Question about Cars & Trucks

1 Answer

Car won't start. No power to fuel pump or heat fan

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 11,753 Answers

What Make vehicle do you have ? You need to find a wiring diagram an find where it's power starts or comes from ! Have you checked relays an fuse's ?

Posted on Apr 14, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 1995 e34 520i won`t start

may need to change spark plugs or make sure that you have the correct plugs(spark)

Posted on Sep 10, 2008

lastech
  • 408 Answers

SOURCE: STALLING PROBLEM TURNED INTO NO START 1990 MB 300 SL

hello,good day,first we are in fuel side,better to install a fuel gauge,to determine the right pressure, is not mention your fuel pump relay,this should also check,some occasion the power supply is missing,now if all is in order (fuel side) then your switching unit(transistor box) need tobe check,assuming your engine is 103 engine,ty

Posted on May 19, 2009

  • 225 Answers

SOURCE: won,t start

sounds like it may be and ignition relay falling out. i think there is 3 of them under the hood. have to ask is there fuel pressure, spark. i know you changed them but why.

Posted on Aug 13, 2009

  • 4 Answers

SOURCE: no power to fuel pump car was running fine just

Check for 12 volts power at the fuel pump harness. If no power is going to the pump, check the fuel pump relay. Also, check the fuel pump inertia switch. Ford usually has it on either inside left or right rear trunk fenders.

Posted on Apr 09, 2010

  • 5370 Answers

SOURCE: Car will turn over but won't start. Through the

No noise from fuel pump when you turn over the car .First thing get voltage at fuel pump relay checked, is there 12 volt to the relay.If no, then problem is again the relay.--------- To reconfirm the problem, try other test, that is remove the relay and by pass the relay terminals with a jumper wire .Then with 12 volt external battery give power to fuel pump connector and see, if the fuel pump starts, then its clear that fuel pump relay is faulty.----------- Also other problem can be fuel pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution
box, in the engine compartment, driver's side near the firewall.----------
The fuel pump inertia switch is in the right front passenger area
it is below the dash but above the carpet in the right hand corner.--------
Its a push button type inertia switch.
--------
Fuel Pump Activation
When ignition switch is turned to START position, PCM operates fuel pump relay to provide fuel for starting engine. PCM senses engine speed and shuts off fuel pump by opening ground circuit to fuel pump relay when engine stops or engine speed drops to less than 120 RPM. When ignition switch is in ON position, EEC power relay is energized (contacts closed). Power is provided to fuel pump relay and timer in PCM. Fuel pump receives power through fuel pump relay contacts.
Inertia Fuel Shutoff (IFS) Switch
All models use an electrical interrupt switch in fuel system. During a collision or vehicle rollover, electrical contacts within inertia switch open, shutting off fuel supply to electric fuel pump. Fuel supply is interrupted even when engine is running.
A reset button is located on switch assembly. If electrical circuit trips, vehicle will not restart until switch is reset. Fuel system should be inspected before resetting switch.
IFS switch is located under instrument panel, near right side of transmission hump.
----------- If the fuel pump relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is faulty and has to be replaced.--------- This will help.Thanks.Helpmech.

Posted on Jul 17, 2011

Testimonial: "Thanks. That was the best answer yet.I didn't want to hear that the PCM might need to be replaced but the car has served it's purpose through the year"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Engine over heats


ck your water pump, sounds like no water movement,

Aug 18, 2012 | 1997 Nissan Sentra

2 Answers

I changed the oil in my 98 concorde and now it wont start. The oil light is on but not the check engine light.\


do you here the fuel pump working when you turn the key?If not could be a fuse that runs the fuel pump.

Aug 05, 2012 | 1998 Chrysler Concorde

1 Answer

Need to know why a 97 mercury cougar won't start until cooling fan and fuel pump stop running


I would think it's a problem with (CCRM) constant control relay module . This module has relay's inside that control the fuel pump , cooling fans , A/C compressor clutch , PCM - engine computer power relay . And thier are electronics involved , solid state circuity . Google CCRM
found this helpful answer from mercury mechanic on JustAnswer com

May 07, 2017 | 1997 Mercury Cougar XR7

1 Answer

1999 300M sometimes it won"t


Your problem may be one of the following:
First check or just replace the fuel filter. Usually located under the car in front of the rear axle, drivers side.
Next, the fuel pump may be worn out. Usually they just stop working (running).
Next, check the fuel pressure regulator. Usually located on the front fuel rail, drivers side.
Is the vacuum line attached? Not leaking or rotted?
Also, do you smell a strong fuel odor when it won't start? May be one or more stuck-open injectors, or the coil pack is bad.
Checking these in the order listed will more than likely fix your problem.
The clicking noise indicates the battery can no longer run the starter, which also means the fuel pump won't run either.

It could be a fuel issue. How old is the fuel filter? Can you hear the pump run for a few seconds when you turn the key on? Try turning the key to ON without trying to start engine three times waiting for the pump to stop running each time. Then try to start the engine. If it starts, Its a form of Vapor lock caused by the extreme heat we have had lately, and a weak fuel pump.

If none of this works, try a new fuel filter first. From there have someone check the fuel pressure regulator and then the pump. If you are in need of a new pump, take my word for it and spend the money to get one from a Dealer, and not from your favorite parts store. Most parts store parts are made in China and they are JUNK.

Aug 27, 2011 | 1999 Chrysler 300M

1 Answer

Won't start after short trip like its vaper locked


STARTING / IDLING PROBLEMS / MISSING

Your problem may be one of the following:
First check or just replace the fuel filter. Usually located under the car in front of the rear axle, drivers side.
Next, the fuel pump may be worn out. Usually they just stop working (running).
Next, check the fuel pressure regulator. Usually located on the front fuel rail, drivers side.
Is the vacuum line attached? Not leaking or rotted?
Also, do you smell a strong fuel odor when it won't start? May be one or more stuck-open injectors, or the coil pack is bad.
Checking these in the order listed will more than likely fix your problem.
The clicking noise indicates the battery can no longer run the starter, which also means the fuel pump won't run either.

It could be a fuel issue. How old is the fuel filter? Can you hear the pump run for a few seconds when you turn the key on? Try turning the key to ON without trying to start engine three times waiting for the pump to stop running each time. Then try to start the engine. If it starts, Its a form of Vapor lock caused by the extreme heat we have had lately.

If none of this works, try a new fuel filter first. From there have someone check the fuel pressure regulator and then the pump. If you are in need of a new pump, take my word for it and spend the money to get one from FORD, and not from your favorite parts store. Most parts store parts are made in China and they are JUNK.

Have you hooked a scanner to the computer and checked the oxygen sensor(s)? If they are bad they could lean out the engine.

VAPOR LOCK
Check the following:
Cooling system working properly including fans.
Under hood fuel lines touching coolant or heater hoses.
Fuel lines under vehicle close to or not shielded from exhaust pipe, converter, muffler. Fuel lines pinched or crushed.
Fuel filter changed recently.
Fuel pump pressure.
Cheap(Bad) gas.

Aug 26, 2011 | 2003 Ford Taurus

1 Answer

Car has been sitting; will turn over but won't start. Used starting fluid and car starts but quits. Won't fire without starting fluid. There is fuel in the tank. Help!!


My first thought is to check the fuel pump operation.
Check to see if fuel pump is getting power.

This is how I check the pump.

Usually there is an in-line fuel filter that can be removed.
While its removed...bump the starter to see if gas shoots out the gas line.
If not, there might be a clog at the pump...or the pump needs replacing.

Hope this helps...

Jul 24, 2011 | 1989 Oldsmobile Delta 88

1 Answer

STALLING PROBLEM TURNED INTO NO START 1990 MB 300 SL


hello,good day,first we are in fuel side,better to install a fuel gauge,to determine the right pressure, is not mention your fuel pump relay,this should also check,some occasion the power supply is missing,now if all is in order (fuel side) then your switching unit(transistor box) need tobe check,assuming your engine is 103 engine,ty

May 17, 2009 | 1987 Mercedes-Benz Mercedes Benz 190 Class

2 Answers

97 gtp turns over wont start..fuel pump runs enermidintly


yep i seen it in happen .i was at a gas station a guy drove car to the gas station on empty.he fill his tank up .could not get it to crank .some cars you have to restart fuel pump when run out of gas. like chrysler.you use a scanner. but chervrolet you run low over heat damage the pump.it has to stay submerge gas to keep it cool. check fuel pump pressure.it should be 41 - 47 psi.

May 05, 2009 | 1997 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...