Question about 2000 Honda Odyssey

1 Answer

What do I fix if my a/c clutch not engaging but if I bypass the relay the clutch will engage

I replace a new clutch relay but still the clutch will not engaged but if I bypass the relay clutch will engage I charge 2 134a but still the clutch not engaged

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Check the No. 59 (7.5A) fuse in the under-hood fuse
/relay box, and the No. 3 (7.5A) fuse in the driver's
under-dash fuse/relay box.

It could be that one of these 2 fuses are blown and that would cause the a/c clutch relay to not engage

What do I fix if my a/c clutch not engaging but if - 25654071-53cyoy0icyh5bjnubwnwpgjl-4-2.png

Posted on Jun 29, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 131 Answers

SOURCE: A/C - compressor clutch won't engage

Your A/C system has a pressure sensor. If the system needs recharged, the compressor will not engage.

Posted on Jul 06, 2008

justuscc
  • 360 Answers

SOURCE: Compressor Magnetic Clutch - 1996 Honda Accord EX

looks like fuse # 8 "heater control relay- ac clutch relay-cooling fan" fuse runs the 12 volt side " black and yellow stripe wire " pcm or ecm runs the ground side "red -blue stripe wire"- what else do you need?

Posted on Sep 18, 2008

  • 1596 Answers

SOURCE: rover 600 1997 not engaging any gears when clutch fully depressed

Sounds like the SLave Cylinder has givin up Possible the Reli=eice Bearing I ALWAYS Replace As A PAIR . If you can put in gear by having someone rock the car front to back and it holds well its pretty Obvious that you DO have A Clutch Master Cylinder or Clutch Slave aat Releice Bearing Problem AGAIN These Parts I REPLACE AS A PAIR. Before ANything Chech Fluid Level that will tell the store IF FULL Most Probably MASTER-- If EMPTY then See where it went Look At SLAVE if wet thats the Culpret. --->> I Hope this INFO helps you and have a good Day >> Please dont forget to RATE me ok ? Thank You

Posted on Jan 16, 2009

  • 11 Answers

SOURCE: Honda CRV 2002 - Clutch

you must still have air in the line. check all lines fittings and your clutch gaskets

Posted on Feb 16, 2009

  • 1779 Answers

SOURCE: My Clutch won't engage into gear. Need advice!

Did you check the clutch reservoir under the hood mounted on the firewall, driver side? Make sure level is up where it should be. If it's real low, you may have to bleed the system to get the air out. If you need to add fluid, use brake fluid.

Posted on Apr 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac not working, air compressor clutch not engaging


Hi Adeyeri

Keep in mind that the Clutch won't engage for a few safety reasons.

Temperature inside vehicle
Temperature of compressor or pipes
Pressure inside pipes
Compressor jambed
Eg It's out of refrigerant Gas

You can momentarily engage the clutch by simply giving it +12v to the wire attached to clutch. Usually has a connector close by.
Or
If it has a Relay (click) in fuse box
You can by pass it with a jumper

A quick engage & disengage should allow you to detect possible problem.
But don't over ride the built in safety for more than about a minute.

Cheers
Hope this Helps

Vehicle Air Con testing YouTube

FIXED Car Compressor Clutch Won Engage

12 Volt Car Relays Used In Automotive Industry

Feb 23, 2016 | 2002 Infiniti QX4

1 Answer

Ac clutch won't engauge


Relay will not engage if pressure switch thinks freon is low. This switch does sometimes fail. If you are sure freon is ok, use jumper wire to bypass low pressure switch and see what happens.

Jun 24, 2015 | 2005 Honda Accord 2.4

2 Answers

Bypass ac relay 2000 grand am


Use a wire to connect the two openings parallel to each other just for flash. If you get a spark but no engagement then it's probably not the relay but the clutch. The clutch relies on the relay bringing the ground connections together. Find the grounds in the connector using a continuity tool or reading the diagram on the spade end of the relay, using a magnifying glass if necessary. They're hard to see.

Sep 03, 2014 | Cars & Trucks

1 Answer

My ac clutch is not engaging..new compressor,dyer and hoses, new relay fuse in engine compartment...if freon is low will that make clutch not engage?


yes there is low pressure cycling switch on low side
bypass those wire and if the clutch engage then your low in freon or switch defect

Oct 02, 2013 | 1996 Chevrolet S-10 Pickup

1 Answer

97 chevy suburban AC clutch won't engage pressures


Looks like the low pressure switch gets power from a 10amp ac fuse. Power then goes to the ac relay which is powered on by the ac heat controller on the dash. Power then goes thru the high pressure switch to the compressor. The ac relay is grounded to the body. Do you have power on the lite and dark green wires going into the relay and is it grounded ?

Jul 26, 2013 | Cars & Trucks

1 Answer

Air Conditioner Compressor Clutch Problem


If you did not use a vacuum pump from a dry system them the system will not work.

Jul 04, 2017 | 2002 Chrysler PT Cruiser

1 Answer

Ac compressor clutch will not engage on my 98 yukon.


The most common cause of no clutch engagement is a low state of refrigerant charge in the system. Have a set of AC pressure gauges hooked up and bypass the compressor cycling switch and check the pressure on the low side charging port, you show shop 28-32 PSI at idle.

Jun 24, 2012 | Cars & Trucks

1 Answer

2003 dyna starter turns but wont engage, new battery fitted


Hi Anonymous, lift up rubber boot on positive cable to starter, unplug starter relay wire usually green, with a jumper wire connected to positive battery cable starter stud, touch blade connecter on starter where starter relay wire was removed. If starter engages and turns over engine then your starter relay is bad. If starter activates but does not engage then your starter drive/clutch is bad. Good luck

Jan 22, 2012 | Cars & Trucks

1 Answer

Ac will blow warm air, the clutch does not engage. Could this be a compressor prob? Looked in the manual ...no trouble shooting ideas


Since you know that the clutch must engage in order for the compressor to operate, then there are most likely one of causes. The first is low or no freon in the system. The a/c system has a pressure sensor mounted in the low( return) side hose that prevents the clutch to engage if the freon is too low. The second would be the a/c fuse or relay faulty, preventing the clutch solenoid( a 12 volt electrically operated solenoid) from engaging. And the third would be that the clutch itself is bad because the solenoid wiring has broken. I suggest that first you locate the a/c clutch relay in the relay panel, remove the relay, carefully remove the plastic cover from the relay and reinstall the relay. The clutch should engage the compressor when you manually close the relay contact with your finger for one or two seconds. If the clutch does engage, your electrical circuit in ok and you are probably low on freon. A half of a can of r-134 in more that enough to operate the pressure switch. If it doesn't engage, check the a/c fuse or the clutch solenoid itself. Get back to me and let me know how things went. Dano

Jun 30, 2011 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
2000 Honda Odyssey Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...