Question about Subaru Cars & Trucks
Replaced the fuel pump, fuel filter, fuel pump relay, checked fuses, wont start. also seems to have electrical issues
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You are looking for the constant control relay module- ( CCRM ) see below. The pump will be located inside the fuel tank.Most of the time , its the pump and not the relay but, it wouldn't hurt to check the relay out. Teh relay is housed in the CCRM. Its located behind the engine coolant reservoir.
Posted on Mar 20, 2009
SOURCE: 2003 GMC Yukon - fuel pump
Check your ECM fuse. There should be 2 fuses for your ECM. It's the ECM that controls the function of the fuel pump. Good luck friend and it's also common for the wire harness from the frame to the fuel pump to go bad due to corrosion from the bad weather we get in the winter and rainy spring and fall.
Posted on Sep 04, 2009
You start by disconnecting the battery. Remove the fuel-pump, and put back the new one. Use some rag to catch up excess fuel. Safety: be very aware of the wiring conections.!
Posted on Nov 12, 2009
Did you check the fuel inertia switch in the passenger side kick panel ?
The fuel pump is powered :
the fuse to the fuel pump relay.
The fuel pump relay to the fuel inertia switch
The fuel inertia switch to the fuel pump itself.
At the fuel inertia switch in the kick panel, power from the relay is the Dark Green w/ Yellow stripe wire and the pink w/ black stripe wire is the power. from the fuel inertia switch to the fuel pump.
If you jumper the fuel pump relay, you should hear it run. If not pull the fuel pump relay, and check the pins in the relay socket, pin 30 should be the power from the fuse.
If you have power at pin #30, jumper the relay socket as shown with the red line above, and check the dark green w/ yellow stripe wire at the fuel inertia switch for power.
Press the button on the top of the fuel inertia switch, and check for power leaving the fuel inertia switch on the pink w/ black stripe wire.
This is tests good, check for power at the fuel pump, same pink w/ black stripe wire.
Fuel inertia switch info is in the owners manual, If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
Posted on Jan 03, 2010
Tips for a great answer:
Apr 21, 2015 | 2000 Subaru Legacy
Jul 27, 2011 | 1991 Subaru Legacy
Feb 20, 2011 | 1998 Subaru Legacy
Jan 27, 2010 | 1997 Subaru Legacy
Aug 07, 2009 | 2000 Subaru Legacy
May 08, 2009 | 1991 Subaru Legacy
Dec 26, 2008 | 1995 Subaru Legacy
Jul 14, 2018 | Subaru Cars & Trucks
86 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: