Question about Cars & Trucks

Open Question

How to remove a rear wiper motor on a 03 expedition

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: rear wiper motor

you have to remove the wiper arm first under the arm there a plastic cap remove it big screw undo it lift the tailgate remove the inner plastic cover bolt and plastic clip go easy its plastic after removing the panel you should see the motor unscrew it that it reasemble the only thing that you got to take care when you tight the big nut back dont over tight it you might break the glass it my job ive done 100 of those job and i alway hate when it time to screw that nut back go easy everything will go well cheers pierre

Posted on Jun 24, 2008

johnny5846
  • 379 Answers

SOURCE: 2003 Ford Explorer-Rear Wiper Motor-How to Replace?

the plastic panel pops off , if you had a trim removal tool it would be nice but it can be improvised , they are just tension clips , get some kind of lever behind the panel and give it a pop , once the plastic panel is off its pretty much self explanatory from there , a connector and couple small bolts , now the outside has nut under the w/w blade , a piece of the arm cover pops up to access the nut , remove w/w arm , then a grommet and under the grommet is a bigger nut that helps hold the motor onto the door/hatch , when reinstalling before you put the w/w arm back on run the wiper and make sure it shuts off and in the park position . should be a piece of cake .

Posted on Jan 05, 2009

  • 1 Answer

SOURCE: Replacing the rear wiper motor on a 2002 olds silhouette

I have the same issue, and just did it yesterday.

1. remove the rear hatch door handle with a T35 star screwdriver bit
2. gently pry the panel up exposing the two bottom plastic push fasteners
3. I used a flat prybar with the notch on the fastener and pryed both off
(the push fastener has 2 washers on the top end so get the pry bar under the top one)
4. Now pull the panel off the side door latches and gently pull down again to expose the two back push fasteners and pry them off too.

You now should be able to remove the motor. The wiring harness comes off easily after you figured out that the only the small end closest to the wires comes off, not the whole "box". Insert the small blade of a jacknife crosswise in the space on top of the connector and pry up the tab letting the fasterner slip off.

I found a motor on the net for about $80 (part number1880686) but it currently is out of stock so I have to wait a couple of weeks to finish. I put the panel back on without the push fasteners and will wait the 2 weeks. Buick dealer wanted $320.

Good Luck

Jim
517-784-5385

Posted on Apr 16, 2009

  • 75 Answers

SOURCE: rear wiper motor broke

Well you going to have to open the tailgate up and remove the inside cover that is attached to it. You will need a small flat head and a No. 2 star head screw driver and some gloves so that you don't cut your hands....

First where the handle is remove the caps on the handle and then remove the handle there may be a small pocket around the handle to remove it also with the screw driver....And then remove the garnish from around the tailgate by using the small flat head and your fingers to pry it off with....Remember just to take your time when doing this and wear some safety glasses so that nothing goes in your eyes.

Once you have removed the garnish you should see the wiper motor there should be three bolts that hold it in place and wire wire coupler that it hooked up to it. And before you undo the motor you will need to go on the outside of the tail gate you will need to remove the wiper arm off of the motor and then take the rest off after that.

Posted on May 24, 2009

1ATony
  • 159 Answers

SOURCE: How do I install a rear wiper motor on 2003 Pontiac Montana?

Here's a great video that will show you how to install the rear wiper motor on a 97-05 Montana or Venture">

Posted on Mar 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Only front wipers not working on 2005 expedition


check the linkages at your wiper motor. check the wires for power to the motor.

Dec 28, 2013 | 2005 Ford Expedition

2 Answers

How do I fix or replace the rear wiper motor


Hello,

  1. Disconnect the cable running to the negative terminal on the car's battery. To do this, loosen the nut on the cable clamp until the clamp is loose enough for you to slide the cable clamp off the negative battery terminal.
  2. Pull the wiper arm away from the rear windshield until the wiper arm locks into a vertical or semi-vertical position or is perpendicular to the rear windshield.
  3. Remove the nut holding the wiper arm assembly to the rear wiper motor.
  4. Pull the wiper arm off the wiper motor assembly.
  5. Unplug the rear wiper motor plug/harness.
  6. Remove the screws holding the rear wiper motor to the inside of the vehicle at the base of the rear window.
  7. Pull the rear wiper motor off.
  8. Install the new wiper motor and put the wiper motor and arm assembly back on the vehicle by reversing the completed steps.
From ehow.com

I hope this helps

Mar 21, 2011 | 2000 Ford Expedition

1 Answer

Anyone experiencing repeated broken rear wiper motor?


yes my reaR WIPER WNT WORK I HAVE TO REPLACE THE MOTOR
sorry about caps

Feb 11, 2010 | 2004 Ford Expedition

1 Answer

Rear wiper motor ford expedition 2005


my 2005 ford exp rear wiper moves but the wiper does not it look like something is missing to make it move back and forth can you help.

Jul 01, 2009 | 2005 Ford Expedition

1 Answer

1999 rear wiper motor on a Ford Expedition


take door panel off by prrying clips out, then you should see the motor. unplug the wire harness and take the wiper arm off the outside. Should have to just unbolt it from here, otherwise if its rivited in, you'll need to drill them out and replace them with bolts/washers/lock washer/lock nuts when you put it back in.

Jun 21, 2009 | 1999 Ford Expedition

1 Answer

Problem with rear window wiper. Does not start without a manual lift to start


Sounds like the wiper motor is on it's last leg(s) -- needs help starting -- not enough torque supplied by the motor to move from dead stop. Will probably need replacing.

May 29, 2009 | 2002 Ford Expedition

1 Answer

2005 ford expedition rear wiper


Sounds like a problem within the wiper motor not turning off at rest or not reaching it's rest point to be able to turn itself off, probably needs a new motor. Disconnecting it should have no relation to the front washer operation, you can confirm this by reconnecting the wiper motor to try.

Apr 12, 2009 | 2005 Ford Expedition

2 Answers

Rear wiper does not work at all. front wipers work fine. rear washer works


1. check the fuse to the rear wiper motor
2. check for power to rear wiper motor at the motor (power wire going in to the wiper motor with rear wiper switch on)
If you have good fuses & have power going in to the rear wiper motor...
3. Pull old rear wiper motor and install a new rear wiper motor.
Thank you please drive thru......

Feb 26, 2009 | 2001 Ford Expedition

2 Answers

Rear wiper stopped working


my 2004 expedition had same problem, if you take apart the shaft that goes thru the glass it will be full of dirt, clean ,lubricate and reinstall, you may have to replace the O-ring on the shaft. a 20 minute job, very easy fix

Feb 25, 2009 | 2004 Ford Expedition

2 Answers

2001 Ford Expedition: Rear Wiper won't work.


THEN THERE IS BUT ONE EXPLANATION, THE WIPER TRANS IS NOT CONNECTED TO THE MOTOR DRIVE HEAD.

Feb 05, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...