Question about 2001 Dodge Grand Caravan

1 Answer

I need a diagram showing a fuel filler neck and the emissions hoses and parts attached to it, from a 2001 Dodge Grand Caravan

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 10,875 Answers
Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Is a 2000 Dodge Grand Caravan fuel filler neck usable in a 1999?

yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse

Posted on Jun 25, 2009

flsts
  • 10 Answers

SOURCE: need to replace fuel filler neck on 1999 dodge dakota

I just replaced one today. I found this post looking for an answer myself and ended up just going for it. The metal at the end of the plastic hose is a clamp that was compressed with a special tool. Here is what I did.

I cut the compression clamp open with a Dremel and a cut off wheel. Be careful not to cut through to the plastic. I did a little at a time the whole length of the clamp and cut through only at the end about 3mm. I then put a screwdriver in there any was able to pry it up and break the clamp in half since I had cut most of the way through it. Take your time.

With the clamp off it will still be hard to get the metal tubes out. I had badly rusted tubes so I broke them off near the plastic tube and bent the end inside the plastic a little with a hammer. I was then able to pull the vent tube out. On the fill tube I bent it to move it away from the plastic enough to get tin snips in there. I cut it and could then get the tube out.

It looked like there was some kind of rubber ring on the tubes. I used some sealer on the tube when I slid it in the plastic and used regular hose clamps. Make them very tight. You don't want an air leak.

Posted on Jan 23, 2010

  • 14036 Answers

SOURCE: How to remove the fuel

OPEN GAS CAP FLAP THEN YOU NEED TO DRAIN GAS BELOW FILLER NECK.THEN LOOSEN REMOVE SCREWS IN THE GAS CAP FLAP AREA WHERE FILLER TUBE CONNECTS THEN GO UNDERNEATH VAN LOOSEN REMOVE HOSE CLAMPS AND REMOVE THE HOSE AT THE FILLER NECK BELOW THE GAS TANK.SPRAY WD40 AROUND HOSE AREA AT METAL FILLER TUBE STICK OUT GAS TANK.CAREFULLY USE LARGE PAIR OF CHANNEL LOCK PLIERS TO REMOVE WORK HOSE OFF METAL TUBE FROM GAS TANK. IF YOU CANT REMOVE HOSE WITH HANDS.BECAREFUL NOT TO MAKE ANY SPARKS.PLACE RAGS AROUND ANY METAL PARTS TO KEEP CHANNEL LOCKS FROM HITTING METAL MAKING SPARKS.

Posted on Jun 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge grand caravan 2005 filler neck replacement


1)Block front wheels.
2)Jack up the left rear tire off of the ground.
3)Put blocks up under the frame.
4)Take off the left rear tire.
5)Take out the plastic liner in the fender well that covers the fuel filler neck.
6)Loosen up the hose clamps on the rubber fuel filler hoses. (at the neck side); once the clamps are off plan on buying new ones. This next part of the job is VERY IMPORTANT! use a flat screwdriver and pry 360 degrees all around the rubber filler neck hoses. (they get kinda glued on from being on there so long). Next Get some PB Blaster lube or WD-40 (it has to have the small red squirt hose) and spray the lube up in between the hoses while you pry around. the more you do this the easyer it will be to pull the metal filler neck pipe out.
7)Now its time to take out the 4 bolts that hold the pipe on.
Use a 10mm socket and extension to take out 4 bolts up top behind the fuel filler door.
8)Pull the filler neck out and put everything back together the way it came apart and your done!

Aug 26, 2016 | 2005 Dodge Grand Caravan

1 Answer

OEM # p0442


P0442 DODGE - Evaporative Emission Control Small Leak Detected
Possible causes- Missing or loose fuel cap
- Incorrect fuel filler cap used
- Fuel filler cap remains open or fails to close
- Foreign matter caught in fuel filler cap
- EVAP canister or fuel tank leaks
- EVAP system hose leaking

Oct 08, 2012 | 2002 Dodge Caravan

1 Answer

How to remove the fuel filler neck on my 1999 Dodge Grand Caravan 3.8 ltr. engine


OPEN GAS CAP FLAP THEN YOU NEED TO DRAIN GAS BELOW FILLER NECK.THEN LOOSEN REMOVE SCREWS IN THE GAS CAP FLAP AREA WHERE FILLER TUBE CONNECTS THEN GO UNDERNEATH VAN LOOSEN REMOVE HOSE CLAMPS AND REMOVE THE HOSE AT THE FILLER NECK BELOW THE GAS TANK.SPRAY WD40 AROUND HOSE AREA AT METAL FILLER TUBE STICK OUT GAS TANK.CAREFULLY USE LARGE PAIR OF CHANNEL LOCK PLIERS TO REMOVE WORK HOSE OFF METAL TUBE FROM GAS TANK. IF YOU CANT REMOVE HOSE WITH HANDS.BECAREFUL NOT TO MAKE ANY SPARKS.PLACE RAGS AROUND ANY METAL PARTS TO KEEP CHANNEL LOCKS FROM HITTING METAL MAKING SPARKS.

Jun 23, 2011 | 1999 Dodge Grand Caravan

1 Answer

Is a 2000 Dodge Grand Caravan fuel filler neck usable in a 1999?


yes it will swap and you have to remove it from the bottom of the van remove the screw/clips from inside the filler door and then from underneth disconect the filler tube ti tank and the vent hose to the tank i belive there is a bracket also holding the filler tube to the body with one bolt then it snakes out of the va r insalating is just reverse

Jun 25, 2009 | 1999 Dodge Grand Caravan

2 Answers

Code PO442 & PO455 on a 2003 Dodge Caravan with 3.3 engine


The problem is most likely to be with your vacuum line they put cheap rubber hose for this purpose. You should find a diagram at the front of the vehicle trace the hoses by this diagram. You most likely will find a bad piece of hose.

Mar 14, 2009 | 2003 Dodge Caravan

5 Answers

2001 Dodge Caravan/check engine light


P0442--Evap Emission Sys. leak detected small leak
P0455--Evap Emission sys. leak detected gross leak
P0456--Evap Emission Sys. leak detected very small leak

Jun 07, 2008 | 2001 Dodge Caravan

2 Answers

Fuel in my van


Im having a similar issue except sometimes i can fuel up and sometimes i cant. Have you tried fueling up again with out issue

Jun 04, 2008 | 2005 Dodge Grand Caravan

Not finding what you are looking for?
2001 Dodge Grand Caravan Logo

Related Topics:

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...