Question about 2004 Pontiac Montana

1 Answer

Removing battery from 2004 pontiac montana

Removing battery

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pontiac Master
  • 1,335 Answers

Https://youtu.be/jdNNxUlrNuM
Hope this video helps

Posted on Nov 06, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: 2004 Pontiac Montana blows cold air in defrost

There is a mix damper inside your duct that controls the heat over heater core and ac evaporator that to your floor and one to your defrost. it is probable an electric actuator, that is not functioning properly. If yu can locate it and manually move it, you might have to remove the actuator motor first, you should be able to figure out your problem, I hope this helps! merry Christmas!

Posted on Dec 22, 2008

  • 1 Answer

SOURCE: low beam headlights not working on 2004 Pontiac Montana extended

You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

Posted on Jan 06, 2009

daves944
  • 1050 Answers

SOURCE: 2003 Pontiac Montana Front Wheel Bearings

Remove the wheel, remove the hub nut, remove the brake caliper and rotor, put your socket and extension through the hub flange onto the bearing retainer bolts, undo them, release the abs sensor connector if it has it, remove the bearing and hub flange as an assembly, put the new one on and go backwards from here. Torque the hub nut to 180 ft/lbs, your done.

Posted on Apr 08, 2009

SOURCE: Pontiac Montana '99 Water Thermostat removal

Yes, it can be removed and run without the thermostat. However, your gas mileage will suffer and the heater may not work very well.

Posted on Apr 29, 2009

Molson02536
  • 3854 Answers

SOURCE: pontiac montana oil pan bolt diagram for removal

If all the bolts are off, then the gasket is holding the oil pan in place and your going to have to tap it with a mallet, Not a hammer but a mallet so you don not damage the oil pan. Good luck and hope this helps.

Posted on Jul 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Pontiac Montana that I just replaced no the the alternator and battery in last week and now the battery light comes on and stays on what could be the problem


First, could be defect alt, bad connection at battery conns. or you probably have an electrical short if all else cks out good. Did u ck the load test the bad,ck the charging system & ck for shorts before u did the work?

Dec 11, 2016 | 2004 Pontiac Montana

1 Answer

Where is the ac expansion valve located in a 2004 Pontiac Montana


the expansion valve (TX valve) is located at the inlet side pipe of the evaporator under the dash

Sep 23, 2015 | 2004 Pontiac Montana

1 Answer

I need to replace the battery in my 2004 Pontiac Montana. It is mounted under a cross brace and the under hood fuse panel. Help Please!!


remove and reposition the underhood electrical center (fuse panel)
remove front end of the brace and loosen the other end
remove the _ and the postive cables from the battery
remove hold-down retainer (bottom of battery)
remove the battery

Jan 13, 2011 | 2004 Pontiac Montana

1 Answer

Where are the grease fittings on the front end on my 2004 Pontiac Montana


many vehicles no longer have grease fittings. This does not remove the need for lube, however. When items fail be sure to install aftermarket parts (like Moog) and they will have grease fittings.

Sep 03, 2010 | 2004 Pontiac Montana

1 Answer

My 2004 pontiac montana is heating up , I need to know where the thermostat is


Follow the radiator hose from the top of the radiator. It will end at a small cover with 2 bolts that hold it on. Remove the 2 bolts and the thermostat is under that cover.


Please Vote! Thanks!

Aug 31, 2010 | 2004 Pontiac Montana

1 Answer

How do I change the Battery?


Remove the negative cable first then the positive, then remove the battery, fit the new battery, connect the positive cable first then the negative

Mar 03, 2010 | 2004 Pontiac Montana

1 Answer

Engine Start Then Batt/AIrbag Light On 14.6 Volts At Battery?


Batt/air bag light? 2 problems. air bag light check and clean wiring under passenger seat. Then drivers seat. Battery light I have no idea unless battery volts to low.

Feb 12, 2009 | 2004 Pontiac Montana

Not finding what you are looking for?
2004 Pontiac Montana Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...