Question about 2007 Mitsubishi Eclipse

1 Answer

2007 Mitsubishi eclipse spider just put in clutch kit now it will not engage I can put it in gear without car on and I can push the car back and forth

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 2,210 Answers

Sounds possible you have the friction plate in backwards and there is no clearance. Retrace your steps and check the clutch operating mechanism, then any gear linkage. With the clutch centre plate, the raised part of the spring carrier is usually facing outwards toward the pressure plate fingers.

Posted on Apr 17, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
lobsterman72
  • 91 Answers

SOURCE: tdi clutch pedal pushed all the way down but hard to shift gears

Check your clutch fluid level, sometimes a seperate reservoir (drivers side on firewall), some clutch systems take fluid from the brake system (check brake fluid). If thats ok then the clutch slave may be failing.
If the clutch fluid is low refill it and check for leaks (or just wait till the symptom comes back). If it's happens often then theres a leak in the line or the slave somewhere.

Posted on Jul 08, 2008

  • 1 Answer

SOURCE: car will not move when

Have a helper put it in first gear and then check to see if any of the driveshafts or half shafts are spinning. U could have a broken axle, or one of your axles popped out. Or u could have spun all the fiber or lining off your clutch disk. With car running try to shift in to gear without depressing the clutch if it goes into gear with no grinds then it your disk. just a few simple tricks to try.

Posted on Aug 09, 2008

  • 1 Answer

SOURCE: car will not drive, is it clutch or cabel

my daewoo lanos wont shift into gear/s while running even when clutch is depressed all the way

Posted on Jan 03, 2009

  • 834 Answers

SOURCE: clutch wont disengage and i can push the car when

That burnt smell is what used to be your clutch disk, and you will need to replace the clutch before you will be able to drive that vehicle again. You should purchase a complete clutch kit for your vehicle, and it should come with a new pressure plate, clutch disk, throw-out/release bearing, a pilot bearing, and a clutch disk alignment tool, and be sure that the pilot bearing is replaced when that new clutch is installed.

Posted on Jun 04, 2010

  • 63 Answers

SOURCE: 2001 mitsubishi eclipse v6 how to remove clutch

drop the tranny and it will be right there

Posted on Aug 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Mitsubishi eclipse spider What is the p.s.I. suppose. To be on air condition I know it takes 19 oz. Of freon tried. To put a can of freon in and it won't take it


it won't take anything if the a/c clutch isn't engaging could have a deeper problem with system relays , clogged filter , evaporator , condenser ect should get system checked out

Apr 22, 2015 | 2007 Mitsubishi Eclipse

1 Answer

2007 Mitsubishi eclipse spider replaced clutch plate pressure plate throw out bearing still have no gears I can put it in gear with key off and I can push car anywhere


Does it feel like you have good pedal pressure? Might try bleeding clutch, if you have good pressure its possible the clutch parts are wrong. Or were installed wrong, sorry

Apr 18, 2015 | Mitsubishi Cars & Trucks

1 Answer

2007 Mitsubishi eclipse clutch was slipping but put in new clutch throw out bearing pressure plate had flywheel shaved now I have no gears checked gear oil it's level bleed lines and still no gears


how much was taken off flywheel ? was there a shim between crank and flywheel ? did you make sure spline count on clutch plate matched spline count and diameter on input shaft to transmission

Apr 17, 2015 | 2007 Mitsubishi Eclipse

1 Answer

I replaced the new flywheel and new clutch kits. It doesn't work. Why? If car is off I can shift in to a gear but it starts I cannot engage into gear. What is wrong?


I don't suppose to know Mitsubishi cars at all but it sounds like a safety interlock related to the clutch pedal mechanism hasn't been reconnected correctly or may have been adjusted out of tolerance during the remove and replace process.

Nov 15, 2014 | 2001 Mitsubishi Eclipse GT

1 Answer

Mitsubishi Eclipse GT clutch slipping


sounds like you need a new clutch and throwout bearing

Apr 14, 2017 | Mitsubishi Eclipse Spyder Cars & Trucks

1 Answer

Fourth gear not engaging


some possibilities are the syncro energise spring has come out and not spinning up the gear to allow engagement Prove by engageing and dis engaging with engine stopped and foot on clutch or the hub has been put in back to front or the selector fork has been fitted inncorrectly

Jan 13, 2013 | 1999 Mitsubishi Eclipse

1 Answer

I have a mitsubishi eclipse 2001 rs, i seem to be having a problem with my clutch. or so i think it is my clutch i have had the clutch fluid blead. though i have no problem putting it in gear but when i...


Sounds like the clutch assy is about worn out. Most hydraulic clutches are self adjusting so when the clutch disc lining wears thin it takes more pedal travel to engage.

Feb 05, 2011 | 2001 Mitsubishi Eclipse

Not finding what you are looking for?
2007 Mitsubishi Eclipse Logo

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...