Question about 1996 Isuzu Rodeo
Check the other faults associated with the codes as it may not be those items alone
Posted on Apr 20, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
did you check voltage to sensors if you need help with proedure, contact me, or you may try patrs houses on line in how to section.
Posted on Oct 06, 2008
SOURCE: 1994 gmc safari
Sounds like your Passlock security system went into the tamper mode. If your dashboard security light blinks when the ignition is turned on, your Passlock security system is disabling the injector module, preventing the car from start. Try this:
1- turn the ignition on and just touch the starter, without getting the motor to fire, then leave the ignition in the "on" position. The security light will blink for about 10 minutes. When the light stops blinking, turn the ignition off and leave off for 3 minutes.
2-repeat the step #1, 3 or 4 times. You will know that is fixed when you turn the ignition on and the security light does not blink, then the car will start. Make sure to stay inside the car when you're doing this, as opening the doors will trip the security tamper mode on again. Once the tamper mode is off, the car starts and opening the doors will not trip the Passlock tamper mode.
Posted on Feb 25, 2009
P0700 Transmission Control System Malfunction
P0725 Engine Speed input Circuit Malfunction fixing those will keep the cranksensor from repeatedly going out on you should solve the problem. if you feel this information was helpful please rate it
Posted on Apr 20, 2009
no need to replace the throttle body , and i think that you make a test before to buy any piece . disconnect the negative battery terminal few minutes, then connnect and start engine again, drive few minutes by observing the engine, if light comes again, replace only map sensor ,good luckl
Posted on Apr 24, 2009
If you have a GTP these engines use a hi output fuel pump. they use a fuel pump resistor located under the battery tray (look up from under the car) This resistor lowers the voltage to the fuel fump when not in boost mode. because of its locatoin it is prone to corrosion. if you bypass the wires and the engine starts and stays running replace the resistor
Posted on May 16, 2009
Tips for a great answer:
Oct 10, 2014 | Cars & Trucks
Aug 30, 2014 | Cars & Trucks
Sep 17, 2012 | Chevrolet 1500 Cars & Trucks
Jul 08, 2017 | 1988 Chevrolet Cavalier Z24
Aug 17, 2010 | 2004 Dodge Ram 1500
Nov 24, 2009 | 2003 Isuzu Rodeo
Oct 04, 2009 | 1996 Dodge Neon
Mar 09, 2009 | 1996 Jeep Grand Cherokee
Aug 04, 2008 | 1999 Chevrolet Silverado 1500
Apr 18, 2016 | 1996 Isuzu Rodeo
61 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: