Question about Jeep Liberty

1 Answer

Seem to have a electical trouble between ignition and starter.....dont know where to start help please....

When i turn the key all lights turn on but my jeep dosent start.....

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

3rd post. do we get 4?
read post 1 and a full answer, im not answering 3 times,
its there read it.

Posted on Apr 21, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 277 Answers

SOURCE: Turn ignition key but won't start..All power on, is it starter?

Can be a Junk Relay, access is limited, but giving the Starter a "crack" with a mallet, often cures the problem temporarily. But check the Battery terminals, and Cable to the Starter solenoid ,first for tightness and security.
Regards,DT

Posted on Aug 30, 2009

  • 6982 Answers

SOURCE: 2006 Jeep Wrangler won't start

First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.

Posted on Oct 02, 2009

Testimonial: "Will try! Thanks!"

  • 369 Answers

SOURCE: 2001 ford Taurus. Will not start. Turn key and

The problem would be the starter they go without any warning

Posted on Jan 10, 2010

Testimonial: "Terian5- Thanks for the help Traced the wire to starter. the wire looks like it snaps on. put it back and it started. I need to tighten nut."

  • 566 Answers

SOURCE: VW POLO 1.9CL Diesel 1997 wont start

hi from uk check the main lead from battery+positive to the starters solenoid is secure ? also there is a thin wire that also connects to solenoid on a terminal of its own this is the solenoid energizing wire that works starter when key start position is selected if all above is ok? then use a jump lead and connect one end to battery negative post then the other end of lead to a suitable earth point on engine ? then try starting? if it works/starts ? you have a bad earth connection to engine from battery negative lead check the earth lead connection at point on engine is clean/secure ? it usually is secured by bolt at point where engine and transmission connect ? hope this helps?

Posted on Apr 02, 2010

  • 553 Answers

SOURCE: 2000 jeep wrangler will not start from the key

It sounds like you have a bad neutral safety switch or your linkage is worn enough that it's not registering properly.

Posted on Jun 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Hi I have a 1999 pontiac sunfire im having trouble starting it when i turn the key the starter dosent seem to be engaging and the motor does not turn over ive bump started it and the car runs fine im just...


Hi there skate4life! The two thing that could be causing this is the starter or the ignition switch in the steering column. If you have a test light turn the ignition switch to the "on" position then test the hot wire on the starter. If it lights up the starter is bad. If it doesnt light up it means that the ignitions switch is bad and is not sending power to the starter. i hope that this sheds some light on your situation. Please leave positive feedback if this solution helps.

Have a good day!

Mar 30, 2011 | 1999 Pontiac Sunfire

2 Answers

The car will not start. All the lights come on, dash, interior and head lights. The car will not turn over. It does not even try to turn over. I looked at the battery terminals and they looked very clean....


COULD BE FAULTY STARTER SOLENOID OR STARTER. CHECK THEFT DETERRENT RELAY.SCAN WITH CODE SCANNER FOR THEFT SECURITY TROUBLE CODES.IF ALL IS GOOD.SHIFT TRANSMISSION IN NEUTRAL SEE IF IT WILL CRANK.FAULTY NEUTRAL SWITCH WILL CAUSE NO START PROBLEMS.

Feb 08, 2011 | 1998 Chevrolet Lumina

1 Answer

Key wont turn in ignition. I am getting


I would check the battery first before I started condemning any other systems. It is possible that it has enough of a charge to make the lights come on a little but not enough to turn the starter motor. The starter requires a much larger amount of electricity than the lights.

Dec 17, 2010 | 2001 Mercedes-Benz C-Class

1 Answer

I have 2003 model, 5-speed maual transmission. Had trouble starting engine a few times in last cople of days. Thought I didn't push clutch in all the way. Started after a couple of tries. Eventually...


If there is no "clicking noises" at all first you have to bypass the Clutch Start Switch. To do so remove two wires from the Start Switch and connect them together.
If it doesn't work trouble shoot starter and solenoid. With a wire connected to (+) terminal of the battery power up the solenoid, at the thin wire contact of the starter. You need another person to help you, in the cabin turning the ignition key in ON and start position. If starter and solenoid are O.K this will start your car. If not you have to replace the starter + solenoid assembly. Good Luck.
Sam from,
American Car Co.
862b0b2.gif

Oct 31, 2010 | 2003 Toyota Tacoma

1 Answer

2002 Tahoe engine will not start


Electrical problems are difficult to diagnose in person without testing ...however, it seems that you may be loosing the body ground, causing power loss to the clock and likely the computer as well. As the starter is able to turn the engine, likely there is no problem with engine grounding. While cranking, the accessory side of the ignition switch should remain "hot" otherwise you would loose the clock every time you started it up. If it's not a ground problem, I'd look at the ignition switch itself to make sure it's not dropping power to ignition system while starter is engaged. on some vehicles this can also happen at the starter relay if an ignition bypass is used to provide hotter starting spark.

Jun 28, 2009 | 2002 Jeep Liberty

4 Answers

Saab 900 will not turn over, starter motor has been replaced.help


is the trigger wire on starter (sm conn) energised when you turn key? should be close to 12v. could be bad ign switch if no power..

Apr 06, 2009 | 1996 Saab 900

1 Answer

Wont turn over at all lights and everything else works put new altenater on on it, starter seems fine just wont start security light started coming on a week or so ago dont have owners manual so dont know...


TRY THIS RESET FOR THE SECURITY SYSTEM.

PASS LOCK RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.

Mar 22, 2009 | 2002 Pontiac Grand Am

2 Answers

Starter gets power, all dash lights and fuel pump activate when key is turned to "on" but the starter wont turn the car over. no noise at all. i had what seemed like the same prolem on a sunfire. i had to...


Try tapping on the starter with a hammer while someone is turning the key to the start .Good luck,
CevRevposition.Make sure the car is in park with the emergency brake set & the wheels blocked for safety.If the starter workes after tapping on it,you have bad brushes & need a new starter

Mar 19, 2009 | 1997 Chevrolet Cavalier

1 Answer

1990 Buick Century WILL NOT start


if all lights work and everything on insterment panel lights up but won't click or anything when you turn key than i would chk. the ignition switch, it should be under dash on steering colume. there is a way to chk. this if you know what you are doing. i'll try to explane. need to turn ignition to on, then you have to cross the big post on starter to the small post on starter and it should start, if it starts than its ignition switch. now it will only start if you got regular lights lit up on dash, like you would usely have if it was to start with key. like i said don't atemp this unless you know what your doing. if by chance you have acsess to a remote starter switch that would be better and safer. then you could clamp the ends to the posts and have the starter button in your hand. hope this helps OLD SCHOOL.

Jan 20, 2009 | 1990 Buick Century

1 Answer

My 2001 saturn wont start when you turn the key, the lights come


THE STARTER ITSELF IS PROBABLY THE ERRATTIC TROUBLE MAKER.YOU NEED A TEST LIGHT ON THE STARTER CONTACT TO VERIFY YOUR GETTING IGNITION SIGNAL TO THE STARTER.CHECK WHEN ITS NOT STARTING IF YOU DIDNT REPLACE IT ALREADY.

Nov 22, 2008 | 2001 Saturn S-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...