Question about Chrysler Sebring
Check the water temperature sensor unit and the relays for the fans
the sensor reads the coolant temperature and when a pre-set parameter is reached , a signal is sent to the ECM which activates the fan relays and starts the fans
Posted on Apr 19, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The roatating knob that turns on the headlight pulls out to turn on the fog lights, but only pulls out when the headlights are on,
Posted on Dec 24, 2008
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
Posted on Apr 28, 2009
It may not be a bulb, as the instrument cluster usually has a number of bulbs and they probably didn't all blow at once. Pulling instrument clusters can be touchy and may not be for the average "shadetree mechanic" however, typically there are a few screws above the cluster going into the dash pad and a few hidden behind the trim panels below the cluster.
Posted on Dec 22, 2009
All gas charged supports are not created equal. I recommend using O.E. for this application.
Snow,ice and trapped water make the lid heavier than it should be make sure these are not the issue.
Posted on Jan 19, 2010
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.
Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).
Posted on Jun 03, 2010
Tips for a great answer:
Oct 03, 2016 | 2001 Chrysler Sebring
Oct 20, 2014 | 2001 Chrysler Sebring
Jul 29, 2011 | 2005 Chrysler Sebring Conv
Jul 06, 2010 | 2001 Chrysler Sebring
May 24, 2010 | 1998 Chrysler Sebring
Apr 22, 2010 | 2000 Chrysler Sebring
Jan 21, 2010 | 2001 Chrysler Sebring
Aug 23, 2009 | 2008 Chrysler Sebring Convertible
Jun 05, 2009 | 1996 Chrysler Sebring
Nov 23, 2017 | Chrysler Cars & Trucks
Nov 22, 2017 | Chrysler Cars & Trucks
23 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: