Question about 2006 Ford Five Hundred

Open Question

Where is the speed sensor located on a 06 ford 500 awd limited cvt transmission

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Need to locate the camshaft sensor for 2007 ford 500 awd v-6,my car only goes 45miles an hour.


not a cam position sensor
if it was , the engine would not start
possible accelerator position sensor or throttle position sensor/motor
instead of guessing a solution or problem , have the fault codes read first

Aug 01, 2016 | Ford Cars & Trucks

1 Answer

What can I use in an emergency situation for regular transission fluid to add fluid to my transmission that takes special fluid on a 05 ford 500 awd limited


Ok so first your six speed in your ford is made by Aisin/Warner model tf-80sc Is what I came up with. Did you know Toyota use Aisin transmissions? This mean that the cross I found is correct it said that you can use aisin fluid pn atf-qt4 or fluid rated Toyota T-IV as an alt fluid, being that aisin is the manufacture of your trans you probably will have no issue. Also according to another post when he pulled the drain plug it drained out about three quarts from the plug! hope this was helpful.

Apr 29, 2016 | Ford Cars & Trucks

2 Answers

Where is the torque converter clutch solenoid located P0744


troubleshooting?
  • cvt re0f10a
p0744 torque converter

description
this malfunction is detected when the torque converter clutch does not lock-up as instructed by the tcm. this is not only caused by electrical malfunction (circuits open or shorted), but also by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc.

dtc logic

dtc detection logic
159975295

dtc confirmation procedure

caution:
always drive vehicle at a safe speed.

note:
if "dtc confirmation procedure" has been previously performed, always turn ignition switch off.
then wait at least 10 seconds before performing the next test.
1.check dtc detection
with consult-iii
  1. turn ignition switch on.
  2. select "data monitor".
  3. start engine and maintain the following condition for at least 30 seconds.
159894994

with gst
follow the procedure "with consult-iii".
is "p0744" detected?
yes - go to see: cvt re0f10a.
no - check intermittent incident. refer to see: testing and inspection\initial inspection and diagnostic overview\intermittent incident.

diagnosis procedure
1.check line pressure
perform line pressure test. refer to see: transmission and drivetrain\continuously variable transmission/transaxle\testing and inspection\initial inspection and diagnostic overview\cvt re0f10a.
is the inspection result normal?
yes - go to 2.
no - repair or replace damaged parts.
2.check torque converter clutch solenoid valve
  1. turn ignition switch off.
  2. disconnect cvt unit connector.
  3. check torque converter clutch solenoid valve. refer to see: cvt re0f10a. is the inspection result normal?
yes - go to 3.
no - repair or replace damaged parts.
3.check lock-up select solenoid valve
check lock-up select solenoid valve. refer to see: cvt re0f10a.
is the inspection result normal?
yes - go to 4.
no - replace transaxle assembly. refer to see: transmission and drivetrain\continuously variable transmission/transaxle\service and repair\removal and replacement\cvt re0f10a\transaxle assembly\exploded view.
4.check secondary speed sensor system
check secondary speed sensor system. refer to see: p0720\cvt re0f10a.
is the inspection result normal?
yes - go to 5.
no - repair or replace damaged parts.
5.check primary speed sensor system
check primary speed sensor system. refer to see: p0715\cvt re0f10a.
is the inspection result normal?
yes - go to 6.
no - repair or replace damaged parts.
6.detect malfunctioning items
check tcm connector pin terminals for damage or loose connection with harness connector.
is the inspection result normal?
yes - replace tcm. refer to see: powertrain management\transmission control systems\control module, cvt\service and repair\cvt re0f10a\exploded view.
no - repair or replace damaged parts.

component inspection (torque converter clutch solenoid valve)
1.check torque converter clutch solenoid valve
159962448

check resistance between cvt unit terminal 12 and ground.

159975296

is the inspection result normal?
yes - inspection end
no - perform "self-diag results" mode for "transmission".

component inspection (lock-up select solenoid valve)
1.check lock-up select solenoid valve

159962449

check resistance between cvt unit terminal 13 and ground.

159975297

is the inspection result normal?
yes - inspection end
no - replace transaxle assembly. refer to see: transmission and drivetrain\continuously variable transmission/transaxle\service and repair\removal and replacement\cvt re0f10a\transaxle assembly\exploded view.

Jan 21, 2015 | 2010 Nissan Altima 2.5

1 Answer

Vehicle Speed Sensor


Cvt transmission is continuously variable transmission. VSS is vehicle speed sensor. A faulty sensor can make the transmission run erratic.

Jul 30, 2012 | 1997 Honda Odyssey

1 Answer

Location of camshaft sensor on a 2006 ford 500 awd limited 3.0 v6


It should be located in the valve cover, towards driverside.

Jan 18, 2011 | 2006 Ford Five Hundred

4 Answers

Where is the trans dipstick for a 05 ford 500 AWD Limited Edition


For the 6 speed auto trans the dipstick is located behind the radiator support, to the left of the air cleaner box. The dipstick is a round yellow plastic towards the bottom of the transmission. The exhaust manifold is slightly above it, so be careful not to burn yourself.

Nov 01, 2010 | 2006 Ford Five Hundred

1 Answer

06 Ford Freestyle FWD CVT Fluid Level Measuring (IDLE? or off?)


Hi,
According to the Ford shop manual, the cvt transmission has a transmission fluid dipstick located on the front of the transmission (drivers side between the radiator and trans. The fluid should be checked with the transmission temp between 190deg F and 198deg F ( I think hot engine covers it) running in park. The fluid should be in the crosshatched area of the dipstick. With the the transmission between 109deg f and 117deg f running in park the fluid should be at the bottom hole of the dipstick. This whole procedure is based on your being able to monitor the transmission fluid temperature. If you have a scan tool that shows you live data and you are able to monitor the temp, good. But if you don't own a scan tool and buying one would cancel out the savings of doing your own trans service................ then if it were me I would top off the fluid at the hot (190-198deg f) temp adding a little at a time until I was just near the top of the crosshatch area. I think logic prevails here. If the manual wants the fluid at the bottom hole with a cool trans then we must assume that when the trans is hot it wont be above the top hole. And I also want to add that if this fluid level was this critical then I would think I would have alot of freestyles going thru my shop with transmission concerns as soon as one sprung the smallest leak.
I really hope this helps you out and good for you for doing your own service, I admire that!

May 16, 2010 | 2006 Ford Freestyle

2 Answers

Would like to service my 2006 ford Five Hundred transmission. I am told that it takes a very special and expensive fluid. Is the job strait forward other than that?


I own a "06" 500 with 150,000 miles on it. My Ford dealer recommended transmission service at around 90,000 miles. I don't recall the exact cost but it didn't seem unreasonable, around $140.00. No special pump out or filtration, just drain and refill.

Nov 21, 2009 | 2006 Ford Five Hundred

Not finding what you are looking for?
2006 Ford Five Hundred Logo

483 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...