Question about 2006 Mazda 6

1 Answer

I have a 2006 Mazda 6 with the 3.0 V6 I am experiencing something during acceleration as well as driving it will jerk it only happens occasionally but can happen at anytime, today in cruise control and it started doing this jumping thing again. i dont believe its the tranny. Has anyone else with the Mazda 6 experienced this or any mechanic know these symptoms

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

Typically a sudden hard miss in engine is spark plug coils. Stop by an Autozone and see if code comes up telling you which cylinder is cutting out, then replace coil.
CERACOAT-NANOTECH.com

Posted on Apr 21, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mx5turbo92
  • 545 Answers

SOURCE: 2001 Mazda Tribute jerks and misses

Replace the spark plugs and ignition wires,timing & vacuum leak

Posted on Jun 03, 2009

  • 366 Answers

SOURCE: Acceleration; jerking....FUEL FILTER?

fuel filter is located on firewall near brake master cylinder on drivers side.

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: car jerks when accelerating 1998 mazda millenia v-6

Could be a T C S sensor that needs replacement.

Posted on Jul 03, 2009

roniecon
  • 6826 Answers

SOURCE: My Mazda 6 2006 is not starting,the gages is doing

starter wont turn engine over? if so bad battery or bad battery connections,check alternator out put when u get it running if it is the battery cause it could have started there

Posted on Jul 06, 2009

Hrnsly
  • 154 Answers

SOURCE: 2002 Mazda Tribute V6 difficult to start.

IT SOUNDS LIKE THE IAC VALE OR IDLE AIR CONTROL VALVE IS BAD, WHAT YOU CAN DO IS TAP ON THE VALVE. IT IS LOCATED ON THE INTAKE RIGHT BEHIND THE THROTTLE BODY, JUST TAP ON THE SILVER PART WITH THE BACK OF A SCREW DRIVER A COUPLE OF TIMES. THIS SHOULD UNSTICK THE VALVE AND YOUR TRIBUTE SHOULD RUN. THEN IT IS JUST A MATTER OF REPLACING THE VALVE. YOU CAN GET THEM FROM ANY AUTO PARTS HOUSE.

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 mazda mpv jerks to the left then straightens back out. This usually happens when I have to accelerate really fast or right about the time it shifts into the last gear.


Mike, this may be because the left wheel is the dominate drive axle (left axle locks up and pulls hard, while right side slips) when under power. Vehicles that do not have possie drive differentials have this pulling characteristic.

Apr 01, 2016 | Mazda Cars & Trucks

1 Answer

Why car wont pick up speed when i get to 40mph then jerks and pick up speed


Does it down shift appropriately when accelerating? Normally when you stomp on the gas while in a high gear (travelling at 40mph), the transmission will downshift to a lower gear giving the car much more torque. This can cause the car to jolt or jerk forward and accelerate suddenly.



If this is way off base and you\'re experiencing something else, please let me know

Jul 25, 2014 | 2006 Buick Lucerne

1 Answer

Firing order for a 2006 mazda 6 v6 3.0 L


1-2-3 back bank
4-5-6 front bank
front of vehicle

1,4,2,5,3,6 firing order.

Jul 10, 2014 | 2006 Mazda 6

1 Answer

Looking for the cylinder layout for a 2006 Mazda 6, 3.0 liter V6 engine, also the engine code is an S


1,2,3 are across the back under the intake and4,5,6 are across the front

Jul 10, 2014 | 2000 Mazda MPV

1 Answer

Need the firing order for my mazda 6


contact local sales office ---for mazda

Jul 10, 2014 | 2006 Mazda 6

2 Answers

I have a 2004 Mazda 6s, 6cyl. w/ almost 90k miles shuttering


have the fault codes read and use a quality injector cleaner in the fuel
it could be low fuel pressure , injector problems or accelerator position sensor related

Apr 25, 2017 | 2004 Mazda 6

1 Answer

Bucking 2006 mazda 6


Did you check the transmission oil?

Feb 03, 2013 | 2006 Mazda 6

1 Answer

I have a mazda 6 sports wagon 2005 that has started slipping out of gear while driving. It stayed in third gear until I stopped and shut it off for a few minutes. The engine light came on. When I star


Check Mazda Service Bulletin 05-016/06.

2005-2006 Mazda6 3.0L vehicles produced before Feb 24, 2006 equipped with a 6-speed AW6A-EL automatic transaxle.

Slippage or shock when pressing accelerator fully from 4/5/6.

My car is experiencing this now... the"solution" according to Mazda is to replace a transmission that they knew bad.

Aug 13, 2012 | 2006 Mazda 6

3 Answers

Car jerks when accelerating 1998 mazda millenia v-6


fuel filter would be the first thing to check, and fuel pressure.

May 18, 2009 | 1998 Mazda Millenia

Not finding what you are looking for?
2006 Mazda 6 Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...