diagnostic

Jul 25, 2009 | 1996 Ford F350 Crew Cab

2 Answers

1999 F350 Super Duty Crew Cab Diesel loss of power


the fuel filter is along the frame on the inside but i would also suggest changing out the in tank fuel pump.

Jan 13, 2009 | 1999 Ford F350 Regular Cab

1 Answer

2004 F-350 6.0


Check your fuel pump pressure, fuel pump may be going out

Sep 24, 2008 | 2004 Ford F350

2 Answers

2002 f350 wont start


i had to replace my oil pressure regulator sensor it contols the oil pressure required to have the injectors open and spit fuel, if you replaced it and still no start replace the the cam position sensor

Jul 20, 2008 | 2002 Ford F350 Super Duty DRW Reg. Cab

Not finding what you are looking for?
1993 Ford F350 Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...