Question about 2007 Chevrolet Tahoe

2 Answers

I can not open driver door window and i check all fuses, winder and wires. then i change the main windows control switch with a used one but no thing change. when i change it with a new one all windows and doors locks became unable co opened from main switch

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,326 Answers

Bad motor

Posted on Apr 16, 2015

Testimonial: "we tried to operate the window by connect it directly to external electrical source and it was going up down smoothly. the motor seem work normally,the problem in the main switch which can not operate any windows but it operate right side mirror(passenger side)and all the doors can be locked from the switch but not driver door."

  • Richard Faber
    Richard Faber Apr 18, 2015

    it operating mirror because least button used and different mechanism. the window u have a short somewhere maybe one of the other switch. the lock actuator is bad hit me up on comments if want more details

×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Chevrolet Master
  • 354 Answers

Firstly, you probably bought the wrong new switch. As for the window not working, the window regulator has been known to be a problem. If it was that, you would hear the motor running or trying to run. I would say that since the driver window is the one most used and if you do not hear the motor running, it is probably the lift motor. You still would have to check it because there are other components involved. No matter what, you are going to have to remove the door panel.

Good luck,
Vinnie

Posted on Apr 16, 2015

Testimonial: ""we tried to operate the window by connect it directly to external electrical source and it was going up down smoothly. the motor seem work normally,the problem in the main switch which can not operate any windows but it operate right side mirror(passenger side)and all the doors can be locked from the switch but not driver door.""

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electric windows .drivers side door


no all window motors goes through the master switch
the one fuse and relay if set up that way

could be faulty switch
faulty window winder motor
broken wire across door hinge

Oct 13, 2016 | Cars & Trucks

1 Answer

Windows are not working roght


Put some silicone spray or dry lube in the window frame where the glass runs and this will free up the window and take the load off the motor.
All "Henry"window winder switches are a problem they don't last lone at all. I have replaced my Ford winder switches about every 18months to 2 years. They are a money maker for Ford Motor Coy

Sep 02, 2015 | 2003 Ford Explorer Sport Trac

1 Answer

My windows all the sudden won't roll down


Look for broken wires in the driver's door opening. Peel back the rubber boot on the wiring harness there, with the door open, and check the wires. The power wire and the ground wire for the windows are in that group of wires, going to the master control switch on the driver's door. If you can get the master switch out without taking off the inner door panel-which you may have to do to get to the master switch controls-then you could check for power and ground at the switch connector with a test light or voltmeter.

The first thing people do when their windows quit is to try a new or used master switch. If you don't have a tester, you could try that, but about 75% of the time, it is not the problem. I heard from a salvager when I was looking for a used one, that it was more like 90% of the time. Sure enough, half or more of his cars were missing the master switch.
There may be a fuse to check, but usually the power windows use a circuit breaker rather than a fuse. It should be under the dash in a fuse panel.

May 29, 2015 | Cars & Trucks

2 Answers

Why do my interior lights flash when i open the driver door only and also my windows have stopped working as well?


Check if all of the windows (except the drivers window) work from the main switch, and from the window switches on each door. If the windows all work from the doors switches, you have a bad master (main) panel controlling the drivers door window. If the windows don't work from any switch, check for a fuse issue, or a pinched wire in the tube from the door hinge area to the door.

Dec 03, 2014 | 2000 Ford Explorer

1 Answer

Power windows all stopped working


Maybe a broke wire inside the rubber boot from the body to the door ! See this a lot. Opening an closing the door a million times . Do you have a volt meter ? Pull the switch from the door an test for B+ voltage on the brown wire at pin G connector 1 The other window switches get B+ from the drive door switch . Also check the ground , black wire pin B connector 1 . Do you know how to use a DVOM - digital volt ohm meter ?
Videos on youtube .

Sep 15, 2017 | 2003 Pontiac Grand Am

1 Answer

All power windows don't work do I need to get new motors or fuses?


check all fuses and relays first if good check main controll switch on driver door remove passenger door cover remove plug to window switch get a test lite check to see if you have power to pass door window switch have friend move passenger window up and down from main switch on driver door while you check for power on pass window switch plug.if you have no power the main switch on driver could be bad. good luck j.f

Apr 26, 2010 | 1996 Plymouth Voyager

4 Answers

Window problem


Might want to check the doors with the problem windows for a broken wire from the door to the door jam.

The window lock switch is a single circuit to all the other windows, so if there was a problem with it, none of the window controls would work ( but the driver's side would still operate them ).

The other place to check for a broken wire is the driver's side door to a-pillar harness. The circuits for the other windows run through the driver's side switch. Could be a wire in the driver's side door harness.

The other item could be the driver's side switch, the contacts will get carbon built up on them, and the windows will not operate anymore.
This is what mine looked like when the driver's side window stopped working ( lower left hand corner of the picture is the driver's side window switch, note the carbon build up on the contacts )
ccfb7fb.jpg

I would start with checking for broken wires, by metering the window switch for power.

The back passenger's window switch should be getting power & ground on the white w/ yellow stripe wire and the tan w/ light blue stripe wire.
in the "at rest" position on the driver's side switch, these are supplying ground to the power window, and power is being applied to the other side of the motor ( depending on direction of travel ).
792a56e.jpg

Apr 05, 2010 | 2004 Ford F150

6 Answers

Windows won't roll down


Does the rear window work from the passenger switch?

Oct 07, 2009 | 2003 Cadillac CTS

2 Answers

PROBLEMS WITH POWER WINDOWS


Check the fuse in the car it may be blown , if its fine then power switch board may be defective ..


Good luck....

Jan 12, 2009 | 2004 Ford Explorer

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...