Question about Cars & Trucks

Open Question

2000 accord how to diagnose code p1366 - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 honda accord


That could be just a "soft" code. Does it run hot or any other odd acts? Any other codes? If not clear code & see if it returns. It does have a trans sensor but it's a one in a million.

Jun 30, 2014 | 2000 Honda Accord

1 Answer

2000 honda accord SE stalls randomly


Take your Accord to a competent mechanic and have it diagnosed for stored DTC data which will provide guidance for locating probable trouble causes that can be checked. This is a more practical alternative to replacing parts at random.

Jan 26, 2014 | Cars & Trucks

1 Answer

Code p1456


You can google the code

It is a manufacture code-- not generic

Need a repair shop & scan tool to diagnose

Dec 15, 2012 | 2000 Honda Accord

1 Answer

I have a 2000 Honda Accord 70,000 miles. It will turn over strong but not start. I disconnected 1 sparkplug wire & attached a spare plug held to manifold to check for spark. It started & ran. The...


The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.


The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type. Also engine mechanical problems ca cause many drive-ability related problem such as rough idle and other symptoms








Oct 15, 2012 | 2000 Honda Accord

1 Answer

Can you reset slidig doors 2000 windstar se electric doors quit working


Hi Ryan,

The power sliding doors on your Windstar are pretty complicated. There are many things that can cause them to stop working. The4 FIRST step in diagnosis is to access the Generic Electronic Module (GEM) data and retrieve any fault codes that may be present and diagnose accordingly. Please note that "generic" OBD code readers CANNOT access this information. You will either have to have access to a scanner that can retrieve this "vehicle specific" information or you will have to take the vehicle to someone who does. Please also note the information below.


10_31_2011_11_40_32_pm.jpg

Oct 31, 2011 | 2000 Ford Windstar

1 Answer

My Honda Accord 2000 EX 2 door coupe, 3.0L, has thrown a P0505 code after I cleaned the egr port on the intake manifold. After the car warms up, the idle will bounce between 1000 rpms and 1500 rpms, up...


First check the connector and wiring. If good, remove the idle air control valve and clean the passages as well as the valve and seat. Reconnect the valve but don't install. Have someone start the car while you plug the downstream passage. The car sould idle down or stall, and the valve should retract. Remove your finger, and the valve should extend. If the car will not idle down with the passage plugged, you have a vacuum leak. If the valvedoes not react properly, check continuity of the wires to the ecu.

Sep 02, 2017 | 2000 Honda Accord

1 Answer

I have a 2000 Honda Accord V-6 that had an engine light on code


check egr ports may be filled with **** or egr might be full of **** and need clean

Jan 08, 2010 | 2000 Honda Accord

1 Answer

2000 ex v6 honda accord code p01399


it could be the coil or distrubutor cap

Sep 11, 2009 | 2000 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...