Question about 2006 Nissan 350Z Coupe
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: alarm wont let me start the car
you need the remote control of the alarm to turn the alarm off.
you may need to change the battery of the remote in case it would no longer control the alarm or if you have a valet switch to turn off the alarm, then use it.
the immobilizer is working that is why you can not start the car.
tnx 4 using fixya,
Posted on Sep 13, 2008
SOURCE: my nissan serena car alarm
There are instructions in the owners manual on how to reset the alarm system, if it will not reset then it has a failed part, in this case it needs to go to the shop for diagnosis.
Posted on Oct 29, 2008
SOURCE: My car alarm is blinking
You need to first look under the drivers side dash area near the hood release/fuse panel area and see if there is a valet switch. The switch will look like a little toggle or a push switch. After you locate it, turn the ignition switch to the on position(dont start it) and flick the valet to the opposite position it is in now. If done correctly in most cases the red system light will stay a constant instead of off or blinking indicating you are in valet mode. Next try to start the engine. If this doesnt work you need to remove the alarm system and repair the ignition switch wiring or replace the electrical portion of the ignition switch. The aftermarket alarm cuts into the ignition switch wires and bypasses the start circuit through the alarm module. When disarmed the alarm completes the circuit and allows the car to start. Good luck hope this helps and please rate this.
Posted on Nov 27, 2008
Look for alarm Brain box and look for wires coming out black and red going to valet switch. to turn valet on turn ignition in ON position and press-switch or flip depending on the type of switch. If it a basic alarm just disconnect the main wiring harness to alarm box- unplug and the car should start. Good luck and thanks for using FIX YA
Posted on Jan 27, 2009
The factory security light will remain on - this is a standard feature indicating the car is dead.
First, unplug the hazard fuze in the engine bay (this will reset the ecu and remove the flashing)
Next, replace the battery with a new one (or one with proper charge) - keep in mind a small battery will not do anything for these cars, the engines require a lot to push them over (it isnt a honda)
*Make sure to clean the positive and negative battery cables from acid
Then just start it up :)
Posted on Apr 06, 2009
Tips for a great answer:
Feb 24, 2012 | 1996 Chrysler Town & Country
Nov 30, 2010 | 1992 Lexus Es 300
Aug 07, 2010 | 2004 Toyota Solara
Apr 05, 2010 | 2003 Hyundai Tiburon
Nov 29, 2009 | 2001 Honda Civic
Jun 25, 2009 | 2001 Hyundai XG300
Jun 13, 2009 | 2001 Hyundai Elantra
Sep 24, 2008 | 1992 Chevrolet G20
22 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: