Question about Mazda Cars & Trucks

Open Question

My Mazda rustler 160i cuts out when i am turning to my right sharply and goes again when I am in a straight line again. Any advice.. n

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
WildBill49
  • 97 Answers

SOURCE: mazda rustler 160i

Hi Gerrie1974-

WildBill49 here......Not knowing the specific year and version of your Mazda, I cannot give you a specific part at fault, but I can help you. I am assuming we're talking about an electronic distributor single coil ignition system

If the spark is weak directly out of the coil (with a known good coil hooked up with correect polarity), then the problem is in the spark trigger module... There is a variety of designs, but the basic components remain the same. This is the part of the ignition system that replaces the breaker points. It consists of two parts - a magnetic spark trigger sensor, and a spark signal amplifier/controller. these are sometimes combined into one ignition module.

Replace this module, and spark from the coil should be strong! If it is still weak, reverse the two wires to the coil.

Weak spark at the plug wire with the above good indicates distributor cap/rotor replacement time...

Gerrie, I hope this is what you are looking for, best of luck, and if you feel my advice worthy, please rate it!!!

Thanx-
-WB

Posted on Jun 22, 2008

Ad
  • 1 Answer

SOURCE: mazda rustler 160i wheel bearings

a had sabe problem in a same model about one year.
i replaced inner and outer cv joint

Posted on Dec 17, 2008

  • 2 Answers

SOURCE: 1997 mazda rustler 160i wheel bearings

buy a chevy

Posted on Dec 19, 2008

haider_alhar
  • 90 Answers

SOURCE: setting the idling and airflowmeter on the 160i rustler Bakkie 97

first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

Posted on May 31, 2009

  • 1 Answer

SOURCE: where do i get fuel pump in mazda rustler 160i

fuel pump located inside petrol tank,
you have to remove the fuel tank, only 4 bolts, and a few pipes.
befor doing so, check fuel pump relay located in the middle of dashboard on the floor(horse shoe type plastic cover)

Posted on Nov 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda Rustler 160i Has been running perfectly. All of a sudden cuts out and now won't start. Fuel problem? Dirt? Not familiar with fuel injection


a blocked fuel filter will give a starving indication well before it gets to clogged to pass fuel
the problem is else where
run the fault codes to determine the problem sensor

Feb 16, 2017 | Mazda Cars & Trucks

1 Answer

Hi i have a mazda rustler 160i and something is draining the battery how can i find the problem and fix it


If you are mechanically inclined, start by having a multimeter connected to your battery. Then, remove fuses one at a time while checking if the draw goes away. This will isolate the circuit and then you begin checking components within that circuit.

Nov 20, 2016 | Mazda Cars & Trucks

1 Answer

I have a mazda rustler 160i and something is draining the battery how can i find the problem and fix it


With multi-meter connected to battery begin removing fuses one at a time and checking if the draw goes away. Then, you check components within that circuit until you find the problem.

Nov 20, 2016 | Mazda Cars & Trucks

1 Answer

My mazda rustler 160i only start normally when the petrol tank is on empty,i don't understand why.


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

May 12, 2016 | Mazda Cars & Trucks

1 Answer

Why does the revv drop on my mazda rustler 160i when i depress the clutch pedal to shift the gears. sometimes the engine even cuts off. what could be causing this problem?


look for vacuum leaks, connect a gauge to line an watch it . it should only drop a little when engaging any gears .

Jul 10, 2014 | Cars & Trucks

1 Answer

Setting the idling and airflowmeter on the 160i rustler Bakkie 97


first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

May 31, 2009 | Mazda 323 Cars & Trucks

1 Answer

Mazda rustler 160i wheel bearings


a had sabe problem in a same model about one year.
i replaced inner and outer cv joint

Dec 03, 2008 | 1997 Mazda 626

2 Answers

Mazda rustler 160i


Hi Gerrie1974-

WildBill49 here......Not knowing the specific year and version of your Mazda, I cannot give you a specific part at fault, but I can help you. I am assuming we're talking about an electronic distributor single coil ignition system

If the spark is weak directly out of the coil (with a known good coil hooked up with correect polarity), then the problem is in the spark trigger module... There is a variety of designs, but the basic components remain the same. This is the part of the ignition system that replaces the breaker points. It consists of two parts - a magnetic spark trigger sensor, and a spark signal amplifier/controller. these are sometimes combined into one ignition module.

Replace this module, and spark from the coil should be strong! If it is still weak, reverse the two wires to the coil.

Weak spark at the plug wire with the above good indicates distributor cap/rotor replacement time...

Gerrie, I hope this is what you are looking for, best of luck, and if you feel my advice worthy, please rate it!!!

Thanx-
-WB

Jun 22, 2008 | Mazda 323 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...