Question about Toyota Cars & Trucks
Check this site about the fuel injection settings of your Toyota:
22RE Toyota injector installation
This site has a useful diagram for that purpose:
22R 22RE 22RTE Vacuum Diagrams Pirate4x4 Com 4x4 and Off Road Forum
Posted on Apr 13, 2015
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The fuel pressure regulator is on the driver side fuel rail, close to the back of the engine. You need to pull the intake plenum off to access the pressure regulator.
The normal operating fuel pressure is 38 to 44 PSI
Thanks for choosing FixYa for assistance.
A "FixYa" rating (4 blue diamonds) would be greatly appreciated. Thnaks in advance, and please feel free to re-contact me if you need any further assistance. Thanks, again.
Posted on Feb 21, 2009
It's inside the gas tank. Took me about 20 minutes to drop the tank. 2 bolts that hold it up and undid 2 small bolts on the heat flange that seemed in the way. You should also take out the one small bolt on the driver side holding the brake cable up. You have to anyway to get the tank back in.
I got a pump online for $50. Pump only and it took about 10 minutes this morning to put it in the original bracket out of my fuel tank. So I say go with pump motor only and save big bucks.
TIP: For those of you who want to check if its your fuel pump or fuel relay. There are 2 easy places to do this. One is at the gas tank itself. Under the car they dropped the wiring harness down and put a connector in a bracket on the back of the gas tank. The second one is behind the rear seat back. Lift out the bottom seat pushing the 2 levers and then there are 2 bolts to take out to remove the rear seat back. Then you will see a connector on the passenger side up high. You can use either of these connectors to check if you got power when the key hits the start (engine cranking) position. If you do the relay is good. You can run power from a battery/charger to the fuel pump and see if it works.
Posted on Apr 12, 2009
The fuel pump for your truck is in the gas tank. They cost about $142 at Autozone. It's not that hard if you have a basic ability with tools and a little help to raise and lower the tank. Of course you'll need to drain the tank before you start.
Posted on Jul 28, 2009
Tips for a great answer:
Apr 13, 2015 | Toyota Pickup Cars & Trucks
Apr 29, 2011 | 1986 Toyota Pickup 4WD
Apr 26, 2011 | Toyota Pickup Cars & Trucks
Mar 16, 2010 | 1986 Toyota Pickup 4WD
Jul 28, 2009 | 1986 Toyota Pickup 4WD
May 27, 2009 | 1986 Toyota Pickup 4WD
Mar 02, 2009 | 1986 Toyota Pickup 4WD
Jan 27, 2009 | 1986 Toyota Pickup 4WD
320 people viewed this question
Usually answered in minutes!