Question about Oldsmobile Cars & Trucks

1 Answer

Where would the computer module be located on a 1992 oldsmobile be located

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Underneath the dash driver side

Posted on Apr 19, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What are the probable causes of DTCs P0017 and P0047?

A 1992 model should be OBDI so -
code 17 is a problem with spark control which involves the ignition module, and code 47 is not listed for that model.
Code 47 is generally used when there is a problem between the engine computer and the body computer, but a 92 model would not have a body computer.

Oct 13, 2015 | 1992 Oldsmobile Toronado

2 Answers

Keyless entry module

The keyless entry module is under the rear package tray inside the trunk.
This system is not directly related to the courtesy lights circuit.
Contact me for details and instructions on how to troubleshoot. I just went through a major repair ordeal and learned a great deal about both systems.

Aug 15, 2008 | 1992 Oldsmobile Toronado

1 Answer

Location of ICM in 1992 olds delta 88

It is the module below the coil pack. The coils are plugged into it.

Apr 16, 2013 | 1992 Oldsmobile 88

1 Answer

I have a 1992 olds achieva thats not throwing any spark/firing.

You may need a shop manual to get the test procedures.
You would need to know if you are getting power to the pink black wire going to the module, and a signal from the crank sensor.
The computer controls timing.

Feb 28, 2013 | 1992 Oldsmobile Achieva

2 Answers

Where is the ecm module located 92 ply voyager 3.3l

The 1992 Plymouth Truck Voyager 4WD 3.3L MFI 6cyl the Engine Control Computer is located under hood, driver side, front side of strut tower, rear of headlight, mounted on inner fenderwell .

Hope this helps (remember to rate this answer).

Jun 13, 2011 | 1992 Plymouth Voyager

1 Answer


That year Ciera came with two diiferent engines. if you have the 2.5 liter engine it is located under the hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block. If it is the 3.3 liter engine it is located under the hood, passenger side, lower engine area, front of crankshaft pulley, mounted in engine block. i hope this helps you and good luck.

Mar 15, 2011 | 1992 Oldsmobile Cutlass Ciera

1 Answer

Wheres the fuel pump

the electric fuel pump is located inside the gas tank, the tank must be removed from the car to replace the pump module

May 19, 2010 | 1992 Oldsmobile Ninety Eight Regency

2 Answers

Where is a prom chip located at on a oldsmobile

Then programmable read only memory (PROM) chip that you are asking about is located inside the electronic control module.
This module is located just above the glove compartment in the dash area.
Removal of the glove compartment is required to remove this module. After removing the ECM you will note a small access cover. Remove this cover and you are at the PROM.
Good luck, it is quite easy.

Mar 10, 2010 | 1992 Oldsmobile Cutlass Ciera

1 Answer

How do you install a computer

It's under the dash on the passenger side in back of the glove box, very easy to remove and install, just unplug harness and unbolt, you will need a 10mm socket.

Jan 19, 2010 | 1992 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides