Question about 2005 Ford Ranger XLT

1 Answer

Why does the A/C clutch only engage occasionally.

Freon is good. Sometimes the clutch will engage and sometimes it wont.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 4 Answers

Problem is probably in the cable

Posted on Apr 17, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1994 ford mustang 3.8 liter a.c. compressor clutch will not stay engaged, blower fan works but not cold. freon is good


What is the pressure in your low pressure side at 80 degrees ambient? Did you use gauges?
U said the clutch will not stay engaged, meaning that it engages and then releases. If so, that means the clutch winding is good but that perhaps you have a loose wire feeding the clutch or a bad, intermittent relay. And if that is not the case then you are LOW in freon and the low pressure cut off switch is disconnecting the clutch when the pressure goes down. Pressure should be around 35 pounds on suction line at about 3000 rpm.

Mar 21, 2016 | 1994 Ford Mustang

1 Answer

Ac clutch won't engauge


Relay will not engage if pressure switch thinks freon is low. This switch does sometimes fail. If you are sure freon is ok, use jumper wire to bypass low pressure switch and see what happens.

Jun 24, 2015 | 2005 Honda Accord 2.4

1 Answer

Clutch does not engage. has Freon , checked all fuses and ac relay switch. what should I do next


Make sure the clutch itself is working. Remove the pigtail coming out of the clutch, connect it directly to the battery positive and listen for the clutch clicking in. If you can hear it click, start the car and do it again, see if the clutch engages the pulley.
Clutches, being manufactured by humans, sometimes go faulty.

Mar 13, 2015 | AC Cars & Trucks

2 Answers

Why wont a/c clutch stay engaged


You dont have enough refrigerant in it. Go to wal-mart and by a recharge hose and a can of freon, If you do not have any leaks, and system is ok. Then by adding the proper amount of freon, should keep the a/c clutch from recycling. Good-Day! It will tell the proper way to fill it on the guage for the freon.

Aug 03, 2014 | 2001 Toyota Echo

1 Answer

Clutch on compressor wont stay engaged. presure checks out fine


Sometimes its a faulty relay, sometimes its the magnet in the clutch.
Are you getting a steady power to the clutch ?

May 30, 2013 | 2003 Toyota Corolla

2 Answers

Ac won't get cold anymore power to compressor but won't click on clutch won't engage possible problems are compressor or evaporator what do you think?


Has the Freon been checked with a gauge to see if there is enough Freon to allow the system to work. Low or no Freon will not allow the compressor to engage. The low pressure switch is most likely activated due to low freon, and will cause this condition.

Aug 19, 2011 | 2001 Jeep Grand Cherokee

1 Answer

Air compressor not engage was blowing cold just quit while running check fuse all show good check freon all good no broken hoses compressor wont kick in getting fire ti presser switch


the clutch on the air compressor coil is proably burnt out. disconnect electrical plug at end of air compressor and supply current direct from battery to see if clutch engages, if it does not, change thecoil clutch switch.

Jul 23, 2010 | 2005 Kia Sedona

3 Answers

Air conditioning


If there is no r-12 or freon in the system it wont come on. Try jumping the pressure switch. It's a 2 wire plug somewhere one the AC lines. Just pull it off and jump the wire end with another wire.If the clutch engages you need freon or R-12.

Jul 25, 2009 | 1996 Chevrolet Corsica

2 Answers

A/c compressor wont kick on


the only other thing in the circuit is the pressure switch...unplug/ jump across the connector of the switch to verify circuit integrity and go from there...sometimes this is neccessary to charge freon fully so compressor will stay running to draw freon in the low side.

Jun 25, 2009 | 1994 Ford Ranger Supercab

Not finding what you are looking for?
2005 Ford Ranger XLT Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...