Question about 1999 Kia Sportage

1 Answer

Where is the rear hatch sensor on a 1999 kia sportage

The open rear hatch light stays on,how do I get it to turn off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 487 Answers

Sounds like the door switch has shorted out in the on position. Try replacing it.

Posted on May 19, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 25 Answers

SOURCE: A 1999 Kia Sportage. Heater core leaking.

tie both hoses together

Posted on Jun 25, 2009

c17hydro
  • 2984 Answers

SOURCE: 1999 kia sportage timing marks

dfd3ea1.gif Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks
9f1c7ef.gif

  1. Align marks on camshaft pulleys with alignment marks on seal plate.
  2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
  3. Loosen tensioner lock bolt.
  4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
  5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
  6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
  7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
  8. NOTE: Replace tensioner spring if timing belt deflection is excessive.
Timing Belt Installation


eb770f2.gif
  1. Install lower timing belt cover.
  2. Install upper timing belt cover.
  3. Install power steering drive belt and adjust belt tension.
  4. Install fan pulley.
  5. Install generator drive belt and adjust belt tension.
  6. Install A/C drive belt and adjust belt tension.
  7. Install splash guard.
  8. Install fan and fan shroud.
  9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
  10. Install fan shroud mounting bolts.
  11. Install fresh air duct.
  12. Connect hose to resonance chamber.
  13. Connect battery negative cable.

Posted on Jul 26, 2009

  • 36 Answers

SOURCE: where is crankshaft sensor on 99 kia sportage?

The crankshaft pos. sensor is located on the left "driver" side of the engine on the bellhousing and is retained by a single 10mm bolt.The sensor may be tight,be sure to twist as you pull so that it doesnt break off in the bottom end.

Posted on Jul 26, 2009

  • 8 Answers

SOURCE: Hold light stays on, 2002 kia sportage

are u sure the button isn't pushed on the side of shifter...If its flashing i am not sure. when i go out 4x4ing mine flashes then a few days later it goes out....

Posted on Jun 08, 2010

roniecon
  • 6826 Answers

SOURCE: location of crankshaft position sensor on 1999 kia

The crankshaft sensor is in the bell housing,near the flywheel.If this was helpful,please rate,thank you

Posted on Jun 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 Kia Sportage rear tailgate button release won't open hatch.


it sounds like it disconnected from the rod.Need to remove the hatch panel,should be easy fix if you are confident. good luck Jeff

Jun 20, 2017 | Kia Cars & Trucks

1 Answer

Can't open hatch 08 kia sportage


I'd call a Kia service department with that question. If they won't answer for free, phone another one.

Jun 18, 2017 | Kia Cars & Trucks

1 Answer

How do you open the back door (no manual)


Rear hatch is locked or unlocked with a key. (if equipped) • To open the rear hatch, insert the key into the lock, turn it to the unlock position and pull up the rear hatch by pressing the handle (DOOR). You can also lock/unlock the latch (but not release it) with the central door lock system. • If unlocked, the rear hatch can be opened by pressing the handle (DOOR) and pulling the hatch up. • To close the rear hatch, lower and push down the rear hatch firmly. Make sure that the rear hatch is securely latched.

Apr 12, 2016 | 2009 Kia Sportage

1 Answer

How can I remove the rear latch from the hatch door?


Solution: you need the valet key and there should be a way to open it from the inside -jeff ps please rate , i have had the same problem many times with my mercury villager. one thing i have found to work on more than one occasion is while it is closed, push the back hatch as if you were shutting it. hit the lock button ( either on remote or inside of van ). then push the handle out on the hatch to make sure it will catch all the way. unlock the doors and pull on the handle, the hatch should open with no problem. , if it is electronic check the fuses first. if not electric spray with WD-40 in key hole and around button

Feb 07, 2016 | 2008 Kia Sportage

1 Answer

Where to find fuse for relation of the reverse parking sensors in kia sedona ls 07plate


kia sportage parking sensor - ABMforum.com

abmforum.com/kia-sportage-parking-sensor.html
kia sportage parking sensor installing rear parking sensors fitting rear parking sensor strip ... the pre-drill hole on 07 sportage 2007 kia sportage lx navigation wiringparking sensors. ... I cannot see any fuse which may relate to them. ... with their rear parking sensors Even if all is clear behind I now get a continuous beep and ...

Urgent help needed - towbar electrics - Kia Forum

www.kia-forums.com/kia.../71610-urgent-help-needed-towbar-electrics....

Aug 28, 2011 - 10 posts - ‎3 authors
I'm in the middle of fitting a genuine Kia towbar (made by Witter) to my SW. ... Need help again - Does anyone know the location of the PDC Control unit (parking sensors)? ... Drives: Kia Ceed SW 1.6 MT LX A8 ... with the loom which connects to the fuse box does not seem to attach to the rear lighting loom.

[PDF]2007 Sedona Owner's Manual - Kia Canada


Jan 30, 2016 | Kia Cars & Trucks

1 Answer

How do we install the 02 sensors in the 1999 kia sportage?


when you find the O2 sensor that you are replacing disconnect the electrical plug then using a 7/8" wrench placed around the sensor base turn the sensor counter clockwise looking at it from the top of the sensor. sometimes you have to heat the exhaust pipe around the sensor were it threads in this will help loosen the sensor. keep in mind that sometimes the threads are pulled out/stripped and you will have to run a cleaning tap to clean the threads and you install the sensor in the same place.

Sep 16, 2014 | 1999 Kia Sportage

1 Answer

Light for hatch stays on but its a 2 door soft top


Check the tailgate. It should have a switch on it that warns if the tailgate/hatch is ajar.

Mar 14, 2014 | 2002 Kia Sportage

1 Answer

My 1999 Kia Sportage won't start. I put a new fuel pump in replaced the car battery . Need help please...


Im dealing with a similar situation. But have found that I have no spark. By opening the end of the air intake and giving a little squirt of starter fluid and no start. Opened access to FP and pulled a hose. No fuel. So no fuel no spark. reading lots and lots of forums I have come to the conclusion it is either the Cam or the Crank sensor. The crank sensor is easier to get to and cheaper. I am going to check that first.

Apr 06, 2013 | 1999 Kia Sportage

4 Answers

HOLD keeps coming on in my 99 kia sportage what does that mean


Look on the shifter lever,just bellow the push button. There is another push button there. That's the one you press or depress to keep the transmission on 3rd. gear. Just press it again and the hold light should come off.

Feb 09, 2010 | 1999 Kia Sportage

1 Answer

2000 Kia sportage rear hatch won't open with key - any suggestions?


you need the valet key and there should be a way to open it from the inside -jeff ps please rate

Aug 12, 2008 | 2000 Kia Sportage

Not finding what you are looking for?
1999 Kia Sportage Logo

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...