Question about Suzuki Cars & Trucks
That is the starter key line!
so at the starter solenoid, pull off , the tiny wire lug there.
no more blow?, the starter solenoid is bad shorted.
yes, blows, then the key line is shorted. (harness shorts or)
is car stick or auto shifted, ? as both wiring is different.
in a real shop we have this $50 meter, that allows me to find
shorts fast. (amp clamp meter , DC)
or this. dirt cheap. $20
this one works 2 ways, a meter and CB ,it has a circuit breaker
to replace your blown fuse. then not going broke on fuses.
finds any short, even on harness shorts.
Posted on Apr 21, 2015
You have a short to ground somewhere.The best way to start this diagnosis is you will always have one of your main power wires of your battery to the starter.A better question is do you even get to crank it before it blows or does it blow when you put it in, as in turn the key to the run position no cranking or you crank then it blows?
Posted on Apr 20, 2015
FIND the short .no doubt the starter has gone to starter heaven
Posted on Apr 20, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: location of cam position senor
Not a bad job to replace the cam position sensor, it took about two hours cost about $150.00 with oem parts. First remove air filter box,remove plastic spark plug cover. Jack up engine about an inch remove engine mount. Now you can access sensor through a convenient cover that mounts around engine mount bracket extending from engine block.( one ten millimeter bolt) Remove accessory drive belt for a little extra room and replace with new one while you are in there. Just between the two cam gears you will see a torx screw that aligns the switch when in installed. DO NOT REMOVE THIS Just above the torx screw is a reverse torx screw (6 millimeter) Put a shop rag in the access hole to catch the screw just in case you drop it ,( so it does not fall into timing belt cover) Put something "sticky" in the 6 millimeter socket such as gasket sealer to keep from losing screw. remove. Pull switch up from inside spark plug cover and install new one through the same. reinstall 6 millimeter bolt. Switch is self aligning. Reinstall belt, engine mount, air box. Doing this myself probably saved me about $150.00 to $200.00 dollars
Posted on Jun 08, 2008
ON the fuse box cover.
IS there a especification for the funtion of the fuse. or the number of the location of the fuse.
If you can give me, I can try help you. as more I can.
Thank you for use fixya.
Posted on Jul 24, 2008
THERES A FUSE BOX THAT SITS INSIDE THE HOOD OF YOUR CAR BY YOUR BATTERY AS WELL AS ONE BY THE SIDE PANEL BY YOUR DRIVER SIDE. EITHER SPOT SHOULD HAVE A FUSE THAT GOES TO YOUR RADIO. I HOPE THIS HELPS YOU!
Posted on Apr 28, 2009
Several things can cause a car to die. The fact that you don't have any engine codes eliminates some of them. First thing you should try if you haven't is change the fuel filter. Make sure there are no damp, or damaged electrical components. It could be faulty spark plugs, or wires, or a vacuum leak. Check carefully under the hood for vacuum leaks. With the engine running, wiggle all the vacuum hoses around and check for cracked loose or broken hoses. They will make a hissing sound when you find it. A stethoscope, or a length of fuel line held to your ear can help a lot. Check all intake bolts for tightness too. Good luck.
Posted on Jun 12, 2009
Tips for a great answer:
Jun 06, 2016 | Suzuki Cars & Trucks
Apr 20, 2015 | Suzuki Cars & Trucks
Mar 18, 2015 | 2006 Suzuki Forenza
Feb 22, 2015 | 2007 Suzuki Forenza
Aug 31, 2014 | 2005 Suzuki Forenza
Jun 27, 2013 | Cars & Trucks
Jul 11, 2011 | 2004 Suzuki Forenza
Oct 14, 2009 | 2007 Suzuki Forenza Sedan
77 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: