Question about 2007 Subaru Forester 2.5

Open Question

Neither key fob will lock doors, the fobs will unlock them however. Changed batteries no help.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

co7196
  • 3433 Answers

SOURCE: Locks on 2004 Legacy Outback

Not far fetched. The frequencies may bleed like a radio channel does when its not right on. Your two frequencies may be so close or one much stronger(other car) You should have it check before someone else notices it. Good luck

Posted on May 25, 2009

  • 119 Answers

SOURCE: key fob keep on failing to work

sounds like you have a aftermarket system installed,this is most likely interfaced with the subaru keyless,this system needs to be removed to diagnose,i believe the aftermarket system is causing the concern,i've seen many problems arise with these components

Posted on Jul 30, 2009

wiringlunati
  • 576 Answers

SOURCE: I have a 1999 Subaru Impreza- Remote locking

First, it may seem obvious, but check the fuses associated with the remote unlock. Next, go to Autozone or somewhere like that where they have a remote tester. That will tell if the remote is functional. If the remote works and the fuses are good, see if you can find out how to program remotes to it. It may have forgotten the code for that remote.

Posted on Dec 03, 2009

Testimonial: "Thanks for the tips, i'll do some investigation.. I'm amazed at the quick reponse! "

SOURCE: subaru 2005 legacy outback wagon driver's side

Check for a blown fuse for the lock system.

Posted on Mar 22, 2010

countrybo331
  • 79 Answers

SOURCE: Electrical-check engine light blinking & door lock, lock/unlocks

first unhook the battery for 15seconds and hook it up......if that dnt work jus say somthing i pretty sure i can help u figure this out

Posted on Mar 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Doors Wont Lock for Key Fob


Either the battery is dead in the FOB or the FOB is defective or the receiver for the FOB signal is defective.

May 20, 2016 | Toyota RAV4 Cars & Trucks

1 Answer

2007 sonata driver door won't unlock with key fob


door reciever or lock has issues
did you scan the car first.
does the receiver put 12dc to the unlock solenoid.
if yes the solenoid is bad.
if not the receiver has issues. (check connections first there)

Jul 15, 2015 | 2007 Hyundai Sonata Limited Sedan

1 Answer

When I press my central locking on my key fob for my Land Rover Freelander 2003 TD4 Diesel , only the rear door can be opened, when I press to lock ALL doors they lock and when I try to unlock them with...


Procedure for 2002 Land Rover models:
1. With the doors shut and from inside the vehicle.
2. Turn ignition to position 1 and back to off within 5 seconds
3. Remove key from ignition and press and hold the unlock button (has
an arrow on it) for 15 seconds during this time press the key lock button
(has Land Rover logo)3 times within 5 seconds
4. Release both buttons
5. Doors will lock and unlock to show correct programming has occurred hope this helps

Jan 05, 2015 | Cars & Trucks

1 Answer

Ive got a 2000 st24 and having problems with my key fob and alarm, key fob now not working changed batteries no difference, alarm goes off all the time, sometimes u can play a tune with the alarm ie...


I would look into getting a new key fob and having it programmed to the vehicle. If not tben use the key and lock unlock the door to deactivate the security

Nov 08, 2014 | Cars & Trucks

1 Answer

I cannot lock or unlock my car with my key fob


Test the battery inside key fob, should be at 3 volts, if is less than 3 volts replace the battery. If that does not work you may need to replace the key fob, on this vehicle you can program the key fob through the radio, the car manual shows you how to do this.

Before replacing the old key fob you can try to resinc the fob to the car by pressing the lock and unlock buttons at the same time for about 15 sec, if the door locks cycle the the fob will work again.

Mar 02, 2013 | 2004 Chevrolet Impala

1 Answer

I changed my battery in my 2005 cadillac sts, and now it is showing that the starter is locked. fob locks and unlocks the car, but i can't get car to start. what do i do?


you can try this, with the battery connected lock the car using the key fob, make sure no keys are in the ignition. Disconnect the battery again and let it sit for 30 min or so, reconnect the battery and using the key fob unlock the car, it should start, if not repeat the procedure and insert the key into the door lock to unlock the car, both of these solutions should reset the security system. Good luck.

Sep 09, 2012 | 2005 Cadillac STS

1 Answer

My key fob for my 2006 LaCrosse unlocks the doors & opens the trunk, but doesn't lock the doors. Can it be cleaned, or does it need to be replaced?


It is not clear whether the problem is with the fob or the receiver in the car. You could try replacing the fob (they are available online from various sites) but the receiver will need to be programmed to use it, and that usually requires a trip to a dealership (unless you have access to the OEM service manual). Your best bet is to take it to a dealership and have them diagnose and repair the problem.

Jul 05, 2017 | Cars & Trucks

1 Answer

Need to reset the key fob after replacing the battery


You should not have to reset the key fob after a battery replacement. The signal from the key fob stays the same and is programed to the reciever.
If the key fob needs to be reprogrammed then follow these steps.
1. Have all key fobs with you during programming.
2. Sit in the vehicle with all doors closed.
3. Lock all doors using the Lock/Unlock switch on the door.
4. Insert and withdraw the ignition key 7 to 9 times within 10 seconds (do not turn the key, just insert and withdraw).
5. The 4 way flasher indicator on the dash should flash once or twice.
6. Insert the ignition key and turn it on (key on, engine off).
7. Press any button on one remote and the 4 way flasher indicator on the dash should flash once.
8. If you have more key fobs to program use the Lock/Unlock button on the door to unlock the doors and then lock the doors.
9. Press any button on the next key fob and the 4 way flasher indicator on the dash should flash once.
10. Repeat if you have more key fobs. Only 5 can be programmed.
11. To exit, simply turn of the igniton and remove the ignition key.
12. Unlock the doors using the Lock/Unlock switch on the door and exit the vehicle.
13. Make sure the window is down when testing remotes in case you leave the keys inside.
14. Close all doors and test all remotes that were programmed.

Do not skip any steps or the process will not work.

If the 4 way flasher indicator does not work when inserting the key, you will need to start the process from the begining. If it still does not work the receiver may be your problem.

If the 4 way flasher indicator does not flash when pressing any button on the key fob then the key fob is the problem (dead battery or defective remote)

Dec 18, 2009 | 2002 Nissan Xterra

Not finding what you are looking for?
2007 Subaru Forester 2.5 Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7727 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...