Question about 1995 Geo Tracker
what key? ignition key,is not working
does the key fail in all doors too?
if you lost them all.
any key show (lock smiths, real) can cut you a new key
and if you (secrets) the right door planal, front right. the code
sticker is next to the door key lock inside
with this number the smith can cut a key for like $25 knowing the code. 4x that the hard way.(hacking)
im sure you dont want to change all 6 locks in a 4 door. (no doors count stated)
but if only the igntion fails., it too can be fixed.
we take it out, and to a key shop (real) and get the cylinder matched to a new key. (code unknown at get go) (just did a 91, that way)
Posted on Apr 18, 2015
Can replace ignition switch w/used unit for around $100
Posted on Apr 16, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.
Posted on Mar 09, 2009
I had the very same problem with my 94 tracker and it turned out to be something simple. My check engine light had popped on after it had hit 100,000. I went through all of the suggestions that people had suggested (unplug battery......etc) and still to no avail. Searching the internet, I came across a website called suzukiforum.com and there, this guy was able to help me with my problem. It turned out to be a maintenance switch that kicks on every 50,000 miles. This switch is like a secret that the auto manufactures use to ploy owners of their cars to bring to the dealer and then rack up the dollars in unnecessary "repairs". The switch is located under the dash and can be hidden anywhere. From the assistance of the guy on the forum, he was able to send me photos of this damn switch and possible locations where it may be mounted. I found mine in about 5 minutes, where it was attached to the steering column. It's a tiny switch, that you slide up or down, depending on what position it is in upon finding it. If it's up, then slide it in the down position and visa versa. Once you do this, the check engine light will go off. Make sure you do not have the car running and you can even unhook one of the battery posts, just to make sure you don't hit anything while rooting around under the dash. Good luck!
Posted on Apr 30, 2009
If your lucky the code may have been written down in the manuel book. If it's not written down in the book or it's missing, drive to the chevy dealer that sells Geo trackers and the Service adviser can help you unlock the stereo by getting the information from the Vin number.
Good luck and hope this help. http://www.delcolockcodes.com/
Posted on May 23, 2009
first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.
Posted on May 05, 2010
Tips for a great answer:
Oct 20, 2016 | 1995 Geo Tracker
Aug 14, 2014 | 1995 Geo Tracker
Jun 29, 2013 | 1995 Geo Tracker
Mar 11, 2011 | 1995 Geo Tracker
Jan 19, 2010 | 1995 Geo Tracker
May 18, 2009 | 1995 Geo Tracker
Jan 22, 2009 | 1995 Geo Tracker
123 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: