Question about Cars & Trucks

1 Answer

Why it wont receive fuel to the carburator - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 290 Answers

When you turn the key to the on position do you here a slight buzzing sound. if not check the fuel pump fuse then check the fuel pump relay switch if both are good then replace the fuel pump.

Posted on Apr 21, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1978 gmc sierra sbc 350.. problems starting its been sitting for a while. I replaced the mechanical fuel pump but still doesn't run. I can pour gas in the quadrajet carburator and it will turn over and run...


If it runs when you pour fuel in the carburetor, then the problem is that the engine is not receiving fuel. (by the way, be careful, the carburetor may back fire and cause a fire). Disconnect the fuel line from the carburetor and place the end of the line in a bucket, then turn the truck over to see if fuel is flowing. If it is a mechanical fuel pump it should pump fuel into the bucket when the battery turns over the engine. If you had a lot of debris pop out of the carburetor, it should be taken off and cleaned. You may have had a bird or something else try and build a nest in it.

Aug 09, 2014 | Cars & Trucks

1 Answer

I just replace the fuel pump,filter and carburator on my 1983 plymouth reliant.it will turn over and start but wont say started what could be the problem


Possible float is sticking in carb. Tap side of float bowl with screwdriver and see if that helps. If not, I suggest checking the float level and make sure it is adjusted at the right height.

Apr 25, 2014 | Plymouth Reliant Cars & Trucks

1 Answer

No fuel to carburator


Clogged fuel filter or bad fuel pump or fuel pump electrical. When you get in the car and turn the key to on put not all the way to start do you hear the whirl of the fuel pump? Is there a fuel pump inertia switch?

Mar 09, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Cant start the 1981 dotson truck


You should have points and condensor in the distributor,take one sparkplug wire from one one the sparkplug and leave a 1/4 air gap.Have some one crank it you should have spark,If you dont you will need a point and condensor,or if you want just the condensor,now if you replace the point and condensor you retime the engine.If you have spark and it wont start,now go to the carburator the sight glass should be full of fuel.if its not test the fuel pump if its good the carburator float is preventing fuel from entering

Mar 19, 2012 | Nissan Cars & Trucks

1 Answer

My 1991 olds mobile cutlass calais wont start,after I added fuel injector cleaner because,the car was having hesistating problems below 25 miles an hour and it might of been a spark plug problem or fuel...


When you chaged the air filter & sprayed Gumout carb cleaner, you got rid of a little gunk in the
air intake, but when you added the fuel injector cleaner (its the same stuff as carburator cleaner) to the fuel tank, you "cleaned out" ALL the ****/gunk/buildup/dirt in the fuel system which has built up since 1991 and sent it straight to the fuel filter, which is now clogged. The reason that the car tries to start, but fails, is that it'll successfully burn up any fuel that gets past the clogged fuel filter, but the engine consumes that small amount of gasoline quickly, then dies.
Your solution: change the fuel filter.
The fuel filter is located:
Under vehicle, driver side, below seating area, near fuel tank, mounted on frame rail in fuel line

Sep 30, 2011 | 1991 Oldsmobile Cutlass Calais

2 Answers

Wont idle runs fine when driving down the highway but when you stop it wont idle.


check the carburator..might be dirty..might have tiny particles clogged in it..

Jul 08, 2009 | 1987 Plymouth Gran Fury

1 Answer

My carburator is dirty I think


Its fuel injected, try injector cleaner

Jun 26, 2009 | 1985 Honda Prelude

2 Answers

My 4 cil. yj 1995 jeep wont start, and i need it to study


hi,seem you have problem in fuel or ignition system,try to start 3 to 4 times,remove your spake plug,determine if fuel or ignition is missing,if your plug is wet of fuel,look your ignition system,if no fuel is present,try to check your filter ,fuel line,fuel pump if working,ty

Apr 13, 2009 | 1995 Jeep Wrangler

1 Answer

My car wont stay running


it could be the fuel pump not working right. you can buy an electric one and put on there and it will tell you right away if your original fuel pump is dead

Dec 29, 2008 | 2001 Volkswagen Beetle

1 Answer

Hilux Motor suddenly lost power, then trouble to maintain idle


the carburator is dirty and check the bleeder screw for some dirt that went in the carburator. Adjust the idle .

Dec 17, 2008 | 1993 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...