Question about Isuzu Cars & Trucks

2 Answers

I have change head motor on my Isuzu pickup 92 I put on timing but my truck don't startup tries but don't by carburator I have seem some blow everytime i try to start what coulb be the problem?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Isuzu Master
  • 10,875 Answers

Turn the distributor 180 degrees

Posted on Apr 18, 2015

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 372 Answers

If its popping back through the carb, the timing isn't right. Could either be distributor in wrong,or the cam timing is mis-aligned

Posted on Apr 18, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 1992 isuzu pickup timing

Sounds 180 degrees out. Move flywheel to top dead center. Remove timing belt and turn flywheel pulley ONE complete turn to top dead center. Then put timing belt back on with marks lined up.

Posted on Feb 11, 2009

  • 31 Answers

SOURCE: air conditioning not blowing cool air

To get the refrigerant in you have to have a technician purge the system first. Hope that helps.

Posted on Apr 22, 2009

  • 850 Answers

SOURCE: 92 gmc pickup,fuel injected throttle body.Engine

electronic dizzy modules do this when they get warm they cut out but can start up again within minutes !
very commen fault!
get it checked or borrow one
Cheers Rob

Posted on Aug 15, 2009

  • 14036 Answers

SOURCE: 92 isuzu pickup head gasket repair

YOU NEED TOOLS AND A HAYNES REPAIR MANAUL TO SHOW AND TELL YOU HOW HEADS ARE REMOVE.YOU NEED A STRAIGHT EDGE LIKE FRAMING SQUARE AND FEELER GAUGE TO DECK THE THE HEAD TO CHECK FOR WARPAGE.OR THE MACHINE SHOP CAN CHECK WARPAGE ON HEAD.SEE IF REPLACED HEAD GASKET AND DONT CHECK WARPAGE WHICH SHOULD NOT EXCEED 0.004 INCH.IF SO YOUR NEW HEAD GASKET WILL LEAK ALSO.

Posted on Apr 10, 2010

  • 447 Answers

SOURCE: changing pickup coil

You have to remove the distributor from the engine then remove the distributor shaft from the distibutor housing, then you can remove & replace the pickup coil. Make sure you marke the exact location of the distributor body in relation to the intake manifold and note exactly where the rotor is pointing in relation to the distributor cap. I always set the timing marks on the front pulley at zero and make sure that the rotor is pointing at the #1 plug wire terminal on the cap before removing any distributor as it makes getting it in time easier if you lose your marks. You should reset the ignition timing when you have it all back together again as you'll most likely be off a few degrees. Some of these distributors had problems with the magnets in the distibutor shaft that would mimic a failing pickup coil and they were prone to drive gear wear. If you suspect any of those problems it's often easier to replace the entire distibutor with a reman unit.

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do you have a pitcure fo the timing marks for 92 isuzu 2.3


try fixya.com/answer/answerpageslideview.aspx?thid=24538348

May 30, 2014 | 1992 Isuzu Pickup

1 Answer

'92 Nissan hardbody temp gas gage don't work any


Check for the the temp unit on cylinder head. put the wire on cylinder head and check if the gauge is working

May 17, 2012 | 1992 Nissan Pickup

1 Answer

What is the firing order on a 92 jackaroo isuzu motor


ON A 4-CYL: 1-3-4-2 DISTRIBUTOR ROTATION-COUNTERCLOCKWISE / ON A V-6: W/DISTRIBUTOR (COUNTERCLOCKWISE): 1-2-3-4-5-6. SAME GOES FOR THE DISTRIBUTORLESS IGNITION!

Feb 19, 2011 | 1992 Isuzu Pickup

1 Answer

92 isuzu pickup head gasket repair


YOU NEED TOOLS AND A HAYNES REPAIR MANAUL TO SHOW AND TELL YOU HOW HEADS ARE REMOVE.YOU NEED A STRAIGHT EDGE LIKE FRAMING SQUARE AND FEELER GAUGE TO DECK THE THE HEAD TO CHECK FOR WARPAGE.OR THE MACHINE SHOP CAN CHECK WARPAGE ON HEAD.SEE IF REPLACED HEAD GASKET AND DONT CHECK WARPAGE WHICH SHOULD NOT EXCEED 0.004 INCH.IF SO YOUR NEW HEAD GASKET WILL LEAK ALSO.

Apr 10, 2010 | 1992 Isuzu Pickup

1 Answer

How to change lift spring on 92 isuzu pick up


refit the original springs ,rear springs are leaf springs ,no problem their but for the front coil springs you will need a pair of spring clamps but this is not a difficult job and well within the bounds of a competent weekend mechanic

Oct 17, 2009 | 1992 Isuzu Pickup

1 Answer

Can't control idle ,motor surges up and down then shuts off


Check and clean carburator or have it replaced. Had a nissan sentra with the same problem. Hope that helped.

Jun 07, 2009 | 1994 Isuzu Pickup

2 Answers

Will a GM 60 degree V6 work in my '97 Rodeo LS V6 4wd


NO! Call a salvage yard, they have info. on what will fit it.

Jun 04, 2009 | 1995 Isuzu Rodeo

1 Answer

92 Isuzu changed water pump 2 times and still won't pump water?


take the themostate out and run the car. if there are water curculating, the you have a ba themostate.

Apr 17, 2009 | 1994 Isuzu Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...