Question about 1991 Toyota Camry

1 Answer

91camry dash lights indicate a problem with breaks and headlights also with battery new baterry still same indicators

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 372 Answers

Have charging system tested, sounds like alternator malfunctioning most places will test at low or no cost

Posted on Apr 19, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: dash board light indicator

water light check coolent lvl in resavore

Posted on Jul 18, 2008

  • 1 Answer

SOURCE: 1994 camry reverse indicator ilght on when breaking

Common to see a broken wire in the wire harness that runs along the left rear trunk hinge. They can cause all sorts of problems after years of bending when the trunk is opened and closed. You will need to carefully cut the wire loom and inspect these wires. Sometimes the wires are broken INSIDE the insulation and cannot be seen without stripping the wires.

Posted on Dec 13, 2008

  • 42 Answers

SOURCE: 2000 toyota camry check engine

wires are pinched and shorting together near the left (drivers side) trunk hinge. brake light power is feeding back through the reverse light wiring. this will also turn on the check engine light with a neutral safety switch malfunction code as the computer also sees this voltage in the reverse light circuit. Find and repair the wiring, pull the EFI fuse in the panel under the hood to clear the code. Hope this helps

Posted on Dec 28, 2008

bmw_tech_38
  • 113 Answers

SOURCE: Passenger side indicator comes on with head lights

Hi, have you checked to see if the bulb for the parking light/side light is working in the headlight?

Posted on Apr 23, 2009

darkknight1
  • 6 Answers

SOURCE: toyota rav 1996. New battery fitted, EFI fuse

replace all the fuses and bulbs

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

DRL dashboard indicator and headlight indicator lamps not working


Probably the bulb for the indicator. There is no I separate fuse.

Oct 24, 2016 | Subaru Cars & Trucks

1 Answer

91 camry dash lights indicate break , light& battery problem car dies new battery lights still indicate same problems. Breacks work fine


Lamp failure sensor it sit in thetrunk next or the hinge
the harness falls down and gets stuck and short out the
wire harness repair harness replace little yellow box
it start with 89373 ,make sure you have the the right
sensor easy to locate please reply let me know if
that helps thank you

Apr 19, 2015 | 1991 Toyota Camry

1 Answer

I have a 2008 jeep rubicon that the headlights the indicator lights the wipers and air condition stop working the same time


LIGHT INDICATOR AND WIPER ALL PART OF YOU SWITCH ON THE STEERING COLUMN .BUT FIRST READ YOU MANUAL AND CHECK ALL THE FUSES.INSIDE AND OUTSIDE THE JEEP.NEXT FOLLOW THE GROUND WIRE FROM THE BATTERY AND MAKE SURE THE WIRE IS CLEAN AND TIGHT TO THE BODY.MORE GROUND WIRE WILL FIND UNDER THE DASH BOARD CLOSE TO THE DOOR HINCH.
GOOD LUCK

Mar 27, 2014 | 2008 Jeep Wrangler Rubicon

1 Answer

Was driving 2002 ford ranger when engine died,lights work,no clicking from starter,could it be the clutch sensor?


The clutch sensor would not cause the dying problem. If you have dash lights that is not an indication that the battery is ok sine they require almost no voltage to turn on. Try your headlights with the key on and see if the dash light dim. This would indicate a battery/charging system problem. Also note if the battery light comes on when the key is turned on. If the other lights work but the battery light does not it indicates the alternator has a problem. If all the lights work fine check for power at the clutch switch which contacts the cluths pedal arm higher up the pedal. Should have power to and thru the switch when cranking.

Dec 11, 2013 | 2004 Ford Ranger

2 Answers

My battery light indicator on dash board stays on


This is usually caused by a faulty alternator.
It stays on because the alternator is not generating sufficient voltage on the control winding to extinguish it.

Check battery terminal voltage while motor running with headlights on or blower fan running.
Terminal voltage should be approx 14.5V.
Ensure alternator and engine are properly connected to ground and the battery negative terminal.

Oct 08, 2009 | Nissan 200SX Cars & Trucks

1 Answer

Passenger side indicator comes on with head lights


Hi, have you checked to see if the bulb for the parking light/side light is working in the headlight?

Apr 19, 2009 | 2000 BMW 3 Series

1 Answer

No front lights work


check the headlight relays under the hood also fuses under the hood and in the interior fuse pannel.

Nov 18, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1991 Toyota Camry Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...