Question about 1998 Honda Accord

1 Answer

Is there any way to bypass the emmobilliser complety from my 98 honda accord lx

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

There is not as its built into the computer that runs you engine. called the ecm

Posted on May 03, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: Honda Removal of factory radio 1991 Accord lx

start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps

Posted on Jan 17, 2009

Online-Tech
  • 51 Answers

SOURCE: where is the valet switch for honda accord 2002 lx?

Hi,
Does the vehicle have an aftermarket alarm system? Is the valet switch for this what you are looking for? If so, it depends entirely on who installed it as where they have put it, although it's usually under the dash on the driver’s side. Some alarms have different sequences that you have to go through to put the alarm into valet mode; it's not usually just a switch that you flick. Best to pop into an alarm or stereo installer and see if they can spot it for you, or if the car is immobilized, find out what sort of alarm it is and call an installer for the info on the valet procedure.

Thank You for contacting Fixya.com

Posted on Aug 03, 2009

Sean80000
  • 1867 Answers

SOURCE: 1994 hoda accord lx brakes

Please refer to the link below.

http://corp.advanceautoparts.com/english/youcan/asp/ccr/ccr20011001bb.asp

Posted on Dec 01, 2009

philschneide
  • 448 Answers

SOURCE: how to remove starter from 1998 honda accord

Detach the cable from the negative terminal of the battery. Caution: If you have an anti-theft radio, make sure you have the activation code before disconnecting the battery.

Remove the battery and battery tray from the engine compartment (remove the battery first, then remove the bolts for the battery tray and remove it.).

Remove the lower radiator hose and the wiring harness from the starter bracket. Make sure they are positioned out of the way.

Clearly label, then disconnect the wires from the terminals on the starter motor solenoid (the smaller cylinder attached to the starter). Disconnect any clips securing the wiring to the starter.

Remove the mounting bolts (two) and detach the starter (pull it gently out of its housing).

Reverse this procedure for installation.

Hope this is of help to you.

Posted on Dec 26, 2009

  • 819 Answers

SOURCE: how to remove starter solenoid from 1998 honda accord LX 4cyl?

the starter solenoid is integral to the starter.

Posted on Dec 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW DO I BYPASS ANTI THEFT ON A 98 HONDA ACCORD EX , NO RADIO, NEW IGNITION


Sorry no easy solution to this. and we can't give out that info anyway.

May 01, 2014 | 1998 Honda Accord

1 Answer

Cant see my miles on me honda 98 accord lx


it is broken, and you should fix it or replace a new one.
skt-100 super key tool 2.1

Aug 24, 2012 | 1997 Honda Accord

1 Answer

Were is the crank position sensor located on a 98 accord lx 2.2 motor?


There is no 2.2L motor in a 1998 Honda Accord.
The Crankshaft Position Sensor for the 2.3L 4-Cyl. engine is located behind the crankshaft pulley on the oil pump assembly.

May 10, 2011 | 1998 Honda Accord

1 Answer

98 accord dashboard lights flickering


in case anybody else has an issue like this, check the ignition switch. common problem in these cars.

Feb 23, 2010 | 1998 Honda Accord

1 Answer

1998 Honda Accord Lx 4 door. Power door locks work intermittently


i had the same problem on my accord 98 coupe 98.
and one day they stop working. i changed the engines of the locks and now the doors are working gr8!
hope it helps

cheers

Dec 30, 2009 | 1998 Honda Accord

1 Answer

1987 HONDA ACCORD LX WATER LEAK


Yes, there is a "bypass outlet" coolant hose that connects from the water pump inlet pipe (metal pipe that runs from back of water pump along engine block to lower radiator hose) to the intake manifold.

I am not sure about the "black box" - not enough detail.

Jul 14, 2009 | 1987 Honda Accord

2 Answers

Honda Accord Outside handle broken and Child lock is on.


Remove the panel and disable the child lock or some cars have an option to just bypass the child lock either or

Jun 07, 2009 | 1999 Honda Accord

1 Answer

Need to know the right tension setting of the accel. cable of a 98 accord lx vtech cant seem to set it right im burning to much fuel and car is running crappy


Honda does not apply a specification for this.

Tight enough so there is no slack, but not so tight as the throttle is held open.

May 25, 2009 | 1998 Honda Accord

1 Answer

Flashing key sensor on and suddenly car turns off


make sure you are not using the valet key. if still goes on take the key to a honda dealer and let them reprogramme the key,. most dealers do it for free.

Feb 17, 2009 | 1998 Honda Accord

Not finding what you are looking for?
1998 Honda Accord Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...