Question about 2004 Audi A4

Open Question

How do you pair nokia 925 to 2004 model audi a4 convertible

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: audi a4 camb timming

Hi,

Audis are not very common in mycountry but from what I can gather:

Themark for the crankshaft gear is on the cover you have to remove inorder to get at the timing belt. The sprocket you may be having troublewith is the intermediate shaft (in front of the water pump) and I don'tbelieve that one matters at all since it doesn't drive any of the cams.The intake cams are driven by a chain off of the exhaust cam shaft soonly the exhaust cam is driven directly by the timing belt.

Additionally, you may benefit from the Audi A4 Service Manual and/or Audi A4 Cabriolet Workshop Manual.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Posted on Aug 30, 2008

Ad
emissionwiz
  • 76164 Answers

SOURCE: Petrol gauge faulty on audi a4 2001

Most likely the sending unit for the guage is defective, it is located in the fuel tank.

Posted on Nov 05, 2008

chain saw
  • 94 Answers

SOURCE: electrical fault Audi A4 2002

PRISE OUT THE TRIM PANEL AT THE BASE OF THE ARMREST WITH A FLAT-BLADED TOOL UNDO 2 SCREWS(DRIVERS DOOR) SINGLE SCREW ACCESSIBLE THOUGH THE ARMREST ON PASSENGER SIDE ,NOW GO TO THE BASE OF THE DOOR TRIM UNDO THE SCREW IN THE CENTRE,ONTO THE TOP TRIM NOW ABOVE THE RELEASE HANDLE,STARTING AT THE FRONT EDGE(DOOR HINGE SIDE) CAREFULLY PULL THE TRIM PANEL AWAY FROM THE DOOR TO RELEASE THE CLIPS,THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL,UNDO THE 4 SCREWS YOU CAN SEE,UNHOOK CABLE FROM REAR OF INTERIOR DOOR HANDLE,DISCONNECT WIRING PLUGS SPEAKER ,WINDOW MOTOR CONTROL UNIT AND THERE YOU HAVE IT ..EASY... IF YOU START NOW YOU WILL HAVE IT FINISHED IN 2 DAYS...ONLY JOKING....SHOULD TAKE 1 HOUR..HOPE THIS WILL BE OF SOME HELP TO YOU...LET ME KNOW HOW YOU GOT ON

Posted on Feb 10, 2009

  • 47 Answers

SOURCE: audi a4 2.8 1995 model

  1. Remove the hubcap or center cap.
  2. Loosen but do not remove the hex collar bolt.
  3. Loosen but do not remove the wheel lug bolts.
  4. Raise and safely support the vehicle.
  5. Loosen all, and remove all but one of the CV joint to stub axle bolts retaining the halfshaft to the transaxle flange. If necessary have an assistant hold the tire, or remove the tire, install two of the lug bolts and have an assistant hold a suitable and sturdy 3 foot (1 meter) prytool between the lug bolts to prevent the axle from spinning.
  6. If not previously removed, remove the front wheels.
  7. Remove the remaining CV joint to stub axle bolt and remove the halfshaft from the transaxle drive flange and support it out of the way. Do NOT let it hang unsupported.
  8. Remove the outer axle hex collar bolt and press the halfshaft out of the hub. A suitable press tool may be necessary, otherwise drive the axle out using a suitable drift.
  9. Remove the ABS wheel speed sensor cable from the brake caliper bracket.
  10. Slide the ABS speed sensor partly out of its mount.
  11. Remove upper control arm pinch bolt and nut, then remove both arms up and out of the steering knuckle.


WARNING The slots in the steering knuckle must not be widened. Do NOT loosen any other steering knuckle fasteners, otherwise the axle geometry must be checked.
  1. Tilt the steering knuckle out and to the rear of the vehicle, then remove the halfshaft. If necessary, use a press tool to remove the axle from the hub.



0900c152800c2fa3.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. A threaded plastic guide dowel is included in the vehicle's tool kit. Thread it into place to guide the wheel on the ground
Fig. Apply a light coating of an anti-seizing compound to the lug bolts


Fig. The screwdriver handle supplied in the vehicle's tool kit is used to start the lug bolts
Fig. Always loosen or tighten the axle nut or bolt with the vehicle on the ground
  1. Install the halfshaft into the wheel hub.
  2. Install the upper control arms into the steering knuckle and tighten to:
  3. Upper steering knuckle pinch bolt: 30 ft. lbs. (40 Nm).
  4. Install the wheel and hold it to keep the axle from turning. If necessary have an assistant hold the tire, or with the wheel removed, install two of the lug bolts and have an assistant hold a suitable and sturdy 3 foot (1 meter) prytool between the lug bolts to prevent the axle from spinning.
  5. Attach the inner halfshaft-to-transaxle flange and tighten to:

Inner CV joint-to-transaxle flange:


M8 fasteners: 30 ft. lbs. (40 Nm) M10 fasteners: 59 ft. lbs. (80 Nm)
  1. install the ABS wheel speed sensor, and the sensor cable into the caliper bracket.
  2. If not previously installed, install the wheel without the wheel trim and do not fully tighten the lug bolts.
  3. With the wheels installed and the vehicle on the ground, tighten the lug bolts in a crisscross pattern and then the axle bolt as follows:
  4. Wheel lug bolts: 89 ft. lbs. (120 Nm)

Posted on Jul 09, 2009

  • 1 Answer

SOURCE: rear speakers audi a4

how to connect a universal bose speaker to an audi a4 1996 rear

Posted on Sep 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi a4 water leak drivers footwell


hi all have an audi a4 convertible 06 plate just cleaned it only to find wet carpet drivers side bulled back carpet and found about an inch of water heeelllppp

Jun 15, 2012 | 2007 Audi A4 Convertible

1 Answer

I am interested in replacing my catalytic converters on my Audi A4 1996. I have seen a couple of CC's on the internet and wondered why they are so different in price.


There are many different manufacturers for audi, also make sure you are looking at the correct ones for your engine, either a 2.8 or 1.8T. That is another big difference for the turbo model it comes right off of the turbo.

Mar 28, 2011 | 1996 Audi A4

1 Answer

I replaced the stock catalytic converter on my 2004 Audi A4 1.8T about 3000 miles ago with a direct fit model from MagnaFlow because my mechanic said the original unit had failed and I didn't want to spend...


The mechanic is yanking your chain and the following links will explain why cats fail http://www.ebay.co.uk/gds/Reasons-for-catalytic-converter-failure-/10000000002803746/g.html
Audi A4 catalytic converter CHECK FOR PROBLEMS your mechanic can replace cats every couple of weeks or months depending on your driving style or he can repair the faults causing the cats to fail

May 13, 2017 | 2004 Audi A4

1 Answer

2001 audi a4, loosing power


HAVE YOUR CATALYTIC CONVERTER CHECKED .IT COULD BE PLUGGED

Apr 30, 2010 | 2001 Audi A4

1 Answer

Convertible top has to be put down/up manually.


Just took my 2004 A4 convertible (25,000 miles) to the dealer...needed new module...cost $375 for part and $300 for labor. Maybe this should be a recall item.

Apr 05, 2010 | 2007 Audi A4 Convertible

2 Answers

With my bluetooth phone in my car when someone rings me a mute sign comes on and i cant hear the person talking through my radio? and when i end the call it goes away? what have i pressed?


check on your phone settings that the privacy mode is off. if it is then unpair the device and re-pair the device the pairing code is usually 1234

Mar 13, 2010 | 2007 Audi A4 Convertible

1 Answer

I need an owners manual for my 2007 audi a4


its very simple,
go to a Audi showroom.
show them your car papers.
ask them for a manual.
if they don't give it to you.....
use this link

http://www.pdfgeni.com/book/audi-a4-owners-manual-pdf.html


Jan 13, 2010 | 2007 Audi A4 Convertible

2 Answers

1997 Audi A4 Transmission problem


front clutch needs renewing

Jan 10, 2009 | 2006 Audi A4

Not finding what you are looking for?
2004 Audi A4 Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...