Question about 2010 Ford Focus

1 Answer

I have to turn my ignition back and forward hard to get it too crank I replaced the part before it wasn't the ignition barrel on a Ford focus 2010 what is it called?

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 1,326 Answers

Ignition switch

Posted on Apr 23, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3422 Answers

SOURCE: broken ignition barrel ford laser 1989 model

Hi,

this is the procedure to remove the ignition barrel:

Remove the steering column surround and you should see a black round thing on the left hand side, this is the ignition switch. Remove this and you will see there is one screw holding the ignition barrel on, remove and you then need to insert your key and turn it to the ACC position. you should now be able to withdraw the barrel using the key but take care not to snap the key off in the barrel.

Please don't forget to rate or accept the solution as fixya.

Goodluck..

Posted on Jun 15, 2008

  • 26 Answers

SOURCE: i have a R reg

Most likely there you have a security system VAT (Vehicle Anti-Theft) module. If you try to bypass this the car will not start. Have a mechanic or yourself get to the main wiring harness to the ignition in the steering column under the dash, unplug it and use another ignition with a key in it to learn the security system code first before trying to start it.

Posted on Sep 13, 2008

  • 89 Answers

SOURCE: the angle of the headrest is too far forward on 2010 ford focus

try cleaning battery connections and starter connections if this does not help check timeing may be out. check nfor possible over heating. berrydalewolf

Posted on Oct 27, 2009

  • 1 Answer

SOURCE: key ignition barrel does not turn 2000 avalon

i can turn the key to acc but will not go any further.

Posted on Jun 14, 2011

  • 1 Answer

SOURCE: 20003 Ford Focus. It will not crack unless you

alternator not charging

Posted on Jul 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is my Ford Transit Ignition locking so that I cannot turn the key further to 'turn over'the engine?


still something wrong with the two
do the door locks/boot work ok with the keys
did you replace the old keys with a new set of key s at the same time as the barrel

May 11, 2016 | Cars & Trucks

1 Answer

My crank fuse keep blowing what cause it to blow


Ignition Switch / Starter Fuse keeps blowing. - CarGurus

www.cargurus.com > Questions > Ford > Focus
CarGurusAug 14, 2010 - Ignition Switch / Starter Fuse keeps blowing. - I own a 2002 Ford Focus, 2.0l SPI engine. 5-speed manual trans. Recently bought from a friend's ...

Jul 28, 2015 | Cars & Trucks

1 Answer

How hard is it to change an ignition switch


Not that hard if you are mechanically inclined. The flat rate book time is .8 of an hour. You need to remove the steering wheel bezel covers and the switch is held in place by clips.

Jun 14, 2015 | 2010 Ford Focus 1.6

1 Answer

Wrong key broke off in ignition of a 2004 focus how do i removed this piece


Might have to have the barrel drilled out and replaced, I have removed broken keys with very fine crochet needles and a lot of patience. To take a barrel out without damage the key needs to be turned into the first position to depress the barrel lock pin, which you can't do with the broken key in. Good luck

Jan 23, 2014 | 2006 Ford Focus

1 Answer

Have just changed fuel filter on 2010 Focus1.8 duratorq engine and refilled filter cannister. Engine started and ran until cannister emptied and then stopped. Refilled cannister but would not start. How...


Turn the ignition "on" without cranking the engine - wait for 30 seconds.

Turn the Ignition back off for 10 seconds.

Repeat 3 times.

All air will be purged back into the fuel tank.

Jul 21, 2011 | 2011 Ford Focus

1 Answer

My ignition will not turn, the steering is locked also. I had a previous problem where when you put the key in the car would not crank, turn over or anything. Then after a while it would just crank up.


The previous problem sounds like it was probably the starter motor playing up but may of been related to your current problem. The ignition barrel sometimes locks at the same time as the steering and you have to move the steering wheel that little bit of movement back and forward whilst turning the key to unlock them. If this does not work then it may be a problem with the ignition barrel which may need replacing. The other 2 things it could be is the starter relay or a fuse.

Mar 25, 2011 | Buick Regal Cars & Trucks

2 Answers

05 ford focus, key won't turn in the ignition, tried both sets of keys.


Try wiggling the key and tapping near the ignition and see.If the Key starts turning in the ignition.Also spray wd-40 in the ignition switch hole and let the wd-40 spray liquid remain in there for 30 minutes then see if you can turn the key in ignition.Try this wd-40 spray couple of times,if still the same problem then,the ignition has to be replaced.Also the keys are to be reprogrammed by the dealer.Without getting your car key reprogrammed they will not work with new ignition lock cylinder. This problem is very common in ford focus,many other users too have noticed this and are very disappointed with the ford service due to this problem.Click this link directly to see the same problem with other ford focus users;--- http://www.carcomplaints.com/Ford/Focus/2003/accessories-interior/key_wont_turn_in_the_ignition.shtml ----------------- Thank you.

Jan 24, 2011 | 2005 Ford Focus

1 Answer

When you turn the key it has trouble starting sometimes you turn it it doesnt do anything, sometimes it turns the lights and radio on and other times it starts to crank and doesnt so far it has always...


I would check the ignition switch, these are prone to key and barrel wear, Sounds silly but if you have another key try that as a newer,less worn profile key can sometimes help with a solution

Oct 05, 2010 | 2005 Ford Focus

1 Answer

The angle of the headrest is too far forward on 2010 ford focus


try cleaning battery connections and starter connections if this does not help check timeing may be out. check nfor possible over heating. berrydalewolf

Oct 26, 2009 | 2009 Ford Focus

1 Answer

Replaced ignition coil now the car is dead and


hi I would check all of my fuses, possibly somthing got arced and blew the crank fuse

Aug 07, 2009 | 2001 Ford Focus

Not finding what you are looking for?
2010 Ford Focus Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...