All 3 passengers can't control window, only driver master switch

Rear Passenger Power Window Operation
The rear passenger power window switches receive battery voltage through the window lockout control circuit if the window lockout function is disabled. Ground for the rear passenger power window motors is supplied through normally closed up and down contacts of both the rear passenger power window switches and the driver power window switch. When the either rear passenger power window switch is placed in the down position, the power window motor down control circuit is switched to 12 volts and is applied to the down side of the rear passenger power window motor. Since the other side of the rear passenger power motor is connected to ground through the normally closed up contacts of both the rear passenger and driver power window switches, the window travels down. By placing the rear passenger power window switch in the up position, the polarity of the power window motor is reversed and the window travels up.
The rear passenger power windows can also be controlled from the driver power window switch.

Did you try pushing the lock out switch on the drivers master switch ?

Lockout Switch Feature
The window lockout switch, when closed, provides power to the passenger door switches enabling normal window operation and when the lockout switch is open, power is cut to the passenger door switches disabling window operation. Normal window operation is still available from the driver master control.

Test the MASTER switch at the drivers side. It seems to be a "wiring problem with the Master switch. The master switch is the switch that controls ALL the cars windows.

The passenger window switch gets both power and ground from the master switch. You have replaced the passenger side switch and it still had the same result and if the wiring is good from the master switch to the passenger side switch, then the only thing left would be the power window master switch. Check all wiring of the Master switch. That's the only thing that's left to do.

Not following you completely.
When you say driver side passenger window, you mean the driver side rear window ?
The window motors get power thru a power window control unit and thru the driver master switch.
You'll need a shop manual with the wiring diagrams to track down the problem.

Try a passenger side door switch or a new complete master switch on drivers door. Alaways check fuses also.

Check for broken wires inside the rubber boot from the body to the driver door . Happens all; the time ,wires breaking . Also you should have check for B+ voltage at the master switch before replacing .
How To Diagnose your Power Window Problem Is the Switch or motor bad BUY...
The Trainer 24 Power Window Troubleshooting

It has to be the switch or the wiring, right? So pull out the switch and probe the back with a volt meter to see if power is coming out of the switch. If yes, trace the wires to the doors.

sugest fuse ck 1st thing. Master bypasses individual controls. Power supply to rear windows is interupted. Ck for connevtor under front seats. Fuse may be labrled accessory or per win.

This may be just a case of inadvertently hitting the window lock out n th driver door window switch by mistake. Check that first. Here's some background on window operation

Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Symptom Chart Condition Possible Sources Action

• All windows are inoperative

• BJB Fuse:
  • F20.
• Circuit.
• Power window relay.
• Front door power window switch.

• GO to Pinpoint Test A .

• Single power window is inoperative

• Front door power window switch.
• Front door power window regulator.
• Circuit.
• Driver door power window switch.

• GO to Pinpoint Test B .

• Vent power window is inoperative — quarter window glass power latch

• Circuit.
• Quarter window glass switch.
• Quarter window glass power latch.

• GO to Pinpoint Test C .

• The one touch down feature is inoperative

• Master window regulator and door lock switch.

• INSTALL a new master window/door lock/unlock switch. REFER to Switch—Master Window Door Lock/Unlock .

• The back window will not defrost

• CJB Fuses:
  • F30 (10A).
  • F32 (20A).
  • F34 (20A).
• BJB Fuse:
  • F27 (45A)
• Circuit.
• Heated back window switch.
• SEC/timer module.
• Rear window defrost relay.

• GO to Pinpoint Test D .

• The back window defrost will not shut off automatically

• SEC/timer module.
• Circuit.
• Rear window defrost relay.

• GO to Pinpoint Test E .

Hi Ethel101
I think that what has happened with your vehicle, is that the master (driver control) switch has become defective....If you have a friend who is good with electronics you may be able to ask for help in getting it fixed....otherwise a new unit is needed.

Best regards

Johngee10