Question about 1997 Buick Park Avenue

Open Question

What is the buzzing noice behind the instrument panel of my 1997 Park Ave?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1997 park ave battery dies over night

I just posted my experience in another place on this site but on my 1992 PA the accessories relay stuck closed. This relay is the one that allows you to listen to the radio etc and keep things on until you open the door then all shuts off. When it is stuck closed accessories keep running until your battery drains dead. The relay was replaced and all worked great.

Posted on Feb 11, 2009

Ad
  • 1596 Answers

SOURCE: power door lock switch replacement




Remove or Disconnect

Door handle trim plate.

  1. .Install or Connect

  2. Electrical connector and door lock cable.
  3. Trim panel by engaging hooks on backside of panel.
  4. Push pin fastener in defroster duct.
  5. Screw from behind lamp assembly.
  6. Courtesy lamp assembly.
  7. Two screws in arm rest.
  8. Arm rest cover plate.
  9. Door handle trim plate.
There May Be A Need to Drill Out RIVETS that Hold Motor in place,. Just Replace with>>MACHINED SCREWS & BOLT'S




Remove or Disconnect

  1. Trim panel. See: Doors, Hood and Trunk\Doors
  2. Four tabs retaining switch.
  3. Electrical connector.
Install or Connect

  1. Electrical connector.
  2. Snap switch into trim panel.
  3. Trim panel.

Posted on Mar 14, 2009

  • 14 Answers

SOURCE: 1997 buick park ave door lock buttom is loose. How

At the bottom of the door panel you will find several screws ( haven't removed mine in a few mo. and have forgotten how many ) there are also screws under the slotted bottom of the finger grip in the door panel. After removing screws lift the panel from the bottom and to the top of the door. You will encounter clips on the rear of the door panel the most problematic is by door locking mechanism. Use a small blade flat screwdriver to Gently prise the clip out of the metal door. To pass over the interior door handle piviot the door panel, Take Care the wires for window and door lock are located here!
I used Gorilla Glue to reseat my lock button be Cautious not to bind the lock button, or the function will be impaired ( won't work ) HAVE FUN

Posted on Aug 24, 2009

  • 396 Answers

SOURCE: 1997 Buick Park Ave. no taillights, no turn

yes there is definately a fuse that will control all of these, doubting a wire connection is bad, theres just too much not working. your fuse will either be under the dash, or kick panels inside, and there will also be a fuse/relay panel under the hood

Posted on Dec 03, 2010

Testimonial: "THIS CAR BELONGS TO A FRIEND,AND HE ISN'T VERY MECHANICAL AND ASKED ME TO HELP. YOUR RESPONSE HAS BEEN VERY HELPFUL. I WILL GET THIS TO HIM TODAY. "

  • 193 Answers

SOURCE: timing chain replacement 1997 buick park ave.

They are not prone to fail. I always recommend to replace only major when engine repair is needed.

Posted on Mar 27, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 1997 Buick Park Ave speedometer doesn't work, speed sensor is ok what could it be?


The gauge it self could be bad . Replace instrument cluster or have it tested .

Feb 09, 2017 | Buick Cars & Trucks

1 Answer

#6 fuse blowing 1992 buick park ave


you have a short to grownd same weare under the dash that fuse control 7 diferent systems automatic day and night mirror memori seats ad mirrors instrument panel warning and alarms sir air bag system and accesorie power

Sep 11, 2014 | 1992 Buick Park Avenue

1 Answer

Timing chain replacement 1997 buick park ave.


They are not prone to fail. I always recommend to replace only major when engine repair is needed.

Mar 27, 2013 | 1997 Buick Park Avenue

1 Answer

I can't find the fuse box inside the 1997 park ave ultra


the fuse panel is either located under the dash on the drivers side,you may have to drop a down an under dash cover to get access to the fuse panel, the other location is some are in the glove box.

Mar 30, 2011 | 1997 Buick Park Avenue

1 Answer

1997 Buick Park Ave. no taillights, no turn signals, no instrument panel lights. Is there a fuse or possibly a break in the wiring. Where is the fuse for this part of the wiring located? thanks. ...


yes there is definately a fuse that will control all of these, doubting a wire connection is bad, theres just too much not working. your fuse will either be under the dash, or kick panels inside, and there will also be a fuse/relay panel under the hood

Dec 03, 2010 | 2000 Buick Park Avenue

1 Answer

Where is the tdm located on a 94 3.8 park ave?


I'm pretty sure it is behind the glove box in your model. It was in my 95 LeSabre and still is in a 2000 Park Ave. You can find some good info on this page: http://vatspasskey.com

Apr 16, 2010 | 1994 Buick Park Avenue

1 Answer

97 f-150 high pitched wine from radio, buzzing behind instruments


If the whine changes pitch with engine RPM it could be a serious problem with the alternator. Possibly the voltage regulator, or a shorted diode in the alternator causing high frequency AC to be fed into the harness.

Oct 09, 2009 | 1997 Ford F150 Regular Cab

1 Answer

Try to locate body control module on a 94 buick park ave


BCM --The Body Control Module is located on the right side of the vehicle and positioned under the instrument panel. In order to gain access to the module, it will be necessary to first remove the trim panel.

Jun 23, 2009 | 1994 Buick Park Avenue

1 Answer

Power door lock switch replacement





Remove or Disconnect

Door handle trim plate.
  1. .Install or Connect

  2. Electrical connector and door lock cable.
  3. Trim panel by engaging hooks on backside of panel.
  4. Push pin fastener in defroster duct.
  5. Screw from behind lamp assembly.
  6. Courtesy lamp assembly.
  7. Two screws in arm rest.
  8. Arm rest cover plate.
  9. Door handle trim plate.
There May Be A Need to Drill Out RIVETS that Hold Motor in place,. Just Replace with>>MACHINED SCREWS & BOLT'S




Remove or Disconnect

  1. Trim panel. See: Doors, Hood and Trunk\Doors
  2. Four tabs retaining switch.
  3. Electrical connector.
Install or Connect

  1. Electrical connector.
  2. Snap switch into trim panel.
  3. Trim panel.

Mar 14, 2009 | 2000 Buick Park Avenue

1 Answer

None of the interior lights work, cannot find switch/fuse


Take off panel under glove compartment and fuse box is up high and to the far right of the car almost out to the door. Will have label, cover just snaps off.

Nov 23, 2008 | 1997 Buick Park Avenue

Not finding what you are looking for?
1997 Buick Park Avenue Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...