Question about 1990 Acura Legend

Open Question

1990 acura legend my taillights and dash borad stopped working and every time i turn on my headlights the fuse from my cooling fan pops how do i fix this?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 188 Answers

SOURCE: 98 jeep tj, dash light/taillights/licence plate light don't work

disconnect head lights, and replace fuse. Then turn the light back on to see if it blow a fuse again. if not, plug on light in at a time. You might have a bad headlight???? then unplug that one if nothing happens. Then plug the other one in. It could also be a bad taillight bulb. I have had bad tail light bulbs. Do all of them, one at a time.

Posted on Feb 14, 2009

  • 1 Answer

SOURCE: engine cooling fans not working

if relays are good its most likely the engine coolant temp switch

Posted on Mar 24, 2009

SOURCE: cooling fan fuse

most likely the cooling fan has a short in it. disconnect the connector on the fan. If it doesn't blow now its the fan motor. If it still blows you have a short from the fuse to the motor. What this means is the hot wire is touching bare metal somewhere

Posted on Jul 17, 2009

  • 74 Answers

SOURCE: My headlights on my mazda Astina 323 1990 wont pop up

check fuses

Posted on Oct 08, 2009

  • 347 Answers

SOURCE: 1990 Camry Fuse Diagram. The following suddenly

REPLACE BUSTED FUSES

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The a/c in my acura legend 1995 stopped working while it was running. The button still works because when I turn on the a/c button, I hear a click right under the blower fan but the blower will not c


Check the power going to the motor to see if it's good. If it's ok, you can try tapping on the motor with handle of a screw driver or something similar, it might kick on. If there is no power, check the fuse. Otherwise there might be a switch or module problem.

Dec 12, 2012 | Acura Cars & Trucks

2 Answers

My 1994 acura legend ac only works if i turn it on full blast


High speed only is caused bu a defective blower motor speed control solid state resistor. The resistor is located in the air ducting (for cooling) next to the blower motor under the dash on the passenger side of the car. Remove the lower dash panel to access the part. See picture below of resistor.
Cost for part is about $200.00
7_12_2012_7_34_53_pm.jpg

Jul 12, 2012 | 1994 Acura Legend

2 Answers

Fuse diagram for 1990 acura lengend ls the label is gone


try asking at the dealer or buy a haynes manual ,yes i know the haynes manuals are not very good but they should have a fuse wiring diagram .

Oct 29, 2011 | 1990 Acura Legend

1 Answer

Were do you find the that controle the cooling fan for the 1990 acura legend


in the radiator ,look for a copper coloured switch with two wires on it

Oct 04, 2010 | 1990 Acura Legend

4 Answers

1990 Acura Legend, location of main relay for fuel pump


looked it up online, looks like its in the underhood fuse box but couldn't get a good diagram that shows which relay number it is. the website i use is sort of dependent on the manufacturer, apparently acura did not feel like sharing that info. hope that helps

Jun 17, 2009 | 1993 Acura Legend

1 Answer

1990 acura legend body kit


a 91-95 bodykit will not work unfortunatey.but you can purchase one for older legends. Try Hondatuner magazines website

Apr 14, 2009 | 1990 Acura Legend

1 Answer

My taillights and gauge cluster fuse keeps blowing


bad head light switch or wire shorting to ground.

Mar 22, 2009 | 1990 Acura Legend

1 Answer

Only the high-beam lights come on and i have no taillights.fuses are good on 1989 acura legend


 john.  hi   I have a acura legend 89 . the problem is that when i turn the lights on the back lights wont turn on but  if i turn the switch back one turn they turn on ,   i did check the fuses and they are ok can any one help me???

Aug 19, 2008 | 1995 Acura Legend

Not finding what you are looking for?
1990 Acura Legend Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...