Question about 2006 Suzuki Aerio

1 Answer

How do I replace the clutch? - 2006 Suzuki Aerio

Posted by on

Ad

1 Answer

_-__-___-_
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points
    Superstar:

    An expert that got 20 achievements.
    All-Star:

    An expert that got 10 achievements.
    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 20,706 Answers

Step 2, remove trans-axle. (im assUming stick shift, as both have clutches.) it's only tedious no tricks or rabbits out of hat.
why not youtube others doing this first. see if its "easy for you" first.

so what does it say there. on that #2 step in FSM.book

answer for STICK shift car.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the negative battery cable.
  3. Drain the transaxle oil.
  4. Remove or disconnect the following:
    • Clutch operating cylinder with hose still attached
    • Gear control cables
    • All the wiring harness clamps and connectors involved with the transaxle removal, tag if necessary for location to aid during installation
    • Ground cable at the transaxle
    • Starter
    • Exhaust No. 1 pipe bolts
  5. Support engine with lifting device.
    • Engine under covers
    • Exhaust No. 1 pipe and exhaust No. 2 pipe
    • Lower stiffener
    • Left and right ball joints from steering knuckles
    • Drive shaft joints
    • Center shaft support and center shaft
    • Dynamic damper
    • Engine rear mounting
    • Engine rear mounting No. 1 bracket with No. 2 bracket
    • Transaxle to engine bolts and nut
  6. Support transaxle with a transmission jack.
    • Left engine mounting with bracket
  7. Remove any remaining attached parts from the transaxle.
  8. Pull transaxle out so as to disconnect the input shaft from the clutch disc and then remove it.
then the install.'
lots more steps and torque settings. RTM?

Posted on Apr 18, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

6ya.com

6ya - Get Instant Help

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a place to add transmission fluid to a 2002 kia sport age clutch, mine is slipping
no transmission fluid in a clutch system
only brake fluid
and that is in the reservoir at the top of the clutch master cylinder or shared with the brake master cylinder
if the clutch is slipping it indicates the need to replace the clutch master cylinder or tor replace the clutch assembly
Clutch master cylinder is cheaper and easier and is generally the main reason for slipping clutches unless you have a cable clutch in which case replace the cable

May 27, 2017 | Kia Cars & Trucks

2 Answers

Clutch and engine check light plus clutch got eaten up in 2 weeks time
If ur have replace ur clutch but the check light still on it mean your CO sensors need to clean or replace.

Jun 17, 2016 | Nissan Cars & Trucks

2 Answers

How do i replace a clutch fan on a chevrolet trailblazer
http://www.bing.com/videos/search?q=replace+a+clutch+fan+on+a+chevrolet+trailblazer&FORM=HDRSC3


http://www.bing.com/videos/search?q=replace+a+clutch+fan+on+a+chevrolet+trailblazer&FORM=HDRSC3

May 16, 2015 | Chevrolet TrailBlazer Cars & Trucks

2 Answers

Hyundai. Tucson, 59 plate' clutch slips at high speed when changing gear
check /replace clutch cable or replace master cylinder. If the clutch has not been replaced it may need a clutch kit as the indications are that the pressure plate is weak ( worn clutch plate or from overheated clutch)

Feb 10, 2015 | Hyundai Tucson Cars & Trucks

2 Answers

How can i fix the squeak on the clutch on 2007 crv
Most likely the it is a worn clutch. Replace it as soon as possible before the metal parts start to wear out which can be expensive to fix. All manual cars needs clutch replacement at some point.

Sep 05, 2014 | Honda CRV Cars & Trucks

1 Answer

Clutch stick gets stuck and I can't change gears
It can be due to the:
- Engine rpm high.
- Brake oil level too low.
- Brake oil contaminated.
- Air in the clutch system. (Bleed air)
- Worn out master cylinder clutch, upper. (Replace)
- Worn out clutch cylinder clutch, lower. (Replace).
- Worn out clutch plate. (Replace)
- Worn out pressure plate. (Replace).
- Clutch bearing defective or seized. (Replace).

Aug 30, 2013 | 1999 Toyota Corolla

1 Answer

How Do You Replace Clutch Master cylinder
honda civic.... replaced with new clutch and clutch kit... now i have to replace the clutch master cylinder..... only done 167k since new clutch.... should this have been checked when the clutch was replaced?

Jan 11, 2011 | 1998 Chevrolet Camaro

1 Answer

Replaced master and slave clutch cylinders but
if you replace and shure to make a good bleed on clutch fluid, then replace clutch disc

Jul 27, 2010 | 1991 Toyota 4Runner

1 Answer

Chevy l989 4X4 5 speed manual clutch not working
Almost every time a clutch is replaced in a GM with hydraulic release system that system is replaced as well. You can try, and try, and try again to bleed it, but you will eventually replace the clutch slave and master cylinders. Once the slave is allowed to fully extend, it is then virtually impossible to make it function correctly again.

Jul 08, 2009 | 1998 Volkswagen Passat

1 Answer

Clutch fried on 2007 Hyundai Tuscon
Yes they are related. I had the same thing happened to me the forks got bend so I had to replace the whole clutch system, clutch cover where the forks are at and the clutch itself. When they replace the clutch plate they should also replace the clutch cover or vice versa. I don't think it's you it's probably just the car. I suggest you have the clutch plate and clutch cover replaced.

Jan 21, 2009 | 2005 Hyundai Tucson

Not finding what you are looking for?

View Most Popular

2006 Aerio

  • Cars & Trucks

Related Question

Is there a place to add transmission fluid to a 2002 kia sport age clutch, mine is slipping

  • Kia Cars & Trucks

Open Questions:

0 Answers

how do I set the timing chain on a 2006 Suzuki aerio SX

Apr 11, 2017 | 2006 Suzuki Aerio

0 Answers

How do you chane air bag light on 2006 Suzuki aerio

Apr 26, 2014 | 2006 Suzuki Aerio

0 Answers

when traveling about 45 mph my car weaves

Apr 07, 2014 | 2006 Suzuki Aerio

0 Answers

2006 Suzuki Aerio 2.3L car turns on but will not stay on Have addthe cleaner but once it dries out it shuts off

Jan 27, 2014 | 2006 Suzuki Aerio

See all 2006 Suzuki Aerio Questions

Related Topics

2006 Suzuki Aerio Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

Suzuki Aerio Cars & Trucks

2003 Suzuki Aerio

2003 Suzuki Aerio

2003 Suzuki Aerio

2003 Suzuki Aerio

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2006 Aerio Manual

2006 Aerio

Loading...