Question about Oldsmobile 98

1 Answer

How can I check a camshaft sensor in a 1991 Oldsmobile 98 Regency Elite?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 236 Answers

Find out what resistants in ohms is suppose to be and check with ohm meter

Posted on Apr 21, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shop242
  • 214 Answers

SOURCE: wheres the temp sensor located on a 1992 oldsmobile 98 regency?

It should be on the air cleaner hose or Housing itself..

Posted on Mar 17, 2009

polarcycle
  • 1392 Answers

SOURCE: The blower motor on my 1993 Oldsmobile 98 Regency

You need a blower motor resistor.

Posted on Aug 05, 2009

  • 6 Answers

SOURCE: 1991 oldsmobile 98 fuel filter replacement location?

my fuel filter is located right behind the pass side tire on the inner side of the frame.

Posted on Sep 22, 2009

  • 1168 Answers

SOURCE: where is the starter for a 1995 oldsmobile 98

The starter motor for your Oldsmobile is mounted at the front lower part of the engine, just behind the radiator.
Book time to replace by an experience person is 1.1 hours.
If you are looking to do this yourself, disconnect the battery negative terminal and isolate it.
Remove any covers or braces in order to access and remove the starter.
Remove the wires to the solenoid on the starter, then the bolts retaining the starter to the engine.
There may be some shims between the starter and the engine. You may need to replace these with the new starter.
Hope your repair goes well.

KL

Posted on Dec 16, 2009

roniecon
  • 6826 Answers

SOURCE: how to replace 1991 olds regency 98 elite

Remove the crankshaft pulley,the harmonic balance,with a puller made for this,then you can replace the sensor,and align it,if it is not aligned,it will break it.

Posted on Aug 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 95 oldsmobile 98 regency elite I cant find where the knock sensor goes I have a haynes manual but where it shows it wont go


Well, for starters, your problem got posted under 1985 Oldsmobile 98 - then you said it was a 95 Oldsmobile 98 Regency Elite (HUGE difference between 85 and 95)...then it would be REALLY nice to know which engine we are talking about.

I'll just go with what you said last: 1995 Oldsmobile Regency Elite (Two engine possibilities)

If you have the 3.8L Supercharged engine (VIN CODE "1") it is on the left side of the engine near the oil filter.

If you have the non-supercharged 3.8L (VIN CODE "K") there are TWO of them. One is near the oil filter and the other one is in about the same location on the other side of the engine block.

Please also note that MOST fault codes for knock sensors are not caused by the knock sensors themselves. (they do fail, but it is very rare.) Usually there is either a wiring problem to the knock sensor, or the engine has internal problems causing a "knocking" or "ticking" noise which causes the engine computer to "think" that there is a problem with pre-detonation causing an "ignition ping". The code sets when the computer has retarded the ignition timing as far as it can and the "knock" or "ping" does not go away....usually it doesn't go away because it is not caused by ignition timing. The knock sensor is just doing its job and reporting the knock. It does not know the difference between a knock caused by ignition and a knock caused by internal engine problems.

Jun 28, 2011 | 1985 Oldsmobile 98

1 Answer

1995 Olds 98 Regency Elite I'm re-attaching rear


there is a small set screw in the base of the mirror you will need to loosen this and then slide the metal plate out.

Aug 30, 2010 | 1995 Oldsmobile Ninety Eight Regency

1 Answer

How to replace 1991 olds regency 98 elite crankshaft sensor?


Remove the crankshaft pulley,the harmonic balance,with a puller made for this,then you can replace the sensor,and align it,if it is not aligned,it will break it.

Aug 22, 2010 | 1991 Oldsmobile Ninety Eight Regency

3 Answers

I have a 1990 oldsmobile 98 and every day i have to get a boost to start it. what's the problem


it is the automatic load leveler that pumps air into the back shocks to level the car so it rides better when there are lots of people or weight in it. it is in the frontof the car opposite the battery, just disconnect it. had the same problem on my 1990 olds 98.

Aug 21, 2010 | 1988 Oldsmobile Regency

2 Answers

1991 Olds 98 regency elite not start


iv'e had the same problem. mine was the starter wire had a split in the wire under the plastic. i cut wire and wired it directly to the bolt.

Jun 03, 2009 | 1991 Oldsmobile Ninety Eight Regency

3 Answers

1991 oldsmobile 98 fuel filter replacement location?


my fuel filter is located right behind the pass side tire on the inner side of the frame.

May 03, 2009 | 1991 Oldsmobile Ninety Eight Regency

1 Answer

1991 olds 98 regncy elite blower motor not working


There is a fusible link for the blower motor. Check that. Don't know where it is. Look up the wiring diagram at autozone.com. Also check the fuse in the fuse box. Could just be that.

Feb 24, 2009 | 1991 Oldsmobile Ninety Eight Regency

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...