Question about Dodge Avenger

1 Answer

How to remove seat from avenger 220 cc - Avenger Dodge Cars & Trucks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 55 Answers

Remove the 4 bolts the seat 2 in the front 2 in the back also you need to undo the plug for the power seat switch as well as the single wire plug for the sensor for when you sit on the seat, you may have to remove the inner seat belt as well the bolt is under a plastic cover and it requires a torx socket hope this helps

Posted on Nov 28, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2014 avenger. How do I remove the console between front seats?


Lift out any inserts or mats etc that are inside the console floor. Sometimes there are screws hidden there. Look around the sides and back of the console as well. There are usually a couple of screws on the sides and a few at the rear. You may also have to undo the gear shift knob if its a floor shifter. Move the seats all the way forward or backward to expose any screws or covers that hide screws for the console. If you have to force anything, it will mean that there are still screws or bolts, you have to have a close look.

May 26, 2015 | 2014 Dodge Avenger

1 Answer

Locate factory stereo amplifier for a 2008 dodge avenger


Its either umder the passenger seat or in the trunk

Feb 12, 2015 | 2008 Dodge Avenger

1 Answer

How 2 turn off seat belt light 2011 dodge avenger?


Pull on the front seat belts a few times

If the rear ones are use- try them also

Nothing--- you will need a scan tool to check the
SRS Module for codes

Nov 21, 2014 | 2011 Dodge Avenger

1 Answer

How remove head rest


For Hard back seat, you have to pop the hard back seatby unclipping the Top 2 clips. For Soft back seat, there should be a zipper.
anyway, you have open up the back of the seat and disconnect the active head rest connector.
Make sure you disconnect the battery post first, so u dont set off an airbag light.

press the release button on the left, and Stick a Small pick or screw driver to release a hidden button on the right.
2456817.jpg


remove-head-rest-34mp2nvq3oy5jdzwlhqp5egt-5-2.jpg

Mar 14, 2014 | 2014 Dodge Avenger

1 Answer

Where is the fuel filter on a 2008 dodge avenger


There IS no fuel filter on a Dodger Avenger with the 2.4L PZEV....it's an integral part of the fuel pump. Remove the rear seat bench, and you'll see a black plastic cover on the left (driver's) side. Pry that open, and you'll see the top of the fuel pump and a black retainer ring. Knock down all the tabs to release the pump and seal, remove, replace with a new pump and seal, replace retainer rain, all is good. Unless you somehow get a lot of dirt and water in your fuel, the integral filter's good for at least 100K miles. By that time, your pump's just about shot anyway, so change it out then, along with the spark plugs.

May 09, 2012 | 2008 Dodge Avenger

1 Answer

How do i replace the reclining lever for a 2008 dodge avenger


The mechanism is probably held in with a bolt and spring, so you'll
have to remove the plastic side cover around the bottom of the seat,
to gain access. Once the cover is off, you will just need to remove and
replace the bad parts.

Mar 29, 2010 | 2008 Dodge Avenger

1 Answer

Where is the fuel pump in a 1996 dodge avenger


it is in the fuel tank and this is a easy one. because most are not accessibly unless you drop the fuel tank! but on your vehicle it can be access by the access panel under the rear back seat bottom. remove the bottom of the back seat and you will see it right in the middle! unplug the harness , remove the panel and remove fuel pump and assembly up and out. good luck and if you have any more question please ask.real easy fix. good luck

Sep 23, 2009 | 1996 Dodge Avenger

2 Answers

How do you replace fuel pump on a 1995 dodge avenger?


Easy my friend. Pull out the back seat, and remove the square plate on the passenger side. After you pull back the plate, you will see a round plate that needs to be removed. The fuel pump is attached to the bottom side of this plate. No need to remove tank.

Jan 14, 2009 | 1995 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...